5. In the figure shown below, the height of the water and oil are 15 and 8 m respectively. The container is open to the atmosphere (a) What is the gauge pressure and absolute pressure at the oil water interface? (b) What is the gauge pressure and absolute pressure at the bottom of the container? The density of the oil is 750kg/m^3 OIL WATER shutterstock.com 1172374471

Q: There are different types of pressures: atmospheric, barometric, gauge, absolute and vacuum…

A: There are different types of pressure 1) atmospheric pressure /barometric pressure - the pressure…

Q: The load on a 2-in.-diameter hydraulic cylinder increases from 10,000 lb to 15,000 lb. Due to the…

A:

Q: In the given image, the pressure at point A is 15 lbf/in2. All fluids are at 20°C. What is the air…

A: Given:Pressure at point A, PA=15 lbf/in2=15*144 lb/ft2=2160 lb/ft2Specific gravity of liquid in the…

Q: How much heat is absorbed by a 27.0 g sample of water in going from liquid at 38.2 °C to steam at…

A:

Q: A solid sphere, of diameter 15.5 cm, floats in 20°C water with 1527 cubic centimeters exposed above…

A: Given data is

Q: You drive on 15 to the Bay Area. Midway through the trip your car indicates that the tire pressure…

A: Given: P1=330kPaT1=500c T2=100c V = 0.025 m3

Q: The differential change in pressure p close to the surface of a static fluid is given by the…

A:

Q: 1. A rotating cylinder viscometer was used to find the dynamic viscosity of SAE 10W-30 oil at 130°F.…

A: To find: The dynamic viscosity of SAE, and also find the power required to rotate the cylinder at 50…

Q: in Bourdon Gauge experiment, if the mass of the piston is 340 gr and mass of the platform is 173 gr,…

A: Given:mp=340 g =0.340 Kgmpl=173 g=0.173 KgA=244.8*10-6 m2Absolute pressure error,Pe=7398.3 Pa

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.