5. If GSM uses a frame structure where each frame consists of 8 time slots, and each time slot contains 156.25 bits. The data is transmitted at the speed of 270.833 kbps in the channel. Find: a. The time duration of one bit b. The time duration of one slot c. The time duration of a frame d. How long must a user occupying a single time slot wait between two successive transmissions [3.692us, 0.577ms, 4.615ms]

5. If GSM uses a frame structure where each frame consists of 8 time slots, and each time slot contains 156.25 bits. The data is transmitted at the speed of 270.833 kbps in the channel. Find: a. The time duration of one bit b. The time duration of one slot c. The time duration of a frame d. How long must a user occupying a single time slot wait between two successive transmissions [3.692us, 0.577ms, 4.615ms]

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Assume a digital communication system with the following specifications: P=0.05, (n, k) block coding with n=20 and k-bit in every message, and the block code can correct maximum of 3 bits in every received dataword. Find the following: (a) The average number of errors in every transmitted codeword. (b) The number of packets received in error from 20000 transmitted packets.
For the circuit shown below, assume re = 130, VCC (in V) is: VCC 2k 92k 4k luF luF 4k Vin luF S-99 luF o Vo 0.5k 0.5k 1uF O 9.7 O 10.7 O 11.7 O 7.7 O 6.7 O 8.7 For the circuit shown below, assume re 13 2, the input impedance Zin (in k2) is: VCC 2k 92k 4k luF luF 4k Vin luF B=99 4k luF Vo 0.5k 0.5k luF O 17.53 О 22.79 O 53.92 O 42.87 O 34.53 O 9.43 HH
Q3. Draw a time division multiplexing PAM (TDM-PAM) and show that the minimum required channel BW is 2nfm where n is the number of users and fM is the maximum frequency of the message signal.
If the sequence 111111 is transmitted using Differential Manchester encoding. what is the ratio of the baud rate (D) to the bit rate (R)?
05] Assume a digital communication system with the following specifications: Pbe=0.05, (n,k) block coding with n=20 and k-bit in every message, and the block code can correct maximum of 3 bits in every received dataword. Find the following: (a) The average number of errors in every transmitted codeword. (b) The number of packets received in error from 20000 transmitted packets.
b. Maximum frequency of an analog video signal is 5 MHz. If this analog video signal is sent in digital form at the data rate of 100 Mbps, what is the number of required quantization levels?
Four computers are sending the digital data over a multiplexed line as shown in the Figure below. A). Show how the messages are multiplexed into frames using synchronous TDM and Asynchronous TDM. B). How many frames are generated if you are using Synchronous TDM? C) How many frames are generated if you are using asynchronous TDM with frame size 3? SAMPLE DATA HELLO CODE
How Analog to Digital Encoding Scheme works on data during transmission process. Explain.
Consider a packet switched network, where one packet of size 10000 bits is send from Host A to Destination D, and the datarate of the each link is 2kbps. What will be the end to end delay for one packet? Consider only transmission delay. A R1 D R2 Select one: O a. 2 sec O b. 0.5 sec O c. None O d. 1.5 seC
Q28) The bit error probability for orthogonal signaling is greater than the bit error probability for unipolar signaling. a. False b. True DIGITAL COMMUNICATIONS Course