5. Find Vout + Vin 1.25kn 1kn Vout Vin=2V -1.25 -2.5 +2.5 +1.25

Q: ide al diode ffechive vulue frequency equeal to 6o He. the source is sinu soidal, with an e equal…

A: This is half wave Rectifier with RC filter.  If the ripple = 6.06%  The average output Voltage?

Q: Assume each diode to be OFF when V₂ ≤ 0.7V and ON when VĎ >0.7V. Find iD1, İD2, İD³, and vō in each…

A: Given:a circuit,when , the diode is off. when , the diode is on. Find:iD1, iD2, iD3 and v0.

Q: Determine the Vdc level across R1 if the diode is Silicon diode XSc1 D2 Ext Trig 1N4001 V1 R1 15Vpk…

A: In this question,  Find the  average output voltage Vo    This is half wave rectifier.

Q: Sketch i0  and v01 for the network below for the input shown (Both diodes are Si. Vd = 0.7 V)…

A: During the positive half cycle only diode D1 is forward biased and it will conduct and with the help…

Q: Q3 (a) Figure Q3(a) shows the circuit diagram diode as a clamper. (i) Name the type of clamper.…

A: 1) this is negative clamper because it will shift the waveform in  downward direction. ii)

Q: What is the voltage at Vout (in V)? Answer tolerance is 5%.

A: Given: Diode voltage =1 V                    R1=6.3 kΩR2=7.2 kΩR3=6.5 kΩR4=4.2 kΩR5=2.1 kΩR6=2.4 kΩ…

Q: 5. Given a variable input voltage in the circuit shown, a Zener diode is used to regulate the output…

A: Given:a zener diode circuit, with, we need to find:a) minimumb) maximumvalue of Vin for sustained…

Q: Use Kirchhoff's law method Indicates the conduction status of the diode The result is the table of…

A:

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.