5. Find the maximum weight of the bucket that the wire system can support so that no single wire develops a tension more than 500 N. 3/3 250 E 1300 30°

Q: 5. If the maximum tension that the string can withstand is 4200N, what is the maximum mass that can…

A:

Q: Consider a copper wire with cross-sectional area 4 mm?. The Young's modulus for copper is 1.1 × 1011…

A:

Q: A tow truck is pulling a car out of a ditch by means of a steel cable (Y = 2.0 x 1011 N/m2) that is…

A:

Q: The homogeneous wire ABCD is bent as shown and is attach to a hinge at C. Determine the length L…

A: this question is about to measure center of gravity of wire for equilibrium.

Q: 1. A current path shown in the diagram below produces a magnetic field at P, the center of the arc.…

A: Given, The current in a arc which has 30 degree angle and in a square

Q: tension or compression!

A:

Q: 3. The length of the biceps muscle increases 1.7cm over the course of an overhead softball throw.…

A:

Q: Determine the magnitude P of the vertical force required to lift the wheelbarrow free of the ground…

A: Given: To find Force P

Q: 3. A 130 kg uniform beam is attached to a vertical wall at one end and is supported by a cable at…

A:

Q: in tension

A:

Q: A uniform bar of length 5.00 m is attached by a hinge to a wall (see figure). The bar is held…

A: Length of the bar, L=5.00m Force on the vertical string, F=145N Distance, x=3.33m

Q: 2. A uniform 300-kg beam, 6.00 m long, is freely pivoted at P, as shown in the figure. The beam is…

A: Approach to solving the question:Moments of the strut are balanced by the moments of beam and Mass…

Mechanical Properties of Solids

There are three types of matter- solid, liquid and gas. Out of them, solids have a rigid shaped and size. The intermolecular forces of attractions in solids are greatest. Mechanical properties are the physical properties of a material which it shows, when it is provided with certain amount of force or load. These properties are to be kept in mind for various purposes. When a force is applied to an object, the object may or may not get deformed depending upon its elastic property. But every time the object develops a restoring force against the force applied. This is commonly known as stress. If the object changes its dimensions due to the force applied it develops strain ( which is the ratio of change in dimension to the original dimension).