5. A first order transfer function has a order polynomial in s in the numerator? . ... 6. A first order transfer function can have an oscillating response to step input? 7. A stable first order transfer function must have a pole on the ... ... ... O axis e neleg of the

Q: What type of feedback controller is shown in figure A. PD controller B. PI controller C. Type 2 D.…

A:

Q: The figure below on the left shows an armature controlled de servomotor driving a load through a…

A: The figure below shows an armature controlled dc servomotor driving a load through gear train:

Q: The EMF induced in the armature of a shunt generator is 500 V. The armature resistance is 0.2 2 if…

A: Given: A shunt generator with, Induced emf in the armature, E=500 V. The armature resistance, Ra=0.2…

Q: Explain the fundamental differences between open-loop and closed-loop control systems. Provide…

A: Open-Loop Control System:An open-loop control system is a type of control system where the control…

Q: At 6V a servo has a stall torque of 2.5 kg-cm. a) What would the stall torque be at 4V? b) What is…

A: PART (A): Torque in a servo is Proportional to the applied voltage. T∝VWhere,T is torqueV is applied…

Q: What are the applications of vibration motor and Vacuum Pump in Mechatronics systems?

A: It is asked to tell the applications of vibration motor and Vacuum pump in Mechactronic systems.

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.