5. A 1.90 kg box rests on a plank that is inclined at an angle of 25° above the horizontal. The upper end of the box is attached to a spring with a force constant of 25 N/m, as shown in the figure. If the coefficient of static friction between the box and the plank is 0.83, what is the maximum amount the spring can be compressed and the box remain at rest? X 0.88

5. A 1.90 kg box rests on a plank that is inclined at an angle of 25° above the horizontal. The upper end of the box is attached to a spring with a force constant of 25 N/m, as shown in the figure. If the coefficient of static friction between the box and the plank is 0.83, what is the maximum amount the spring can be compressed and the box remain at rest? X 0.88

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

1. The figure shows a horizontal steel beam with mass M = 500 kg and length L = 2.0 m held against a vertical wall by a taut cable with 0 = 60°. A ball with mass m = 200 kg is attached via a short cable at a distance x 1.5 m from the wall. = a. Draw an extended force diagram for the steel beam, drawing the direction of the forces and the location of the forces acting on the beam. Ꮎ X m b. Using the contact point between the wall and the beam as your pivot point for torque calculations, balance the torques created by all the forces acting on the beam to determine the magnitude of the tension force that the cable exerts on the beam. C. Balance the forces in the x- and y-directions to determine the x- and y-components of the force that the wall exerts on the beam.
A mass, M = 8.6 kg hangs from a string of length L = 1.26 m. The ball is pulled back so the string makes an angle 12.16 degrees with respect to the vertical and the ball is released. The ball takes 0.69757232087945 seconds to reach its lowest point. Determine the Tension, T, in the string at the lowest point.
Question number three
A small box of mass m1m1 is sitting on a board of mass m2m2 and length LL (Figure 1). The board rests on a frictionless horizontal surface. The coefficient of static friction between the board and the box is μsμs μsμs Throughout the problem, use gg for the magnitude of the free-fall acceleration. In the hints, use ff for the magnitude of the friction force between the board and the box. Find Fmin, the constant force with the least magnitude that must be applied to the board in order to pull the board out from under the the box (which will then fall off of the opposite end of the board) Express your answer in terms of some or all of the variables μsμs m1m1 m2m2 g L Do not include ff in your answer.
Two identical, side-by-side springs with spring constant 240 N/m support a 2.00 kg hanging box. Each spring supports the same weight. By how much is each spring stretched?
Determine the force P required to force the 18° wedge under the 75-kg uniform crate which rests against the small stop at A. The coefficient of friction for all surfaces is 0.38. P 8° Answer: P = 18° 356 1.4 m 75 kg 0.5 m A 18° N
Need help checking practice problems, image included. Thanks!
A 2.0-m-long rod has a density in kilograms per meter A = a + bx ,where a = 1.0 kg/m, b = 1.0 k9/m², and x is the distance from the left end of the rod. The rod rests horizontally with each end supported by a scale. The force exerted by the left scales is 39.2 N 22.9 N 16.3 N 4.0 N 32.6 N
Problem B3. A solid cylinder is supported on an inclined plane by a chord parallel to the plane at a distance of above the radius of the cylinder. The cylinder has a radius of 2.00 m, its mass is 20.0 kg, and the inclined plane has an inclination of 20°. The coefficient of kinetic friction between the cylinder and the plane is 0.20 and the coefficient of static friction is 0.30. The cylinder remains in static equilibrium. 20 Figure B3. Problem diagram B3 a) Make a free-body diagram for the solid cylinder.
A 20 kg dog stands on a 40 kg platform that is supported by two ropes. One rope is attached to the right edge of the platform and the other is attached 50 cm from the left edge of the platform. The dog sits 50 cm from the right edge of the platform. A 5.0 kg cat jumps up, but is wary of the dog abs stays all the way on the left edge. The platform is 2.0 m long. What is the tension in each rope?
B 60° Figure 3 L A 5. A beam AB of length 10m and negligible mass leans against a wall at an angle of 60° to the horizontal. It is held at B by a string as shown. There is no friction at either of the ends A or B. A koala of mass M = 10 kg climbs up the beam from B. If the breaking tension of the string is 40 N, find the distance reached by the koala just before the string cannot support any more weight and breaks.
Determine the force P required to force the 18° wedge under the 93-kg uniform crate which rests against the small stop at A. The coefficient of friction for all surfaces is 0.47. P 5° Answer: P = 18° IM 1.5 m 93 kg 1.0 m A 18° N