5 A student performing an iodine titration expected to use a total of approximately 4.8 mL of Na,S,O, solution. The student read the initial volume of Na,S,0, in the burette as 48.32 ml. and began adding it to the iodine sample with the stopcock open at full stream. The sample suddenly turned colorless and the student quickly closed the stopcock. The final volume of Na,S,O, in the burette was 45.12 mL. Can the student use these data to determine the quantity of iodine in the sample? Justify your,answer,

5 A student performing an iodine titration expected to use a total of approximately 4.8 mL of Na,S,O, solution. The student read the initial volume of Na,S,0, in the burette as 48.32 ml. and began adding it to the iodine sample with the stopcock open at full stream. The sample suddenly turned colorless and the student quickly closed the stopcock. The final volume of Na,S,O, in the burette was 45.12 mL. Can the student use these data to determine the quantity of iodine in the sample? Justify your,answer,

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter15: Acid-base Equilibria

Section: Chapter Questions

Problem 106AE: One method for determining the purity of aspirin (C9H8O4) is to hydrolyze it with NaOH solution and...

See similar textbooks

Similar questions

Titration of a 20.0-mL sample of acid rain required 1.7 mL of 0.08 11 M NaOH to reach the end point. If we assume that the acidity of the rain is due to the presence of sulfuric acid, what was the concentration of sulfuric acid in this sample of rain?
42. a. Fill in the following table as if it is a well plate and you are mixing two aqueous compounds at a time to see if a precipitate forms. If a precipitate is expected to form, indicate that by writing the correct formula for the precipitate in the corresponding box in the table. If no precipitate is expected to form, write “NO” in the box. CaCI2 Pb(NO3)2 (NH4)3PO4 Na2CO3 AgNO3 K2SO4 b. How do you prepare 300.0 mL of a 0.250 M CaCl2 solution using an available 2(X) M solution? Support your answer with calculations, but also make sure you describe how to prepare the solution.
Lead poisoning has been a hazard for centuries. Some scholars believe that the decline of the Roman Empire can be traced, in part, to high levels of lead in water from containers and pipes, and from wine that was stored in leadglazed containers. If we presume that the typical Roman water supply was saturated with lead carbonate, PbCO3 (Ksp = 7.4 1014), how much lead will a Roman ingest in a year if he or she drinks 1 L/day from the container?
A sample of solid calcium hydroxide, Ca(OH)2, is allowed to stand in water until a saturated solution is formed. A titration of 75.00 mL of this solution with 5.00102M HCl requires 36.6 mL of the acid to reach the end point. Ca(OH)2(aq)+2HCl(aq)CaCl2(aq)+2H2O(l) What is the molarity?
One method for determining the purity of aspirin (C9H8O4) is to hydrolyze it with NaOH solution and then to titrate the remaining NaOH. The reaction of aspirin with NaOH is as follows: A sample of aspirin with a mass of 1.427 g was boiled in 50.00 mL of 0.500 M NaOH. After the solution was cooled, it took 31.92 mL of 0.289 M HCl to titrate the excess NaOH. Calculate the purity of the aspirin. What indicator should be used for this titration? Why?
For a product to be called vinegar, it must contain at least 5.0% acetic acid, HC2H3O2, by mass. A 10.00-g sample of a raspberry vinegar is titrated with 0.1250 M Ba(OH)2 and required 37.50 mL for complete neutralization. Can the product be called a vinegar?
ssume a highly magnified view of a solution of HCI that allows you to “see” the HCl. Draw this magnified view. If you dropped in a piece of magnesium, the magnesium would disappear, and hydrogen gas would he released. Represent this change using symbols for the elements, and write the balanced equation.
The procedures and principles of qualitative analysis are coy cred in many introductory chemistry laboratory courses. In qualitative analysis, students learn to analyze mixtures of the common positive and negative ions, separating and confirming the presence of the particular ions in the mixture. One of the first steps in such an analysis is to treat the mixture with hydrochloric acid, which precipitates and removes silver ion, lead(II) ion, and mercury(I) ion from the aqueous mixture as the insoluble chloride salts. Write balanced net ionic equations for the precipitation reactions of these three cations with chloride ion.
What mass of silver chloride can be prepared by the reaction of 100.0 mL of 0.20 M silver nitrate with 100.0 mL of 0.15 M calcium chloride? Calculate the concentrations of each ion remaining in solution after precipitation is complete.
Strong acid solutions may have their concentration determined by reaction with measured quantities of standard sodium carbonate solution. What mass of Na2CO3 is needed to prepare 250. mL of 0.0500 M Na2CO, solution?
The amount of oxygen, O2, dissolved in a water sample at 25 C can be determined by titration. The first step is to add solutions of MnSO4 and NaOH to the water to convert the dissolved oxygen to MnO2. A solution of H2SO4 and KI is then added to convert the MnO2 to Mn2+, and the iodide ion is converted to I2. The I2 is then titrated with standardized Na2S2O3. (a) Balance the equation for the reaction of Mn2+ ions with O2 in basic solution. (b) Balance the equation for the reaction of MnO2 with I in acid solution. (c) Balance the equation for the reaction of S2O32 with I2. (d) Calculate the amount of O2 in 25.0 mL of water if the titration requires 2.45 mL of 0.0112 M Na2S2O3 solution.
Describe in words how you would prepare pure crystalline AgCl and NaNO3 from solid AgNO3 and solid NaCl.