Draw the situation and solved the problem 5) A MOTOR IS ATTACHED TO A 7.5-1n DIAMETER PPE CONNECTING TWD RESERVORS ATAnELEVATION 10om AND ISM RESPECTIVELY (MOTOR IS AT ELEV 0). THE aPE IS 100 mLONG AND DISCHARGES WATER ATA RATE OF SO Lic. THE HAZEN WILLLAMS120. WHAT IS THE MOTOR'S EFFICIENCY IF IT IS RATED 40HP?COEFFICIENT IS

Given: Diameter of the pipe→D=7.5 in=0.19 m Length of the pipe→L=100 m Elevations of reserviors=15 m…

5) A MOTDR IS ATTACHED TO A 7.5-1n DIAMETER FPE ConnECTING TWo RESERVRS AT AN ELEVATION 10om AND ISM RESPECTIVELY ( MOTOR IS ATELEV O). THE APE IS 10o m LONG AND DISCHARGES WATER AT A RATE OF 5O LiC. THE HAZEN WILLLAMS COEFFICIENT IS 120. WHAT IS THE MOTOR'C EFFICIECY IF IT IS RATED 40 HP?

5) A MOTDR IS ATTACHED TO A 7.5-1n DIAMETER FPE ConnECTING TWo RESERVRS AT AN ELEVATION 10om AND ISM RESPECTIVELY ( MOTOR IS ATELEV O). THE APE IS 10o m LONG AND DISCHARGES WATER AT A RATE OF 5O LiC. THE HAZEN WILLLAMS COEFFICIENT IS 120. WHAT IS THE MOTOR'C EFFICIECY IF IT IS RATED 40 HP?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2. A car is traveling on a highway at 28 m/s. a) What is the pressure at the bottom of a car's gas tank. that is a cube with side lengths of 0.5 meters? Assume the tank is full of gasoline with a denisty of 800 kg/m^3. b) How much pressure does a pump need to supply in order to draw gasloine from the bottom of the tank to the top of the tank? The velocity of the gasoline once it is pumped out of the tank should be 1 cm/s; the gas at the bottom of the tank is at rest. c) The gasoline from part b flows through a tube (cylinder) of radius lcm before entering a larger tube of radius 10cm. What will the velocity of the gasoline be in the larger tube? d) The tires on the car have an outer radius of 0.2 meters. How many complete rotations did the tires go through in one hour? Hint: Determine how far the car travels in one hour. e) How many hours can the car travel before running out of gas? f) During your journey. you hit a pothole and have to change your tire. You get your spare…
NEED THE ANSWEER IN 15 MINUTES. PLEASEHELP.WILL UPVOTE
Diameter - 40 cm force 4000 N 1 Determine pressure ?
4) A stone is dropped down a well and 5 s later the sound of the splash is heard. If the velocity of sound is 260 fps, what is the depth of the well in meters.
The impeller diameter of a centrifugal pump used in water pumping is 250 mm, the inlet radius of the water to the impeller blades is 25 mm, and the outlet radius is 10 mm. The inlet angle of water to the blade is 30°, and the outlet angle from the blade is 25°. The blade inlet width is 10 mm, and the outlet width is 5 mm. Given that the pump's rotation speed is 1800 rpm; a) Find the flow rate of the water passing through the pump?b) Find the required shaft power for the pump under ideal conditions?c) Find the pump's discharge head under ideal conditions?
P5/ Find the equation tor the plane through Plo,2,-1) and normel to n= 3i - 2-k
No. 4 please
A vehicle which was travelling at speed 4 m/s now travels with 8 m/s. What will be new stopping distance if original stopping distance was 50 m.
Determine the % increase in Flowrate, Net pumping head and Pump power based on the following conditions below: a) Increasing the impeller speed by 30% b) Increasing the impeller diameter by 20% c) Compute the same if the two conditions above will prevail in one condition Please show complete solution.
101.3 kpa expands constant temperature from 0.l m' to 10 ft', what is the final pressure in bar
Give reason - Size of a bubble increases as it rises towards the surface.