4m A 4-meter-diameter cylindrical tank contains oil and water as shown in the figure. At the bottom of the tank is an orifice having a diameter of 0.1 meter with coefficient of contraction and coefficient of velocity equal to 0.62 and 0.98, respectively. Determine the following: 6m Oil, SG = 0.9 a. The rate of flow on the orifice (L/s). b. The time to remove water only at the tank (s). c. The time to drain all the liquids (s). 4m Water

Q: Q3/ The following is an incomplete page of level book in which (?) indicates missing Entry line.…

A:

Q: The following data were obtained by stadia observation: zenith angle = 81° 50', s = 2.50 ft. The…

A:

Q: A trip table (veh./hr) needs to be loaded on the network shown in the table below. Find the total…

A: Step 1:Step 2:

Q: 200 N 53° A 36° 1.5 189 N 42 kN/m 3 В 4 3

A: When we are calculating the moment due to udl or Uvl we calculate it as  Force acting /m length ×…

Q: Why is a 2-m rod recommended for the roving receiver? O Canopy obstruction can be an issue when…

A: One of the most common errors in GPS surveys is the incorrect reading or recording of the height of…

Q: A distance of 300 m is to be laid-out using a tape having an incorrect length of 29.98 m. How much…

A: Given, Distance to be measured, say D = 300 m Actual/incorrect length of tape, L' = 29.98 m   To…

Q: 239,0 185.2 O'ନ୍ଧ୍ୟା NETI (D) (89 ୬ଗ F 6 3d),6 8''tt ଠଆ neer

A:

Q: centroid C of the beam having the cross-sectional area shown 150 mm 150 mm 20 mm 20 mm B

A:

Q: How did you get the 24.35 kips

A:

Q: Tor flows nate 28 Lis Find pump Power Eし、60M L00 mm ち0 mm El. 30MH

A: Given data Pump Discharge  Elevation heads at two points Length

Q: Problem 26.5 Two level sections of 40-m stations with center heights of 1.32 and 1.59 m in cut, base…

A:

Q: STA BS HI FS IFS ELEV BМ — а 1.24 234.51 m ТР- 1 1.11 3.40 1 + 00 + 25 + 50 + 75 ТР - 2 4.6 2.7 3.6…

A: Height of instrument method HI = elevation + BS elevation = HI - FS

Connections

In steel structures, connections are the members that join two or more steel members. The connections are the most important members of any steel structure, and hence, they are designed more carefully. The majority of the construction cost of steel structures is incurred due to the connections. The design of connections is done as per the recommendations and specifications of the American Institute of Steel Construction (AISC).