Answered: 45 lb 4=0.40 4=0.30 Determine whether…

Name: 45 lb4=0.404 = 0.30Determine whether the block shown is in equilibriu
Uploaded: 2024-03-20T06:56:55.000Z
Channel: Bartleby
Description: 45 lb4=0.404 = 0.30Determine whether the block shown is in equilibrium and find themagnitude and direction of the friction force when P= 100 lb.40

Engineering

Mechanical Engineering

45 lb 4=0.40 4=0.30 Determine whether the block shown is in equilibrium and find the magnitude and direction of the friction force when P= 100 lb.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A 200 lb block is in contact with a plane inclined at 30ᵒ with the horizontal. A force P parallel to and acting up the plane is applied to the body. If μs = 0.20, Determine: a. The force P required to just impend motion up the plane. b. The force P just to prevent motion down the plane.
Do it soon i will rate
The bobcat loader (Figure Q3) has a mass of 1200-kg, shows the center of mass is at G1. If there is a 200-kg pebble in the bucket, with center of mass at G2 determine the reactions of each pair of wheels A and B on the ground and the force in the hydraulic cylinder CD and at the pin E. There is a similar linkage on each side of the loader. L0.5 m E 0.1 m_ D 0.2 m G2 0.18 m G1 0.6 m 0.5 m В 0.45 m 1.2 m 0.15 m 0.2 m 0.05 m Figure Q3
A 1130-kg car is held in place by a light cable on a very smooth (frictionless) ramp as shown below. The cable makes an angle of 31.0° above the surface of the ramp, and the ramp is itself raised by 25.0° above the horizonal. a. Find the tension in the cable. b. How hard does the surface of the ramp push on the car? 31.0° 25.0° 02016 Pearson Education, Inc. Cable
A former student of mechanics wishes to weigh himself t has access only to a scale A with capacity limited to 110 lbs and a small 20- lb spring dynamometer B. With the rig shown he discovers that when he exerts a pull on the rope so that Bregisters 18 lb, the scale A reads 84 lb. What is his correct weight? Answer: Weight= lb
Q1) A man is pulling a spring of stiffness coefficient 8 Ib/in by his hand with the entire arm held horizontally rotating about shoulder joint O; this force acts at the 21° angle is shown. Determine the force exerted by the deltoid muscle on the upper arm at A and x- and y- components of the force reaction at the shoulder joint. The weight of the upper arm Wu = 4.1 Ib, the weight of the lower arm W1 2.4 Ib, and the weight of the hand WH= 0.9 Ib; all these weights act at the locations shown in the figure. the spring extended 1 in only as shown in figure 1. A tensile force in the deltoid muscle prevents the arm from A- 8 Ibin Equilibrium x-1 in Deltoid muscle Fo A YW, YW -5.2 16.5 25.4 Figure 1
Q2. Determine the stretch in each spring for equilibrium of the block of mass M. The springs are shown in the equilibrium position Given: M = 2 kg a - 3 m b = 3 m C - 4 m kAB - 30 kAC = 20 kAD - 40 g- 9.81 www D
Determine the required length of cord AC in Fig. 3-8a so that the 8-kg lamp can be suspended in the position shown. The undeformed length of spring AB is l'AB= 0.4 m, and the spring has a stiffness of KAB 300 N/m. - إحسب الطول المطلوب للحبل (AC) اللازم لتعليق مصباح كتلته (kg 8) كما في الشكل ، علما ان الطول الاصلي m 824.0 C (KAB = 300 N/m) di Jales (0.4 m) (AB) i 2 m KAB = 300 N/m 30° B
The chain binder is used to secure loads of logs, lumber, pipe, and the like. If the tension T₁ is 2.1 kN when 9 = 21°, determine the force P required on the lever and the corresponding tension T₂ for this position. Assume that the surface under A is perfectly smooth. Assume a = 110 mm, b = 420 mm. T₁ Answers: P= T₂ = 六 B KN 6 KN 0 SETO 360000 T₂
Q.3) The coefficient of friction between the 120 lb block (shown in figure below) and the incline plane is 0.3 and that between the cord and cylindrical support is 0.4. Determine the range of cylinder weight W for which the system shown below will be in equilibrium. μ = 0.3 120 lb 24° <μ = 0.4 5 W
The uniform crate shown in the figure weighs 200 lb. It pulled up the incline by a counterweight W of 400 lb. Find the maximum and minimum values of D so that the crate does not tip over as it slides up the incline. Determine the weight W if the 200 lb crate is on the verge of tipping forward as it slides up the incline. Also, assume D = 3.32 ft Final answer: max. d = 3.35 ft ; min. d = 1.61 ft Find W
A puck weighs 9 lb and rests on the center of the frictionless surface of the ramp supported in equilibrium by ropes AC and BC. Determine the normal force the ramp exerts on the puck as well as the tension in each of the two ropes. X g a b A Values for dimensions on the figure are given in the following table. Note the figure may not be to scale. Variable Value 44.0 in 48.4 in 24.2 in 50.8 in 50.6 in 12.1 in 71.3 in C d Z e f 9 B