What is the (Mixing Acid and Base) in industrial chemical process,  (and write a half-page summary of it in 12pt font, single-spaced). Explain what is produced, the chemical reaction(s) involved, why this process/product is important, and how an understanding of limiting reagents is important in optimizing this process.  Use at least two sources of information.  Provide URLs for all sources you use in your research. Chemical reactions discussed must be complete and balanced, including states.

Draw a schematic diagram using this information.  Preparation of the solution Take about 25-30 ml of distilled water in a beaker and add powdered crude copper sulphate while stirring the solution so that the powder dissolves. Keep adding the powdered sample till a little of it remains undissolved, even if it is stirred thoroughly. Now add 2-3 ml of dil. H2SO4 to make the solution clear. This prevents the hydrolysis of copper sulphate. Filtration of the solution Take a funnel and fix a filter paper in it and clamp it to a stand. Place a china dish under the funnel. The stem of the funnel should touch the wall of the china dish to avoid the solution splashing out. Pour the solution into the funnel over a glass rod and collect the filtrate in a china dish. The insoluble impurities are left in the filter paper as residue. Concentration of the filtrate to crystallisation point Heat the china dish on a sand bath till the solution is reduced to about one-third of its original volume. To…

Part A - Reactions of Carbon Dioxide Gas 1. Place a small lump of dry ice into a large test-tube. To the dry ice add about 5 mL of water. After the gas has bubbled through the water for a few minutes (so that it may be assumed the solution is saturated with the gas), test the acidity of the solution by adding 1 drop of universal indicator solution and check the pH on the colour chart provided. Record your observations onto your results page. SODIUM HYDROXIDE 2 M 2. Place two large test tubes in the test tube rack. In one tube place a small lump of dry ice and cover the mouth of the tube with a loose plug of cotton wool. Stand the test tube in a beaker of containing a little warm water (from the hot water tap) for a minute. The test tube will fill with carbon dioxide gas. In the meantime, obtain two small (100 or 150 mL) beakers, and place 20 mL of water in each and add 3 drops of universal indicator to each. 3. Do this step quickly to avoid loss of CO,(g) from the test tube. Remove the…

If you were told to provide a chemical formula for a compound such as dinitrogen tetroxide, state a strategy for how to solve the problem in 2 to 4 sentences. Just a broad strategy you would use for any compound.