4. You have been asked by your professor to create a solution using 2 mg of the amino acid alanine (pictured here) and enough water to create a final volume of 50 ml. What is the final concentration (in mM) of this amino acid solution? Assume that the atomic mass of C is 12 amu, H is 1 amu, N is 14 amu, and O is 16 amu. H. N-C-C. он CH,

4. You have been asked by your professor to create a solution using 2 mg of the amino acid alanine (pictured here) and enough water to create a final volume of 50 ml. What is the final concentration (in mM) of this amino acid solution? Assume that the atomic mass of C is 12 amu, H is 1 amu, N is 14 amu, and O is 16 amu. H. N-C-C. он CH,

Anatomy & Physiology

1st Edition

ISBN:9781938168130

Author:Kelly A. Young, James A. Wise, Peter DeSaix, Dean H. Kruse, Brandon Poe, Eddie Johnson, Jody E. Johnson, Oksana Korol, J. Gordon Betts, Mark Womble

Publisher:Kelly A. Young, James A. Wise, Peter DeSaix, Dean H. Kruse, Brandon Poe, Eddie Johnson, Jody E. Johnson, Oksana Korol, J. Gordon Betts, Mark Womble

Chapter2: The Chemical Level Of Organization

Section: Chapter Questions

Problem 25RQ: C6H12O6 is the chemical formula for a ________. polymer of carbohydrate pentose monosaccharide...

See similar textbooks

Similar questions

A ________ can help keep the pH of a solution stable. a. covalent bond b. hydrogen bond c. buffer d. pH
3. How will you prepare 500 ml of 0.750 M citrate buffer with pH of 4.25 from solid citric acid (C6H8O7) and solid sodium citrate (Na3C6H5O7). The Ka of citric acid is 7.40 x 10-4 . Given: • (Na3C6H5O7) solid sodium citrate = conjugate base in molarity [? −] • (C6H8O7) solid citric acid = weak acid in molarity [??] • 7.40 × 10−4 ?? of citric acid = ??? (acid-dissociation constant) • 500 ml of 0.750 M citrate buffer
6. Draw each of the following amino acids in the ionic form that predominates at pH 7. Show all charges. (Refer to table 16.3 on page 475 in the textbook.) 6.3. 6.4. 6.5
2. Write the formula for the conjugate acid for each of the following bases: a) CO b) H:O c) H:POr
1.Draw the structure of Glycine at the following pH values: 5.97
Purified proteins can have their mW determined by: O Ethanol precipitation O SDS-PAGE O going to taco bell O mowing the lawn Question 45 You want to make a buffered solution to measure the activity of an enzyme, but you forgot the pka of your weak acid. You added 1mL of 1M acid, and 0.1 mL of 1M conjugate base to 8mL of water. The resulting pH you measured on the pH meter was 5.6. What is the PKA of your weak acid? 4.6 5.6 6.6 076
6. The [a] of cheatalotic acid is + 10°. The structure shown below was thought to be correct. Answer for Part b HO, COOH H, HO OH Cheatalotic Acid Incorrect Structure a) Why is the structure shown incorrect? b) Propose a cture of cheatalotic acid that can possibly be correct, assuming atom connectivity is correc
3.) A mixture of amino acids was subjected to paper chromatography with six amino acid standards in order to determine its composition. After visualization using ninhydrin, the measured distances were as follows: A B с D E F G a.) What is the Rf value of each amino acid observed? X Distances: Solvent 10.3cm A 4.50cm B - 1.32cm C - 6.60cm D - 5.20cm E - 3.52cm F 8.70cm G - 10.26cm X1 - 9.72cm X2 - 4.3cm X3 7.1cm - b.) What are the possible components of the amino acid mixture? Answer can be up to two amino acids per component.
A mixture of proteins contains four different polypeptides, all in ~equal concentration, in solution with the following properties: Protein Molecular Mass (kDa) Isoelectric point A 45 4.5 B 77 6.0 C 28 4.1 D 14 10.7 A fraction of the protein solution is applied to a strong cation exchange column using a buffer at pH 8.0 with increasing [NaCl] from 0.05 M – 1.0 M. The chromatogram is shown below: 1. Based on the data presented, which of the following statements is true: Peak #1 is protein D Peak #4 is protein C Peak #3 is protein A Peak #4 is protein D Peak #2 is protein B 2. Since you know that the proteins are all present in approximately equal concentrations, the different relative peak areas tell you that: There are more neutral amino acids in protein #4…
Polymers of macromolecules are disassembled to monomers by: O a. Van der Waals interaction O b. Disulfide reaction O c. Condensation reaction O d. Hydrolysis reaction O' e. Dehydration reaction
6. You weigh 5 milligrams of protein and dissolve it in 1.0 mL of water to make a stock solution with a concentration of 10 mg/mL. You plan to load 10ug of protein in each lane on your SDS PAGE. To do this, you would like to have 10µg in 5 ul so that you can load 5 µl into each well. (5 μl is easy to pipette and fits into a well.) 6a. Using your 5 mg/mL stock solution, you wish to make 100μL of the correct concentration of protein to load. How do you make this working solution? (Yes- you would want this to be in 1x sample buffer, but that makes this question more complicated. So for this question just make the protein in water.) Volume of 10mg/ml Final Volume 100μL of protein 6b. This is a 1: Q 2 Body* W #3 dilution. E $ 4 A R B % 5 MacBook Pro I U T A 6 Y & U 8 (B
2. Four unidentified solutions of equal concentration (0.1 mol/L) were prepared by chemistry students who were investigating the properties of acids and bases. Solution Red litmus Blue litmus pH Conductivit Blue No change 13.2 Very high 2 No change Red 3.5 Weak 3 No change Red 1.8 Very high 4 Blue No change 10.7 Weak Identify the acids and the bases in the list above. b. Classify the acids and the bases as being weak or strong with supporting information. Suggest another test that could be used to determine the relative strengths of the acids.