4. Wet concrete exerts a pressure distribution along the wall of the form. Determine the resultant force of this distribution and specify the height h where the bracing strut should be placed so that it lies through the line of action of the resultant force. The wall has a width of 5 m. 9 Cp = (4z*) kPa

Q: The horizontal fuel tank with a circular cross section, d=2.6 m and length l=9.6 m, is completely…

A: Given data, Diameter of circular fuel tank, d = 2.6 m Length of the tank, l = 9.6 m Density of the…

Q: Determine the resultant force at support A. 2 2 Hint: A = √4² +4,²

A:

Q: If the trough is filled with water (p = the 1000 kg/m³), determine resultant of the water pressure…

A: ρ=1000 kgm3side of equilateral traingle a=115 mmSo A=34a2A=34×.1152A=5.7265×10-3 m2g=9.81…

Q: The rectangular plate of sides 560 mm x 1590 mm is supported by hinges along its side BC and by the…

A:

Q: A 50-m steel surveying tape has a mass of 1.6 kg. If the tape is stretched between two points at the…

A: Given data Length of steel surveying tape, SB,total = 50 m. Mass of steel surveying tape, m = 1.6…

Q: Find the tensions in the ropes if the person has a weight of W = 170 N, the length of the plank…

A: Assume the height of person is 1.7 m. Draw the free-body diagram of the system.

Q: The 200-lb uniform tank is suppended by means of a 6-ft-long cable, which is attached to the side of…

A:

Q: B. If the force vector shown below has x, y, and z components of 300 N, 400N, and 800N respectively,…

A:

Q: 3. The pneumatic jack is used in a service station as shown in the figure below. If the car and lift…

A: The objective of this question is to determine the force that must be developed by the air…

Q: Determine the capacity, in liters, of the punch bowl shown if R = 250mm.

A: Given data: R=250 mm

Pressure Vessels

The term pressure vessel refers to a closed container that contains gas or liquid at a different pressure than environment pressure. The pressure vessels have a wide scale of applications in our day-to-day lives and other industrial places. Some common examples of pressure vessels are gas cylinders, autoclaves, compressor vessels, etc.