4. Using the circuit below find the Thevenin Equivalent circuit as viewed by elements in rectangle (R3 and El). Hints: Make sure you draw out the circuit when you are finding the RTH. R1 R2 1ka 2k0 E1 R3 R4 A 3kQ C 4kQ E2 10V 12V RS R7 7kQ B R6 C Is1 1mA

Q: Fill in the VIR chart for the circuit below.  I need to also reduce the original circuit to a single…

A:

Q: The following circuit has to be used with the problem

A: It is given that:

Q: The voltage difference Vab between points a and b in the Wheatstone bridọe circuit is for the…

A: The voltage across R1 is calculated by voltage division rule given as:…

Q: Use mesh analysis to solve for V in the circuit below. Vs = 20 V, R₁ = 30 02, R2 = 50 Q, R3 = 20 Q,…

A: Given that: VS=20 V, R1=30 Ω, R2=50 Ω, R3=20 ΩR4=30 Ω, R5=40 Ω, R6=60 Ω, R7=80 Ω A circuit is shown…

Q: In the following circuit. If R₁=7 Q, R₂=40, R3=70, R4=7Q, Rs-2.50, R6-30 and R7=30 What is the value…

A:

Q: vo(t) in the form Acos⁡(ωt+θ) V

A:

Q: Find vout in symbolic form USING nodal analysis. please explain nodal analysis and what to look for…

A: In this question, we need to determine the output voltage Vout  using the nodal analysis. This is…

Q: ) What is the equivalent resistance in the circuit below

A: In this question,  We need to calculate the equivalent resistance?  If two resistances R1 and R2 are…

Q: For the circuit below use Superposition to determine the Current through and Voltage across each…

A:

Q: Compute the Norton current IN with respect to the load terminals a-b. Find all solutions…

A: In this question, we need to determine the Norton current IN  across the load terminals a and b.

Q: Solve the following FIND CURRENT FLOWING THROUGH Z3 FIND CURRENT FLOWING THROUGH Z4

A: The given circuit is shown below with mesh currents and assumed current directions in each…

Q: a R2 RS Rab R1 R3 R6 RA RI

A: Given circuit, R1=70, R2=160, R3=60, R4=30, R5=10, R6=20 and R7=10

Q: 3-5 The following are a set of node-voltage equations; draw the circuit they represent. UB-VA R₁ + +…

A: In this question we need to draw the electrical circuit for the given node - voltage equation.

Q: R4 1.5mA 1.2mA 0.8mA R2= R4 = %3D R1 1.0K n R2 R3 3.3Kn VS

A: Solution

Q: Determine the number of Nodes, Branches, Loops, Meshes, Series-connected elements,…

A: A network is given and determine No of Node?  No of Branches?  No of Loops?  No of Meshes?  No of…

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.