4. Use source exchange to transform the circuit shown into an equivalent circuit with a voltage source in series with an impedance. Which of these is the voltage of the new source? A) 1+j1 V B) -2 +j2 V C) j2 V 152 jis D) 1 + j3 V Ⓒ2 L90° A

4. Use source exchange to transform the circuit shown into an equivalent circuit with a voltage source in series with an impedance. Which of these is the voltage of the new source? A) 1+j1 V B) -2 +j2 V C) j2 V 152 jis D) 1 + j3 V Ⓒ2 L90° A

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter6: Power Flows

Section: Chapter Questions

Problem 6.61P

See similar textbooks

Related questions

Q: Time left 0:43 For the circuit in Figure 2. What is the total impedance ZT in Polar form? R-10 X₁-20…

Q: A source voltage is connected across a 10-ohm resistor. What is the la place transform of its…

Q: Ip=12 A Re www 13 Ω + aVL For the transformer equivalent circuit shown what is the source voltage…

A: Given circuit, Ip=12 ARe=13 ΩXe=18 Ωa2Rl=240 Ω

Q: Is 452 j492 Vs = 92-26.6°V Is = 4√2 245° A + Vs Determine the magnitude of current lo due to the…

A: here we have to find the magnitude of current I0 due to the voltage source only.

Q: 6. In this circuit, the current I is 5245° Arms. Find SLoad. A) 50.01 2134.43° VA B) 5000 Z0° VA C)…

A: Voltage source connected to a load through impedance Z is given and value of both voltage source and…

Q: 4. With respect to the following figure, explain why vo does not follow v₁ until VÂ – Vy and follows…

A: Given:A diode circuit, with output waveform, we need to explain:the operation of the circuit. Assume…

Q: Determine the output waveform for the network of figure below and calculate the output dc level. Si…

A: Rectifiers are used to convert the Alternating supply into pulsating DC. It can be an uncontrolled…

Q: 12 2010 10 L90 15 Lo Za = 5 ohms Zb= 3-j4 ohms Zc= 2 ohms Zd = 12 ohms V1= 20 angle 0 V2 = 10 angle…

Q: 7. Find all currents in the circuit below (IT, 11, 12, 13, 14 and 1s). Hint: you might want to use…

Q: 502 j2 11 12 5:1 ww 50 /0 V Vi 22 For the circuit shown, the value of the secondary side of the…

Q: Determine the Thévenin impedance, ZTH, and voltage, VTH for the circuit in Figure 3. Then calculate…

Q: A 400 MVA synchronous machine has H₁ = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two…

A: It is given that: H1=4.6 MJMVA ,S1=400 MVAH2=3.0 MJMVA ,S2=1200 MVASbase=100 MVA

Q: In a R-C series circuit, applied voltage leads the total current." True False Technically, a…

Q: 60mH 0.35: For the mutual electnc arcuit shown in figure beside if Vs=10cos100t Volts, write the set…

A: In this question, We need to write the mesh current equations of the given circuit?.

Q: Q5] find the current of the resistance 180 if the value of the source is 7.4sin(100ft-44) volt Give…

A: 5) To find the value of current flowing through 18 ohm resistor in the circuit

Q: 1. Determine the current of each line and the neutral current and measure the total power supplied…

A: Given: 3 phase 4 wire star connected load ZR= 950 ohm resister in series with 3 H inductor ZB = 1950…

Q: Example: Determine the current I, in the network in Figure below. node 1 Super ndde نكت صاد ل R 203…

Q: If an electrical circuit draws 100W + J100VAR from a sinusoidal source, then what would the circuit…

Q: 7. What is the Norton equivalent impedance at terminals a-b? (a) –j4 Q (c) j2 N (b) -j2 N (d) j4 Q…

A: The given circuit is

Q: a) 1=9.3 /0° A4. f = 350 Hz Find: 24 Ω Z1 V1 HH 11.1 µF 31 Ω Z2 V2 0.93 mH i) The values of V1 and…

A: In this question we need to find the following The value of voltage V1 and V2 The value of the…

Q: Find the impedance Zab in the circuit seen in figure. Suppose that R = = 4.5 2. Part A Zab = Part B…

A: In this question, We need to determine the equivalent impedance across the terminal a and b. If…

Q: 1 BLou sườn Ban ja Us! Uz 2 (0) - 28 4 4 0

Q: В OBPHMua0J5eg/view O Discor S Home Schoology 34.) Apply Kirchhoff's current law and voltage law to…

A: The solution is given below

Q: for the circuit shown below If v_in=5 sin2m10t then corner frequency will be ......Hz 1 UF 2k Ohm 1…

A: For the given circuit if : Vin=5sin2π10t Then corner frequency will be in Hz. Options : 50 60 70…

Q: The symmetrical short circuit current is quantity in nature. O Alternating O Exponential O Ramp O…

A: Need to fill the blank

Q: If the voltage Vs = 800 mV, then the current %3D flowing in the primary winding Ip is: 1:8 -j202…

Q: [Q3] Analyze the following electrical circuit with mesh analysis by finding the currents using…

A: Hello. Since you have posted multiple questions and not specified which question needs to be solved,…

Q: In the figure: R1 = 1439.170, R2 = R1 and R3 =2R2, then determine the value of the voltage source E.…

Q: 2. Answer the following question Draw the phasors la, Ib, I, VL, and Vs taking VL as reference…

Q: 15230° v -130 j5 2 j20 j10 a 150

A: given here a magnetically coupled circuit and asked to find the phasor currents.

Q: R ww 31.25 μF 400 mH a b

A: Thevenin's voltage is calculated by removing the load and Thevenin's voltage is calculated across…

Q: 4) AC circuit analysis is performed as it was in DC except…

A: Ac circuit analysis is performed as it was in DC except one must use phasors for the voltages and…

Q: 2. Calculate V, in this circuit. A) 5.55286.31° V B) 4266.87° V C) 5230° V D) 2266.87° V -j³r 102361…

Q: Using Figure 1, Vs 50V-15 339 Hz R1 1100 R2 100 -m XL1 320 HH XC1 700 R3 600 Figure 1 13 R4 400 XL2…

A: Here I am Solving first three subparts as per guide lines.

Q: 011 (part 1 of 2) Consider the circuit 2. Vab 3 μF 2 μF क 5 μF 140 V 2 4. V-18 V 5. V-4 V 6. V-3 V…

Q: 15) Kirchhoff's Voltage Law (KVL) states that…

A: The second law of Kirchhoff's is about the energy conservation in a closed electrical path. The…

Q: Zin w=10 krad/s an + v dμF HH bmH m + си soru 3) yukarıdaki devrede a=166, b=27, c=3 ve d=35…

Q: A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t- 0.5sin4000t) A is applied to the…

Q: For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals…

A: “Since you have posted multiple sub parts,we will provide the solution only to the first three sub…

Question

4. Use source exchange to transform the circuit shown into an equivalent circuit with
a voltage source in series with an impedance. Which of these is the voltage of the
new source?
A) 1+j1 V B) -2 +j2 V C) j2 V
152
jis
D) 1 + j3 V
Ⓒ2 L90° A

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sinusoids and Phasors of Alternating Circuit

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

For the circuit given in Figure 1, a) Find the Thevenin equivalent circuit with respect to terminals a-b b) When a 5000 resistor is connected to terminal a-b, find the voltage on the resistor wwwwwwmm c) It will be connected to a-b terminals and its voltage on 5000 load will be 132 kV rms. What should be the capacitive reactance value that will increase it? wwwwwwwww d) What happens to the short-circuit current when the a-b terminals are short-circuited? 2+1202 000 m da 127/6 kV rms ob 1.5 +/902 000 w 12725 kV ms
Three impedances, Z1 =10020.Q, Z2 =63.2518.43.2 and Z3 =1002-90•Q are connected in star. Convert the star to an equivalent delta connection. And draw the star network and also the equivalent of delta connection
Two impedances Z1 = 2 + j2 ohms and Z2 = 5cis(-45) ohms, if they will be in parallel, what would be the equivalent circuit impedance ? O 1.53 cis (-20.7) ohms 2.46 cis (-15.5) ohms 2.83 cis(18.5) O 14.14 cis (0) ohms
Two reactances 1+j2 and 2-j2 are connected in series. Which of them is inductive? What is the total reactance? What is the total impedance? Kindly answer please. Thank you. I badly need it
The impedance Z1 = 6+j8, Z2 = 8 -j6 and Z3 = 10+j0 ohms measured at 50Hz from three branches of a parallel circuit. This circuit is fed from a 100-volt 50-Hz supply. A purely reactive (inductive or capacitive) circuit is added as the fourth parallel branch to the above three-branched parallel circuit so as to draw minimum current from the source. Determine the value of L or C to be used in the fourth branch and also find the minimum current.
Find the impedance Zab in the circuit seen in figure. Suppose that R = = 4.5 2. Part A Zab = Part B Ω Zab Zab R ww Ω -182 카 ZAN 20 M Express Zab in polar form. Express your answer in ohms to three significant figures. Enter your answer using angle notation. Express argument in degrees. ANSWER: 40 0 Express Zab in rectangular form. Express your answer in ohms to three significant figures. Enter your answer in rectangular form. ANSWER: m 102 -/200 j200
Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and power factor.
For the circuit of the following figure, if R=26 0, Zc=-J26 0, and ZL=J30 0, and if the value of the nodal voltage V is 1.743-27 47° V, find the value of the reactive power supplied by the 3L-41 V voltage source. Ze R 15/24 V E ZL 341 V a 0.0377 VAR b.00736 VAR C0.0471 VAR d. 0.0589 VAR le
In the figure: R1 = 1439.170, R2 = R1 and R3 =2R2, then determine the value of the voltage source E. a 8 mA 10 mA 2 mA RT R1 R2 R3 O 25.33 11.51 O 17.27 15.43 13.82 +
A voltage and current applied to a single phase load is v= 195 sin (300t+35°) and i= 175 sin (250t- 40°). Find the single and three phase active and reactive power of the circuit if the voltage and current are in cos waveform. Active Power Reactive Power Three Phase Active power Three phase Reactive Power
The sinusoidal voltage source in the circuit in (Figure 1) is developing a voltage equal to 50sin400tV. Suppose that R = 480 Ω.Find the Thévenin voltage with respect to the terminals a,b. In rectangle form. Find the Thévenin impedance with respect to the terminals a,b. in rectangle form
4- A Circuit of zero lagging power factor behaves as a. A capacitive circuit b. An inductive circuit c. RC circuit d. RL circuit