4. Prove the identity: csc (2A) - cot (2A) = tan A. %3D 5. A student wishes to measure the height of a tower. The angle of elevation from two points A and B on the same level as the tower are 15 degrees and 60 degrees, respectively. The two points are 120 feet apart. Determine the height of the tower.

4. Prove the identity: csc (2A) - cot (2A) = tan A. %3D 5. A student wishes to measure the height of a tower. The angle of elevation from two points A and B on the same level as the tower are 15 degrees and 60 degrees, respectively. The two points are 120 feet apart. Determine the height of the tower.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

2. b) using hyperwork Hand written plzz Question 2 (a) For the beams shown in Figure 2, determine the natural frequencies using four elements. Let E; p and A be constant for the beams.. 0.5D BIRD 1.5D 2D L 0.5 2L 1.5L (b) Redo Question 2a using hyperwork software with E = 3 x 10' psi, p = 0:00073 lb-s²/in", D = 1.5 in, L=3 in.
Below is a trapezoidal beam with 3-28mm reinforcing bars at the bottom. Using the design properties of fc' = 21MPa, fs = 140MPa, n = 7, 50mm effective cover, determine the following: Note: Assume the beam has cracked. 650 50 150 500 200 150 What is the Moment of Inertia of the Transformed section of the beam? Express your answer in mm4.
Problem 2 For the simply supported beam shown below, determine whether the beam is cracked or un-cracked under the applied loads, use f'e = 25 MPa, if the beam is cracked calculate the bending stresses in the beam using the transformed area method. 20 KN 300 mm 4 kN/m A↓ D 3025 k 3 m 3 m 500 mm - աա St
Determine the y-coordinate of the centroid of the shaded area.
hello how to determine the horizontal deflection of D
Name of subject:soil mechanic
deflection @ point C, Yc using area method or double integration method
show complete solutions and original work please don't copy from other sites
2. Determine the standard temperature of the steel tape and the length of the line measured, if it was found out that at 35°C the total error due to temperature occurring was 0.03m while at 45°C the total error due to temperature occurring was 0.10m. Use C= 0.0000116/1°C.
for the beam shwon in figure , compute 1- the slope of the beam at B 2- the deflection of the beam at Use the integration method