4. If voltage and current waveforms of the circuit given in the figure are v = 120 sin(314t) and i = 10sin (314t + 1/6) respectively, R a) Calculate the values of the resistance and -V capacitance. b) Draw the waveforms for current, voltage and i(t) phasor diagram. c) Calculate the power consumed by the circuit. v(t) = Vmsinwt

Q: Q1 (a) (b) (c) State the meaning of primary cells. What is the 3 factors affecting capacitance…

A: Cells- It is the device that is used for the conversion of  chemical energy into electrical energy…

Q: The network Nc shown below in Figure 1.99(a) contains a combination of scaled capaci- tors in series…

A: When capacitors are connected in parallel their equivalent value adds up and when capacitors are…

Q: An uncharged capacitor and a resistor are connected in series to a battery, as shown in the figure.…

A:

Q: Q1 Consider the mathematical expression of the voltage and current waveforms given below: v = -1…

A: Given data for question 1 (a) v=-1sin(wt+20o) i=10sin(wt-70o) The phase shift between the two…

Q: 3.) Express the following functions in cosine form (a) 4 sin/wt - 30 ) (b) –10 sinlwt + 20)

A:

Q: For the phasor diagram in figure 6 express the voltages in sinusoids for a period of 5ms. Im Re…

A: The period of the sinusoid is given; the frequency of the sinusoid is calculated as shown below:…

Q: For the three circuits given in the figure, the source voltage is sinusoidal with a peak value of 1V…

A: Given the three circuits as shown below: For the three figures, it is provided with a sinusoidal…

Q: A 50-µF and 100-µF capacitors are connected in series and  across a 100 sin (wt + 30o) voltage.…

A: In this question we need to choose a correct option

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: Clipper Circuits:- A clipper circuit is used to clip the input voltage at a fixed higher and lower…

Q: a. Consider two capacitors C1 connected in series across V = 4 volts. Determine: a. C, b. Q, c. Q1 &…

A:

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: If C1 = C2 = C3 = 16 nF, calculate the equivalent capacitance, in nF, between points A and B in the…

A: According to questions we need to calculate equivalent capacitance.

Q: A self-inductance of 10 mH and its resistance 50 connect to AC source of voltage 200 V, and…

A:

Q: Q.4 Determine the current flowing in the capacitor(-j250) and its direction as shown in Figure…

A:

Q: Calculate average and RMS value of the voltage waveform given in Figure. 4V 2 t(ms) – 4V

A: Considering the given signal is periodic in nature then the time period of the signal is 2. The…

Q: A resistor of R = 10 ohms and an inductor of L = 0.005h are in parallel. The current in the…

A:

Q: The current through the 20-Ohm inductive reactance is given. What will be the sinusoidal expression…

A: The voltage across the inductor can be evaluated using the Ohm’s law:

Q: As the circuit consist of the inductive element, it does not allow the sudden change in the current.…

A: In this question we will define phase shift and phase lag....