4. Given in the table below is the technical descriptions of a transit-tape survey of a closed traverse. Determine the linear error of closure and its direction, balance the traverse using compass rule. Draw the closed traverse approximately scaled. LINE DISTANCE (m) FORWARD BEARING 1 2 80.0 S 58° 00' W 2 3 89.8 N 36° 44' W 3 4 120.0 N 81° 00' E 4 1 50.0 s 00° 05' W

Q: 4. During the survey of four sided polygon, closed traverse has the following dată ! Side AB =…

A: Note- a} Point Angle A 51o13' B 105o39' C 78o11' D 124o47' Sum 359o50'0''

Q: The data in the table below is for a closed-polygon traverse. Balance the traverses by coordinates…

A: Summation of Dep = -0.007 ftSummation of Lat = 0.087 ft

Q: 6. A closed traverse with 5 corners has field measured interior angles at each corner as follows,…

A:

Q: A complete solution to the problems below will include sketches as appropriate. 1. A five sided…

A: We know that sum of interior angles of a polygon is given by (n-2)*180where n = number of sideswe…

Q: Please write clearly....  List the three geometric checks that can be performed on closed polygon…

A: The following are the geometric checks that can be performed on closed polygon: 1. The sum of the…

Q: There is a three sided plot of land that you need to define. Based upon your field measurements with…

A: Calculating the closure error is necessary to determine whether the closed traverse meets Ohio's…

Q: Solve the following problems showing your complete solutions. Draw the figure completely labelled…

A: Consider the traverse diagram;

Q: The four-sided, closed traverse has the following angles and distances: A=51°23' AB-713.93 ft…

A:

Q: 1) In the closed loop traverse given below find; c) Eastings & Northings Consider that the…

A: It is asked to find the easting and northing of given closed traverse.

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.