4. Design a circuit that will satisfy the input/output relation using the following components: DC supply, 1 kilo ohm resistor, and a.) Ideal diode b.) germanium diode Solutions : Circuit Designs with multisim operations and you can choose multiples of input voltages up to 10 volts.

Q: adding bcd numbers

A:

Q: A diode at room temperature (VT=25mV) conducts 1.8 mA when its forward voltage is 0.7 volts. What…

A:

Q: Is Mc microfarads?

A: Given, The abbreviation of mc =?

Q: Question 5 The octal number 345 is smaller than the decimal number 345. True False

A: Octal to decimal number conversion  (345)8 = 3×82 + 4×8 +5 = (229)10

Q: Analyze the following ripple counters and check whether the counter is counting up or down. Explain…

A: A) plotting the waveform: We will write the outputs in MSB to LSB order with respect to clock. As,…

Q: All of the following statements about the TRIAC could be true except: OA. TRIACS are not used in…

A: TRIAC:- A TRIAC is a three-terminal AC switch that differs from conventional silicon-controlled…

Q: In a communication system the signal sent from point a to point b arrives by two paths in parallel.…

A: In a communication system the signal sent from point a to point b arrives by two paths in parallel.…

Q: The frequency shift keying is based on a digital carrier. a sophisticated digital modulation…

A: Frequency shift keying (FSK) :-  It is a technique of frequency modulation in which the frequency of…

Q: I. QUESTIONS/PROBLEMS 1. How are plus and minus current signs determined?

A:

Q: In N-channel JFET the Id is controlled by_______. a.Idss b.Vgs c.Vds d.Ig

A:

Q: For redirection which response code series is used

A: Redirection messages ( 300 – 399 )

Q: In HDB3, If the number of non-zero pulses is even, the format used is a. V000 b. B00V c. V00B d.…

A: The HDR-3 is HIgh Density Bipolar 3 Zero Coding.It is more conservative than other coding methods

Q: The A parameter is O a. expressed in Ohm O b. none of the answers O c. Expressed in Siemens O d.…

A: Transmission line in form of two port network is given by, Two port equation for ABCD parameter is…

Q: How must the uno be configured to create a traffic light? A. Pins can be configured any way B. 1 pin…

A: Arduino Uno :  The Arduino Uno is a microcontroller board based on ATmega32u4.

Q: how to convert 257 to Octal numbering system

A: Step 1 Divide the given decimal number successively by 8 until the ‘0’ quotient

Q: Suppose there are 6 digits [0,1,2,3,4,5], please tell me there are how many combinations for…

A: Given, The 6- digits are [0,1,2,3,4,5] Number of combinations of a 3-digit number with distinct…

Q: Determine 71000  mod 6 and  61001 mod 7

A: Determine 71000 mod 6 and 61001 mod 7 ?

Q: Plz solve all Questions  -1,2,3,4

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: The X/R circuit ratio of an automatic reclosure is inversely proportional to the asymmetrical factor…

A: Automatic recloser: It a type of switchgear that is used in overhead electrical distribution system.…

Q: Please answer in typing format

A: In this question, we need to choose the correct option. what is angle θ based on for a series RC…

Q: In N-channel JFET the Id is controlled by___ a. Vds O b. lg O c. Idss O d. Vgs

A: JFET is controlled by the Gate voltage and current equation in saturation region is given by , ID =…

Q: I- In the table below define the type of error and how can be increase the accuracy? Determine the…

A: Errors are the part and parcel of any instrument. These errors create a discrepency in the readings.…

Q: digital communication I need Line codes for bits stream [101000110]. 1-Unipolar Rz and Unipolar NRz…

A: The digital data encoding schemes are categorized into five types based on their synchronization…

Q: For the following circuit, values of QO, Q1 are only observed at select time indicated by the dashed…

A: At every +ve clock edge, D0 will change its output At every -ve clock edge, D1 will change its…

Q: 4. Subtract (00110011)2 from (01110101)2 using Normal, 1's complement and 2' complement subtraction.

A:

Q: Question 15 Covert (521) from base 8 to base 11

A:

Q: It is assumed that the following unit step response is measured on a second order system. Determine…

A: The solution is given below

Q: Propagation delay is usually measured in O a. milli-volts O b. nano-seconds O c. nano-Watts O d.…

A: We need to tell about unit of propagation delay

Q: The information signal is always an analog signal. an analog signal in case of an analog carrier…

A: A signal can be in form of analog or digital signal.

Q: Multiply (92.5)16 with (B.3)16 and convert the result in octal number.

A: OCTAL NUMBER SYSTEM: It is very important in digital computer work because by using the octal…

Q: Where does 23/332 for N1/N2 come

A:

Q: Need help finding TF

A: Given: Block diagram of a control system. Formula and concept: Transfer function: Transfer function…

Q: Q1: Normalize the following numbers (a) ABCDEFH (b) 1.0000000000001B (c) 10^4 - 10^3 Q2: Code…

A: Q1: Normalize the following numbers (a) ABCDEFH (b) 1.0000000000001B (c) 10^4-10^3 Q2: Code…

Q: Suppose you wish to increase the maximum clock frequency of the following circuit (without…

A: Given circuit  A pipelined computer usually has "pipeline registers" after each stage. These store…

Q: I can't clearly see the lines in the column of the equation.

A: De Morgan's theorems can be expressed as A+B=A.B--->(1)A.B=A+B--->(2)

Electrical Heating Unit

The conversion of electrical energy to heat energy is known as electric heating. The heating system that converts the electrical energy to heat energy for various application is called electrical heating unit. Electricity is employed as the firing mechanism in electric heating systems, which transforms electric current to heat. Electric heaters have heating elements in the form of electric resistors.