4. Consider the system y(n)- 0.4y(n − 1) = x(n)+x(n-1) 3 (1) Find the frequency response H(e) of this system. (2) Find the steady-state response y.(n) when x(n) = 15cos (77 + 7).

Q: What is a receptacle?  What is meant by “service drop”? What are sets of service-entrance…

A: As per the guidelines given, we can only provide the solution of one question in multiple type of…

Q: What are the steps for plotting points on microstation uisng offset, station, side and elevation?

A: We need to tell about steps for plotting points on microstation uisng offset, station, side and…

Q: ock diagram of Arduino car Detector and explain operating

A: The Digital OUT of the first IR Sensor is connected to Pin 11 of Arduino and the Digital OUT of the…

Q: From the above-mentioned statement, you are required to give suggestions and answer comprehensively…

A: Given: “With SCR control, every electric light switch in the home becomes a potential light dimmer…

Q: B. (a) Find Peak time CTP), Percent overs hoot (00os), setting time CtS), Rise Time CTR) of 3.1416…

A:

Q: 9.a. What should be done with the connector ferrule once a connector is attached to a fiber optic…

A:

Q: Fill in the blanks: Q. Expansion of LSB is

A: A combinational circuit is one in which the various gates in the circuit, such as the encoder,…

Q: A transformer secondary provides 35 Vrms to a full wave voltage-doubler circuit. The dc output…

A:

Q: Discuss any two types of signalling mode with a neat diagram.

A: two types of signaling mode with a neat diagram

Q: Name the type of wiring for the 3 wires proximity sensor shown below. BN Select one: O a. NPN…

A:

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: What can you say/perspective about National Electrical Code?

A: The National Electrical Code (NEC) was created to protect people and property from the risks posed…

Q: b) An automatic door entrance system utilizes a laser sensor. Whenever the laser sensor detects…

A:

Q: What is receptacle load ? Explain under 100 words...

A: The amount of load produced by a device inserted into a receptacle is referred to as a receptacle…

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: This is a problem of mobile communication. The detailed solution is given in the next step.

Q: • Sensors on 3 landing gear • The pilot has a Gear Down Control switch • When the Gear Down Control…

A: The required logic design can be obtained by using the truth table derived based on the given…

Q: Overcurrent devices do not have to be readily accessible if ____. Select one: A. LOCATED WITHIN A…

A: Overcurrent devices do not have to be readily accessible if LOCATED ADJACENT TO THE EQUIPMENT WHERE…

Q: Please answer in typing format

A: 1_________conductors shall not be used for more than one multiwire branch circuit unless…

Q: A set of normally closed timed open contacts will open after the time period delay.  True  False

A: Identify True or False: A set of normally closed timed open contacts will open after the time…

Q: The ________parameters may not reflect the actual operating conditions but simply provide an…

A: For the AC analysis of BJT or MOSFET based circuits, It is important to convert it into different…

Q: Compare the nested and the NPC topologies in terms of the blocking voltage for the switches employed…

A: We need to compare NPC and Nested topology.

Q: How does Signaling System Number 7 (SS7) work? Explain fully.

A: Signaling System Number 7 (SS7) : The Signaling System 7 (SS7) is indeed an international…

Q: Compare the nested and the NPC topologies in terms of the blocking voltage for the switches employed…

A: Concept- The nested and the NPC topologies in terms of the blocking voltage for the switches…

Q: Draw the wiring diagram for controlling a florescent lamp from three location and Ai conditioner…

A: The wiring diagram for controlling a fluorescent lamp from three location:

Q: List and explain types of Fire Extinguishers. What's the difference between Mechanical safety vs.…

A: Both more formal visual inspections and routine, informal "before use" visual checks enhance safety.…

Q: ________________________ is the measure of reproducibility a. Accuracy b. Repeatability c.…

A: Electrical circuits involve the measuring of different variables. The measurement of any variable…

Q: And a typical phone service installation, a drywall is constructed beneath the_. A. Weep hole b.…

A: In this question we need to find a a correct option

Q: Explain the safest one to use in an aircraft GPS OR DGPS

A: Given: GPS or DGPS

Q: What are the different onboard sources of electrical power in a modern commercial passenger…

A:

Q: COMMON TRIGGERING COMPONENTS, USED FOR START UP, CONDUCT ANOTHER SEMI CONDUCTOR COMPONENTS

A: Types of semiconductors devices / switches  Uncontrolled semiconductors ( Diode) Semicontrolled…

Q: 5. (a) What is the full form of the word "LASER"? Explain how stimulated emission amplifies light in…

A: (a) LASER: The full form of LASER is "light amplification by stimulated emission of radiation". A…

Q: A Class II hazardous location is where_ Select one: Oa. gasses are present Ob. combustible dust is…

A: We need to select correct option for given statement.

Q: Please provide a comprehensive explanation of what ring counters are as well as how they are used.

A: Introduction Ring Counters: Ring counters are the type of sequential digital circuit that is used…

Q: Match the appropriate number with the given statements. 4 DIGITAL (PWM-) OO UNO TX ON ARDUINO RX…

A: Given,

Q: Programming the device involves the blowing of internal fuses to achieve a desired_________________…

A: PLD is an IC that contains enormous no of entryways, flip-flops, and so forth that can be arranged…

Q: 4. current overloads. " and are used to protect circuits against

A: In this question, we need to fill the blanks. What are the name of devices which are used to protect…

Q: What is the meaning of "system redundancy" in aircraft electrical systems? Explain why system…

A: We have given the following problem What is the meaning of "system redundancy" in aircraft…

Q: 8: A solar cooker uses hot air to cook food. Select one: True False 19: text _____________ can be…

A: Solar cooker is device that converts direct sunlight to heat, cook food materials.

Q: How the Fossil Fuels are contributing to global warming

A: When the carbon-based organisms are buried for long years like in millon , they get decomposed, and…

Q: What are the advantages and disadvantages of Fossil Fuels?

A: Fossil fuels are buried geologic deposits of organic substances such as dead plants, and animals…

Q: Briefly discuss the loaded and non-loaded telephone cables

A: Loading is the process to increase inductance of line by adding lumped inductors atpredefined…