4. An ammonia refrigerating plant operates between pressure limits of 10.34 bar and 2.265 bars. The refrigerant leaves the evaporator as a vapor 0.95 dry and leaves the condenser as a saturated liquid. If the refrigerant mass flow rate is 4 kg/min, find the cooling load. 65.3 kw O 70.5 kw O 75.52 kw O 52.5 kw

4. An ammonia refrigerating plant operates between pressure limits of 10.34 bar and 2.265 bars. The refrigerant leaves the evaporator as a vapor 0.95 dry and leaves the condenser as a saturated liquid. If the refrigerant mass flow rate is 4 kg/min, find the cooling load. 65.3 kw O 70.5 kw O 75.52 kw O 52.5 kw

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Reference Book: Introduction to Chemical Engineering Thermodynamics by Smith, Van Ness, etc. 7th or 8th Ed.
PART A ONLY ( USE IMAGE BELOW) In a standard ideal refrigeration cycle (Fig. 1), the refrigerant 134a enters adiabatically isolated expansion valve as a saturated liquid at a pressure P1 = 1 MPa and leaves the device at a pressure P2 = 100kPa. Then the refrigerant enters the evaporator, where it changes into the saturated vapor. Subsequently, the vapor is compressed in an isentropic compressor to the pressure 1MPa and condensed in the condenser back to the initial saturated-liquid state. PART A - Determine the heat qL absorbed by the refrigerant in the evaporator and the compressor work win (per 1 kg of the refrigerant).
Required information Refrigerant-134a enters the condenser of a steady-flow Carnot refrigerator as a saturated vapor at 65.0 psia, and it leaves with a quality of 0.05. The heat absorption from the refrigerated space takes place at a pressure of 30 psia. Determine the coefficient of performance. (Round the final answer to three decimal places.) The coefficient of performance is
For refrigeration, answer the following questions
3. When subcooling the liquid refrigerant:a. the refrigerating effect per unit mass increases. b. the mass rate of flow per unit capacity decreases. c. the volume flow rate per unit capacity decreases. d. the work of compression per unit mass remain the same. e. the COP increases. f. the theoretical power per unit capacity decreases. A simple saturated refrigeration cycle for R-12 system operates at an evaporating temperature of - 5oC and condensing temperature of 40oC. Show the effect from a to f if the liquid refrigerant is subcooled to 30 oC.
Q2/ In simple refrigeration system uses R134a, the evaporator pressure is 0.25 MPa and the condenser pressure is 1. MPa. The evaporator load is 25 TR. Determine the required work to operate the compressor motor in (a) kW, (b) hp. What is the displacement volume of the compressor if the volumetric efficiency is 80%
Can you also show the T-s and P-h diagrams? A Single Stage Vapor Compression (SSVC) refrigeration system has a cooling capacity of 6 tons. The discharge of the evaporator is at -20°C & 0.1 MPa and the discharge of the condenser is at 30°C & 1.0 MPa. Determine the following: (a) the COP of the system, (b) the Energy Efficiency Ratio in kJ/hr/W, (c) the HP/ton of the system, (d) the Refrigerating Efficiency of the system.
Find the thermal efficiency of the system in percentage to 2.d.p.
A refrigeration system with a capacity of 10 tons of refrigeration, operates at 210 kPa in the evaporator, while in the condenser it is 1170 kPa. If refrigerant R-717 is saturated, calculate the theoretical power required to operate the compressor. Compressor Power = kW
Working fluid is Refrigerant 134a. Vapor-compression refrigeration system has refrigerating capacity = 1650 Btu/hour. Refrigerant enters evaporator at -10F and leaves at 15F. Isentropic compressor efficiency = 74%. Refrigerant condenses at 140F and leaves condenser subcooled at 100F. No large pressure drops through evaporator and condenser. DETERMINE: 1. Pressure of evaporator in lbf/in^2 2. Pressure of condenser in lbf/in^2 3. Mass flow rate in lb/s of refrigerant 134a. 4. Power input in horsepower of compressor. 5. Coefficient of performance.
The food storage room requires a cooling system with a capacity of 15 tons of refrigeration that operates at an evaporator temperature of -25.2 ° C and a condenser temperature of 37.5 ° C. The refrigerant used is R-717 and the system operates in saturated conditions. a. COP = b. Refrigerant flow rate = kg / s c. Heat loss rate in the condenser = kJ / s