4. A short-shunt compound generator has armature, shunt-field and series-field resistances of 0-8 2, 45 Q and 0-6 respectively and sup- plies a load of 5 kW at 250 V. Caleulate the e.m.f. generated in the armature. 282-66V

Q: To change the direction of rotation of a series wound DC generator the general rule is to

A: To change the direction of rotation of a series wound DC generator  Note: we always change the…

Q: A 6-pole lap wound generator has 900 conductors. The e.mf induced per one tur being 3 V. the…

A: Given lap connected , So, No. of poles = No. of parallel paths = 6 Given voltage per turn = 3 volts…

Q: Rotor resistance of a three-phase induction motor is 0.080 per phase. Maximum torque is available at…

A: We have an equivalent circuit of induction motor with, Maximum torque occurs at 12% slip = 0.12 Slip…

Q: A shart-shunt compound generator supplies 80 A at 200 V. If the field resistance, Rf = 400, the…

A: Given Data:Required Data:

Q: Maximum torque is realized when an armature winding is with the magnetic field at 90° O inline or at…

A: With reference to synchronous machines, the load angle or the power angle is the angle between the…

Q: Figure 1 shows an electric generator with 3 rotor windings as marked by a-1, b-2 and c-3. A…

A: The objective of the question is to design a 3-phase 3-wire connection for an electric generator…

Q: d.c. shunt generators in parallel, ench having an armature resistance of 0.1 0, running at the same…

A:

Q: / In an armature winding of d.c machine, the conductors are connected in  Ans/ 1- Series 2- parallel…

A: The armature winding of the DC machine are consist of the copper conductors

Q: how does the rotor of a 3-phase induction motor get power a-  through brushes and commutador…

A: In this question we need to choose a correct option.

Q: The frequency of rotor current in an induction motor is       slip times the frequency of stator…

A: The frequency of the rotor is based on the value of slip and input frequency. The slip value can be…

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.