4. A batter strikes a pitched ball when the center of the ball is 1.0 m above the ground. The ball leaves the bat at an angle of 45° with the ground. After 6 seconds the ball reaches the homerun wall, which is 120 m away. (a) If the wall is 11.3 m tall will the ball clear the wall? (b) Find the distance between the top of the wall and the center of the ball when the ball reaches the wall. 11.3m 45° 1m 120m

4. A batter strikes a pitched ball when the center of the ball is 1.0 m above the ground. The ball leaves the bat at an angle of 45° with the ground. After 6 seconds the ball reaches the homerun wall, which is 120 m away. (a) If the wall is 11.3 m tall will the ball clear the wall? (b) Find the distance between the top of the wall and the center of the ball when the ball reaches the wall. 11.3m 45° 1m 120m

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

I don’t know where to start with this problem.
A mass, m, with speed, v, undergoes a perfectly elastic collision with an initially stationary I mass, M, as shown in the picture. What is the ratio of the two masses, m/M if after the collision, m and M have the same speed, V, but opposite velocities?
Your help working through this problem will be a greater learning experience than I've had in class this semester. I have so little idea of how to begin this.
my b,c answers are wrong, what did I do wrong?
I have part a fine. Part b and c are giving me issues though.
I dont understand how to approach the question. My answer doesnt match with any of the options. Any help is highly appreciated
When defining a problem, you should divide the problem into three separate components. What are these components?
Quick solution. don't submit the wrong answer.
Hi, I have a materials engineering question. Thanks.
The previous answer was incorrect. I'm submitting the same one. I'm not sure how to set it up.