4. A 5 Hp 220 V 4 pole 60 Hz 3phase induction motor was tested and the following data is obtained: no load test, VN= 220 V P;= 310 W INL = 6.2 A load test , V = 220 V P;= 3650 W %3D %3D | = 11.3 A N = 1710 rpm Effective AC resistance of stator per phase, RAc = 0.3 ohm Calculate : f. Hp output

Q: A duplex receptacle is installed on a 4-inch square raised metal cover and mounted on a 4-inch…

A: Given:A duplex receptacle is installed on a 4-inch square raised metal cover and mounted on a 4-inch…

Q: CEC Table 23 allows a maximum of ten wires in a certain box. However , the box will have two wire…

A: According to CEC Table 23, the maximum number of wires allowed in a box with two wire connectors and…

Q: What color fluorescent lamps recommended for residential installation

A: White color fluorescent lamps recommended for residential installation .

Q: Q.1: The following data refer to a single-phase trans former: Turn ratio (2:1). R1=2.4n, X-5.5 n.…

A:

Q: When a ground wire is connected to an interior gas piping system and the underground portion of the…

A: Given:When a ground wire is connected to an interior gas piping system and the underground portion…

Q: 17. Draw below how to wire a 3-way switch:

A: 3-way switch - Three-way switches are typically used to operate a single light fixture from two…

Q: TOPIC: Power Systems, Power Plants & Illumination INSTRUCTIONS: - Answer in this format: Given,…

A: In hazardous locations, the use of non-metallic conduit is permitted provided it is buried not less…

Q: 21/ Which Insulators can be used for both horizontal and vertical positioning? A. PIN TYPE…

A: Given  Which Insulators can be used for both horizontal and vertical positioning?

Q: Use nodal analysis to determine each of the circuit parameters for the provided circuit

A: The circuit is shown below:  Using the nodal analysis,  VA=40 VVC=10 VVB-VAR1+VBR3+VB-VCR2=0

Q: solution!)  If Ibc is equal to 353.338∠146 and Ia is 204∠56, Ica should be

A:

Q: What is the allowed ampacity of tap conductors that supply a motor lead and do not exceed5 feet in…

A: 5. (i) Except as permitted in 240.21(A) through (H), conductors must be equipped with over-current…

Q: According to the NEC is your inspector the AHJ (authority having jurisdiction)?

A: In the given questions We need to tell about the NEC operation.

Q: What is the purpose of the NEC®?

A: NEC stands for National Electrical Code. It was developed in 1897.

Q: What dimensions are used when measuring the area of a building

A: According to National electrical code (NEC 220.12)  " outside area is used for the calculation of…

Q: Count Mounting method 15. From the information you have studied about the various electrical…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Three types of electric devices A, B, and C are connected in series across a 115-volt a-c source,…

A: GivenEA=EB=EC=E∠EB=∠EA+90°∠EC=∠EA-90°

Q: What is the minimum sized IMC conduit we should use for the above wire run if it is 24 inches long?…

A: OPTION C IS CORRECT   The minimum size of Intermediate Metal Conduit (IMC) required for a given wire…

Q: supplementary grounding electrode is required when the only grounding electrode available is ? NEC…

A: According to NEC 250.53 (D)(2)  A supplementary grounding electrode is required if metal…

Q: resistor. 0.3 A upward 0.5 A upward 0.5 A downward 0.3 A downward

A: Answer of question no. 35 We find current in every branch by using nodal analysis. Nodal analysis…

Q: 21. Referring to problem 18, determine 14. O 1.299 A O 1.216 A 1.259 A O 1.265 A

A:

Q: A hotel with a length of 12m, a width of 9m and a ceiling height of 4m

A: The required number of fixtures, watt of the bulb, and type of bulb used in an electrical system…

Q: What dimensions are used when measuring the area of a building? See NEC 220.12.

A: Referring to the NEC 220.12, the floor area is evaluated using the outside of the building…

Q: What is the minimum sized IMC conduit we should use for the above wire run if it is over 24 inches…

A: 1/2".     To determine the minimum size of Intermediate Metal Conduit (IMC) required for a wire run,…

Q: If three #10 AWG THHN/THWN wires were run in a conduit inside a building the MAXIMUM size fuse or…

A:

Q: YOUR TURN # 19-A: Determine how many 6 RHW-2* conductors can be installed in trade size 3 ½ in.…

A:

Q: using the base of 2 to answer following subtraction:  1000 base 2 -101 base 2 ________________

A: According to the given question, it is required to determine the binary subtraction of the two given…

Q: What type of The Luminaries are permitted to be installed in direct contact with the terminal…

A: What type of The Luminaries are permitted to be installed in direct contact with the terminal…

Q: Problem 1 is a review of your understanding of KVL (Kirchhoff's voltage law) Using KVL find the…

A: A simple question based on network analysis and the topics described in the solution are kirchoff's…

Q: diagram R-2R ladder type DAC? ‏

A: R-2R ladder type DAC - In R-2R Digital to Analogue converter is a resistive ladder network provides…

Q: With a neat diagram indicating all the parts, explain the working of the nuclear power plant. (Any…

A:

Q: 39. Using branch current analysis, find the voltage drop across the 1 kN resistor in the figure…

A: If we consider I1 as current flowing in the first loop in clockwise direction and I2 is the current…

Q: Convert the following numbers. Please show the calculations in detail.

A: 1) Decimal : 43.133  To Binary : (43.133)10 = (101011.00100010...)2 DESCRIPTIONS We convert the…

Q: Luminaires that are “Suitable for wet locations” are also suitable for: a. Damp locations b. Dry…

A:

Q: 42. Use superposition theorem to find current I in the circuit shown. All resistances are in ohms. *…

A:

Q: What is the purpose of the NEC?

A:

Q: You wish to turn on the two LEDs located at the outside of the LED pack, so the first thing you will…

A: Al means lower 8bits of the accumulator here, we want to turn on the two LEDs located at outside of…

Q: What is the maximum size Grounding Electrode Conductor regardless of the size of the

A: In this we will write about the maximum size Grounding Electrode Conductor regardless of the size of…

Q: 49. Calculate the value of RL for transference of maximum power in the figure shown, * 0.1 A 0.3 A…

A: We need to find out the resistance for maximum power transfer

Q: 23. A coil of copper wire has resistance of 90 Q at 20°C and is connected to a 230 V supply. By how…

A:

Q: 29. A 10 Q resistor is connected in parallel with a 15 Q resistor and the combination in series with…

A: Concept: 1) If two resistors R1 and R2 are in series combination, then equivalent resistance is…

Q: If the NEC provides a requirement to grounding equipment, it generally implies that there will be a…

A: Here we understand the concept related to grounding.

Q: Doping of a semiconductor material means that impurities are added to_______the resistance of the…

A: Doping is the process of adding impurities to be semiconductors to increase its electrical…

Analog to Digital Converters

The analog-to-digital converter (ADC) allows circuits controlled by microprocessors, Arduinos, Raspberry Pi, and various reasonable digital circuits to be connected to the real world. In the real world, analog signals have a continuous stream of information from a variety of sources and sensors capable of measuring sound, light, temperature, or movement, in addition to the many digital systems that interact with their environment by measuring analog signals from those transducers.