4- The square deforms into the position shown by the dashed lines. Determine the shear strain at each of its corners, A, B, C, and D, relative to the x, y axes. Side D'B' remains horizontal. 3 mm D' B'l |B 53 mm 50 mm 91.5° х C' 50 mm 8 mm

Q: Some homes that use baseboard heating use copper tubing. Hot water runs through and heats the copper…

A: Mass of the copper tube,(m)=540 g. Initial temperature,(T1)=15.01oC Final temperature,(T2)=25.48oC…

Q: Please click on the point in the heating curve where the vapor pressure is equal to the external…

A: When vapor pressure becomes equal to external pressure, bubble formation takes place inside the…

Q: Hi, I need help with the first part of the problem below because I'm very confused about how P1 and…

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: I need answers to problems 7, 8, and 9.  NOTE: Please stop wasting my time and yours by rejecting my…

A: The part name specified in the drawing is “BONNET SLEEVE”.

Q: Please walk me through finding how much force the women need to pull the force

A: Given data: Weight is W Need to determine the required force to pull the weight.

Q: the (1) two subscripts and (2) sign of the stress components (\sigma, \tau) under the given…

A: we have to define the state of stress for the given coordinate system

Q: I need these 2 parts answered pertaining to the print provided. If you can not answer all 2 parts,…

A: AP-001The diameter of the hole that is inclined 15 is ϕ0.25. It can be viewed in the section A…

Q: You are in an inventory management field these days.  You are working for a place which works on 365…

A: The objective of this question is to determine the number of orders per year that should be placed…

Q: Hello, I need help with the answer of 3.14 from the picture, please.

A:

Q: I will rate you with “UPVOTE/LIKE” if you answer every question.   I will rate you with “DOWNVOTE/

A: Given Data : Definitions Moment Principle

Q: What is the unstretched length in DB? * O 1.572 m O 1.837 m O 1.769 m O 3.606 m

A:

Q: You are in an inventory management field these days. You are working for a place which works on 365…

A: The objective of this question is to determine the number of orders per year that should be placed…

Q: I asked for problems 6 and 7 to be answered, but I did not get a properly structured answered as the…

A: Chamfer the edge at  45o  with 0.250” leg distance.

Q: 6 Using the drawing callout shown in Figure 5 below, which part(s) shown in Figure 4 would now…

A: According to the given dimensional tolerance for the part, the maximum and minimum allowable…

Q: I need these three parts answered, if you are unable to answer all three parts please leave it for…

A: 4.The number 81073 denotes the CAGE no. as shown in the print. The CAGE code indicates Commercial…

Q: 4. A water bug is suspended on the surface of a pond by surface tension (water does not wet the…

A: Introduction: Surface tension: Surface tension refers to the propensity of liquid surfaces to…

Project Management Techniques

The guideways or the roadways that are undertaken to perform a project efficiently and all the tools required to accomplish the task are the general outlines for project management techniques.