4) Mohr's circle is shown for a point in a physical object that is subjected to plane stress. If 1 grid square is 8 MPa, the principal stress, op1, ap2 and the normal stress acting on the planes of maximum shear Stress aave, respectively are -------- -----MPa. A-32, 22, -86 C-22, -32, 86 B--86, 22, -32 D-22, -86, -32 24) 40 2 (T

Q: Determine approximately the principal stresses of a point whose stress states are shown below.…

A: In the above stress diagrams,  are not given with values so considered 0.

Q: 1. For the given state of stress, determine (a) the principal planes, (b) the principal stresses.

A:

Q: Suppose that σx = 42 MPa . A) Determine the orientation of principal planes of stress. B)…

A: σx = 42 MPaσy = 0 MPa (from the given figure)

Q: The state of stress at a point is shown on the element. Determine (a) the principal stress and (b)…

A: (a) Write stresses that are shown in the element.   σx=240 MPaσy=100 MPaτxy=80 MPa

Q: A set of stresses applied on the 50-mm x 50-mm ABCD plate cause the plate to deform as shown where…

A:

Q: he rod has a diameter of 40 mmmm. It is subjected to the force system Fx=1100 N, Fy=500 N, Fz=900 N.…

A: The forces are The diameter od rod is The torque is

Q: Draw Mohr's circle that describes each of the following states of stress.

A: Given data:- σx =-8 ksi σy =12 ksi τxv=-6 ksi To draw:- Mohrs circle

Q: The state of plane stress at a point is uniquely represented by three components acting on an…

A: Analyze the given statement and mention the true or false.

Q: Mohr's cirde is shown for a point in a physical object that is subjected to plane stress. Each grid…

A:

Q: Show that for an annular rotating disc, the ratio of the maximum hoop stress to maximum radial…

A:

Stress transformation

The term stress indicates the measure of internal forces that develop due to an external force's application on an object. When a specific external force is applied to an object, internal stress generates in the material. The value of stress can obtain by taking the ratio of the externally applied force and cross-sectional area of the object. There are different types of stress depending on the type of external force.