4 ft 5 ft 5 ft 6 ft FB=10 kips Fc=20 kips Fo 15 kips RE RA

Q: prestress concrete design.

A: The principle  related to design of prestress concrete .  In prestress concrete , internal stresses ...

Q: The initially square element of a material is deformed as shown. Determine the shear strain of the e...

A: To find shear strain of element To find normal strain along AC,BD

Q: 3. Calculate the horizontal reaction at the hinge. a. 680.48 kN b. 677.29 kN c. 640.59 kN d. 659.24 ...

A: ##Solution of given problem of hydrostatic force on a submerged gate ##

Q: d doil Find the dhear dtrongth Cohesion =So kpa, ne mal ress-140kPa =30

A: This question is related with geotechnical engineering . In this question we are provide with value ...

Q: BEARING N 32° 14' W N 53° 42' E S 67° 28' E S 48° 57' W COURSE DISTANCE АВ 115.28 ВС 165.83 CD 206.9...

A:

Q: Point B. The Point Load of 30 kN and 50 kN/m uniform distributed load applied to he beam is as shown...

A:

Q: Situation - Wooden log is used to bridge a 2.5-m gap. The bridge will support a concentrated load of...

A:

Q: Two rods and one cable are attached to the supports at O. If two of the forces are as shown, determi...

A:

Q: Give atleast 5 comparisons or differences between Portal Method and Cantilever Method of structural ...

A: Cantilever method : For thin buildings that are likely to deform in flexure mode, the cantilever app...

Q: 60° Tain ga

A: Projection of curved Surface = Horizontal force acting on the gate  Area of projected section = 2rsi...

Q: Draw bending moment diagram for a fixed ended beam as shown in Fig. 13.3a after 15% redistribution. ...

A:

Q: Figure below shows a beam that is pin supported at Point A and roller supported Point B. The Point L...

A:

Q: The head over a ??????????-crested weir, whose breadth is 5m, is 4m. Given that discharge coefficien...

A: rectangular weir:  

Q: Determine the fixed end shear force in the local coordinate system at the beginning joint of member ...

A: Local coordinate system: Local coordinate system is a set of three coordinates (x,y and z axes) acti...

Q: An RCC beam of rectangular cross-section has factored shear of 200 kN at its critical section. Its w...

A:

Q: Determine the stress in each of the two vertical rods if the temperature rises 50 °C after the load ...

A: To determine the stress in each of the vertical rods.   Given, Rise in temperature (∆T) = 50oC Load ...

Q: Unfactored maximum bending moments at a section of a reinforced concrete beam resulting from a frame...

A:

Q: Techniques

A: The single sideband technique is a technique which is used for transmitting information like an audi...

Q: 5. When deslgning hydraulic structures, like brldges, what procedure might reduce total costs? a. De...

A: There exist many criteria in design of hydraulic structures that need to be optimized simultaneously...

Q: the ite the snear and moment equations (not simplified and simplitied) at each segment pwn uations m...

A:

Q: An angle was measured by ten different observers. The mean of each set and its probable error is sho...

A: Given: The measured angles are, Observer Mean Angle PE o ‘ “ “ 1 6 53 36...

Q: Given data Degree of saturation=D0.5 Void ratio=0:47 Specific gravity of soil=2.7 Determine water co...

A: The given question is related with geotechnical engineering . In this question we are provided with ...

Q: Given data Kinetic energy%3D30 J velocity =5 m/s Determine mass of object

A: The energy induced in the body due to velocity of particle in motion is kinetic energy. It is expres...

Q: . A constant head permeability test is conducted on a certain soil. The diameter of the sample is 7....

A:

Q: A hollow metal tube with an inside diameter of 265 centimeters must carry a tensile load of 910kN. D...

A: Di=2.65m P=910kN P=910000N

Q: Situation 2] A surveyor was tasked to cut off a required area by a line through a given point. In th...

A:

Q: A composite bar is rigidly attached to the wall at A as shown, Axial loads are applied at the positi...

A:

Q: A pipe column is braced to prevent bending and buckling. It is subjected to a compressive load of 10...

A:

Q: Determine the x-y and n-t components of the 18-kip force Facting on the simply-supported beam.

A:

Q: B 3 m 2 m- L3 2 m L2 2 m 1 m L1 m ximum force in each rod can not exceed F, determine the greatest m...

A:

Q: The 5.6-kN force Fis applied at point A. (a) Compute the moment of F about point O, expressing it bo...

A:

Q: Problem 1: The accompanying sketch shows a tract of land which has been plotted from the data of a t...

A: DMD method: DMD means the double meridian method. This Double meridian method is used to calculate t...

Q: How many zero force members are there in the truss? 600N O 1 O 2

A: How many zero force members are there in the truss?

Q: What is the roughness coefficient of a steel pipe with a length of 100 meters if the observed head l...

A:

Q: If the resultant of the loads shown passes through point B, determine the equivalent force-couple sy...

A:

Q: 1. A toll bridge carties 10,000 veh/day. The current toll is P150/vehicle. Studies shown that for ea...

A:

Q: Compute the combined moment of the two 80-Ib forces about (a) point O and (b) point A. The moment is...

A:

Q: edge of the beam. The upper slab carries a superimposed dead load oad of 2 kPa. Then the beam center...

A:

Q: Determine all the internal force for each member.

A: To find force in all members of the truss

Q: P1 = 30 kN P2 = = 20 kN W2 = 12.5 kN/m 7.5 kN/m WL = 10.5 kN/m Wp = 4.5 kN/m WD %3D A В 3 m 2.5 m 8 ...

A:

Q: Given a rectangular plate which is deformed as shown by the broken line. Determine the average shear...

A:

Q: ghboring house. They reduce their flow rate so that the windows do not break, which wo e the inside ...

A: According to given data   A home is on fire, and to prevent its spread to the next house, firefighte...

Q: The annual rainfall at a place for a period of 22 years is given below. (Year started: 1951) ( 49.7,...

A:

Q: Situation - The beam BC shown is supported by a quarter- circular arc AC having a radius of 5 m. The...

A: Given, Radius (R) = 5 m Point load (P) = 30 kN Uniform load on beam BC (w) = 4 kN/m Distance of load...

Q: From the figure shown, for a permeability of 0.001 cm/sec and a void ratio of 0.67. O Compute the di...

A:

Q: Analysis and Conclusion on the relationship of width of compression face of the beam (b) and total d...

A:

Q: PROBLEM: A rectangular reinforced concrete beam has a width of 310 mm and an effective depth of 490 ...

A: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question and s...

Q: What is the verfical displacement at: B? Yp=? Cin mm what temperature change will causse zero ·AT = ...

A: Rods 1 & 2 are in series hence they will be subjected to same tensile force

Q: The composite shaft, consisting of aluminium, copper, and steel sections, is subjected to the loadin...

A:

Q: * .Last month was good for me, I- -a lot of money have made make had made made * He -------- everyth...

A: 1.Last month was good for me , I MADE a lot of money.........here made can be most suitable because ...

Storm Sewers and Detention

The storm drains system transports rainwater or stormwater and other runoff from roads, parking lots, and roof downpipes directly to nearby creeks, rivers, or the sea without any treatment.