4 cm Water Open jet 12 cm (1)- Sea-level air

Q: nagine you have a house with low over the roof with a speed

A:

Q: Q2: The large compressed-air tank shown in the figure bellow exhausts from a nozzle at an exit…

A:

Q: I nree pipes steadiy aenver water at 20°C to a large exit pipe in Fig. P3.8. The velocity V, = 5…

A:

Q: = 1000 kg/m³) flows through a nozzle, 10 cm and velocity v = Water jet (Pwater with diameter Do…

A:

Q: A jet of water, issuing from a sharp-edged vertical orifice under d con m0 cm, at a certain point,…

A: Solution             given data.               Head (H) =10 cm               horizantal cordinate(x)…

Q: Water at 20 ° C fl ows steadily through the tank in Fig.P3.101. Known conditions are D 1 = 8 cm, V 1…

A: Given, V1 = 6 m/s D1= 8 cm D 2 = 4 cm

Q: Q3: Uniform flow at Mach number equal (2) passes over a wedge of 10 half-angle, find M2, P2/P1,…

A: This problem is related to fluid mechanics. Fluid mechanics is the subject of mechanical engineering…

Q: (E) A uniform stream of fluid with speed U at infinity flows two-dimensionally and irrota- tionally…

A:

Q: An ideal gas flows adiabatically through a duct. At section1, p1 =140 kPa, T1 = 2608C, and V1 = 75…

A: Since multiple questions are asked and also it is not specified which question to solve, so as per…

Q: Hydrogen at 4°C is circulated at 1500 psi/min from the lower to the upper reservoir, as in Fig.…

A:

Q: The solid- propellantrocket in Fig. P3.35 is self-contained and has no entrance ducts.Using a…

A: Given Molecular weight = 28 Combustion temperature = 1500 K Combustion pressure = 950 kPa Exit…

Q: In Fig. P3.130 the fl uid is gasoline at 20 ° C at a weight fl owof 120 N/s. Assuming no losses,…

A: Given data To determine the gauge pressure at section 1-1

Q: P3.114 Water flows through a circular nozzle, exits into the air as a jet, and strikes a plate, as…

A:

Q: Pump Pam = 100 kPa D= 3 cm The pump in Fig. P3.146 draws gasoline at 20°C from a reservoir. Pumps…

A:

Q: The liquid in Fig. P3.126 is kerosene at 20 ° C. Estimate thefl ow rate from the tank for ( a ) no…

A: According to given condition the liquid is kerosene so density of liquid ant 1 atm and 20oC is ρ=840…

Q: Water at 20 ° C fl ows steadily through the box in Fig. P3.56,entering station (1) at 2 m/s.…

A: Given data D1=5 cmD2=3 cmuin=2 m/sec

Q: The insulated tank in Fig. P3.182 is to be fi lled from a highpressureair supply. Initial conditions…

A: The initial mass inside the system can be calculated as,

Q: Water fl ows steadily through the box in Fig. P3.63. Averagevelocity at all ports is 7 m/s. The…

A: Given Data: The velocity at port 1 is V1 = 7 m/s. The velocity at port 2 is V2 = 7 m/s. The…

Q: A fi reboat pump delivers water to a vertical nozzle with a3:1 diameter ratio, as in Fig.If friction…

A: Applying Bernoulli's equation between 1 & 2,  Applying the continuity equation between 1 &…

Q: The large turbine in Fig. P3.184 diverts the river flow undera dam as shown. System friction losses…

A: Given data

Q: Carbon dioxide convergent-divergent to a Lule of 60 m / s, 310 °C and 300 kPa in its case, it enters…

A: Nozzle: Nozzle is a device which having varying in cross section, in which pressure is reduced by…

Q: Please be very detailed

A: Case A: When the process takes place quickly, heat transfer will not occur. And this will be the…

Q: A liquid jet of velocity V j and diameter D j strikes a fi xedhollow cone, as in Fig. P3.47, and…

A: From the linear momentum equation, The horizontal restraining force is given…

Q: A horizontal - shaft centrifugal pump lifts water at 65°C. The suction nozzle is one meter below…

A:

Q: Q: Helium, in a large tank at 100 °C and 400 kPa, discharges to a receiver through a…

A:

Q: The liquid in Fig. P3.126 is kerosene at 20°C. Estimate the flow rate from the tank for (a) no…

A: Given data as per the question Pressure at surface = 20 lbf/in2 Atmospheric pressure =14.7 lbf/in2…

Q: Q1. Converging duct at steady one dimensional flow, Inlet section: p = 2.35 kg-m³, A = 0.59 m², v =…

A: Dear student, we are suppose to solve only one question. Please post other question as a separate…

Q: The convergent-divergent nozzle in Figure 22 expands and accelerates dry air to supersonic speeds at…

A:

Q: A piston compresses gas in a cylinder by moving at constantspeed V , as in Fig. P4.18. Let the gas…

A:

Q: Q3:/ A large reservoir at (600 k) supplies air flow through a converging-diverging duct with throat…

A:

Q: Oil (SG = 0.89) enters at section 1 in Fig. P3.20 at a weightfl ow of 250 N/h to lubricate a thrust…

A: Given data S=0.91F=250 N/hr

Q: Water at 20 ° C is pumped at 1500 gal/min from the lower tothe upper reservoir, as in Fig. P3.180.…

A: Water temperature T = 20 0C Flow rate Q = 1500 gal/min = 3.342014ft3/sec Friction loss approximation…

Q: Q2: Air flows isentropically through converging nozzle which has a throat of 7 cm?. The stagnation…

A: Given data: -  The throat area of the nozzle is A = 7 cm2. The stagnation pressure is Po = 130 kPa.…

Q: Water at 20 ° C fl ows at 30 gal/min through the 0.75-indiameterdouble pipe bend of Fig. P3.154. The…

A: Given data: The flow rate water is Q = 30 gal/min. The diameter of the pipe is d = 0.75 in. The…

Q: The open stream of water seen in the following picture emerges from a nozzle into the atmosphere at…

A: Given:Pressure at centerline of section 1, P1=101 kPaDiameter at 1, d1=12 cm=0.12 mDiameter at exit,…

Q: 02: Air flows isentropically through converging nozzle which has a throat of 7 cm?. The stagnation…

A:

Q: D, -6 cm Three pipes steadily deliver water at 20°C to a large exit pipe in Fig. P3.8. The D;=5 cm…

A:

Q: P3.143 The large tank of incompressible liquid in Fig. P3.143 is at rest when, at t = 0, the valve…

A: