3-91. The weights of the various components of the truck are shown. Replace this system of forces by an equivalent resultant force and specify its location measured from point A. 175KN 27.5 kN V8.75 kN 4.2m -1.8 m- 0.9 m 0.6 m

Q: Replace the loading by a single resultant force, specify the location of force measured from point…

A: Note that, the center of mass of a uniformly varying loading (UVL) acts at the position of two-third…

Q: P1-1. Draw a free-body diagram of the ring at A and identify each force. 30° 200 N 500 N (c)

A: To draw: The free body diagram at ring A and identify each forces. FBD: The free body diagram at A.…

Q: - 5 ft- - 2 ft Question 1: 150 lb/ft Determine the resultant forces at pins B and C on member ABC of…

A:

Q: The bent rod ACDB is supported by a sleeve at A and a ball-and-socket joint at B. Determine the…

A: To Find :  The component of the reactions and the tension in the cable . Given :  The weight of…

Q: Q-4. Determine the "Horizontal Displacement" of Joint "A' of the below given frame by using t…

A: Lengths of members, AB=BC=82+62=10 ft=120 in Also, AC=12 ft=144 in ∠BCA=∠BAC=tan-186=53.13°

Q: If you replace the three forces acting on the shaft by a single resultant force (798 lb) with an…

A:

Q: The weights of the various components of the truck are below. Replace this system of forces by an…

A: To find: The equivalent resultant force and also specify the location measured from A. Given: The…

Q: Please show magnitud and direction for every member forces) Use the method of MEMBERS to determine…

A: Force F = —1500 lb

Q: It is desired that a person be able to begin closing the van hatch from the open position shown with…

A:

Q: The line of action of the 3480-lb force runs through the points A and B as shown in the figure.…

A: 1) The line of action of the 3480-lb force runs through the points A and B as shown in the…

Q: In the equilibrium position shown, the resultant of the three forces acting on the bell crank passes…

A:

Q: The backhoe and its contents have a combined weight of 300 kN and center of gravity at point G. Find…

A:

Q: Determine the components for the forces at A and D. The mass of the cylinder is 50 kg. 0.8 m 0.8 m…

A: Given : AD = 1.2 m             AC = 1.6m

Q: Determine the resultant of the three cable tensions that act on the horizontal boom if T1 = 900 lb,…

A: Consider the triangle AOB. The tension T2 is along the hypotenuse AB.We need to find the component…

Q: 2. The 30 cm handle is connected rigidly to the 5cm bar at a right angle. Determine the force…

A: The force applied to the handle is, P=100 N Length of the handle is, L=30 cm

Q: Q2. Replace the force system acting on the frame by an equivalent resultant force and specify where…

A: Solution:

Q: Determine the resultant of the forces acting on the dam as shown.

A: Given data: F1=275 kNF2=165 kNW=650 kN Need to determine the magnitude of the resultant force acting…

Q: 7

A: To solve for the resultant force R and the couple moment M at point O, we need to consider both the…

Q: 2. Find the horizontal and vertical forces at Point C as it acts on Member BD.

A: