39 - (CLO-2) I. Deep drawing II. Extrusion III. Forging IV. Rolling Which one(s) is/are bulk deformation processes given above? a) O I, Il and II b) O I, II, III and IV c) II, III and IV d) I-|| Only I

Q: Item A is one of the products manufactured at ABC Manufacturing. • Each order for producing the…

A: Order cost (OC) = $300/orderLead time (LT) = 2 weeksInventory cost (IC) = $3/unit/weekOn-hand…

Q: P3)  What are the alternative techniques are there to lean manufacturing

A: Lean manufacturing: It is a type of production process which always try to maximize productivity and…

Q: Metal forming processes can be classified into two basic categories:

A: Sheet metal working Bulk deformation processes

Q: mounting chart: Select one: a. describes the dimensions and finish of each component. b. shows an…

A: we will discuss the function of a mounting chart

Q: For the process shown in the schematic below, which of the statements is/are incorrect? Feed hopper…

A: There are two schematic diagrams,the first diagram is the injection moldingsecond is the extrusion…

Q: What material would work best for milling abrasive material? O High speed steel Carbide

A: Some materials that are used as abrasives include Diamond most often used in ceramic grinding and…

Q: Which process type must have a pre- determined capacity for the number of products processed through…

A: Jobbing: It is a type of production plan in which only specific products are produced. Each product…

Q: Kind of "manual control and automatic" scrap machine

A: Shaping and Planning are the operation of removing a layer of work material from the flat surface…

Q: Objects produced by a casting or forging process often have one or more rough surfaces that: a)…

A: Answer: The objects by a casting or forging process often have one or more rough surfaces that must…

Q: What is line of impact?

A: The line of impact is the line along which the impact forces act during the collision. Generally, it…

Q: What is the best to stop procrastinating?

A: Introduction-Procrastination is a snare that a considerable lot of us fall into. As a matter of…

Q: The breakeven production batch size

A: Given; A standard machine tool and an automatic machine tool are beingcompared for the production of…

Q: The first element in a feature control frame in Solidworks denotes what?

A: The products may vary slightly in terms of dimensions as compared to the initial designs because of…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.