350 기 mm 2400mm 400mm C A B 200mm 8 notice not hinge E 3 D =1 200kg

Q: The A-36 steel rod has a diameter of 50 mm and is firmly attached to the rigid supports at A and B…

A: Given data,  d = 50mm T1 = 50 degrees °C T2 = 30 degrees °C For A-36 steel a=12x10^-6/°C E = 200GPa…

Q: For the uniform beam shown, use superposition to determine the reaction at each of the three…

A: A simply supported continuous beam is shown in the above figure. A point load of P and another point…

Q: Determine the degree of determinacy of the structure shown below. Put "-1" if unstable, "O" if…

A: We have to determine the value of degree of determinacy and if unstable use -1 and if determinate…

Q: Q 1 Classify each of the structures as statically determinate, statically inde terminate, or…

A: Degree of indeterminacy

Q: The brass bar AB and aluminum bar BC are joined at the collar B and fixed at their ends A and C. For…

A: A composite beam with a brass section and an aluminum section is given.Modulus of elasticityThermal…

Q: Determine the reactions at the supports for the prismatic beam of Fig.

A: ∑MA = 0 (Taking Clockwise +ve and Anticlockwise -ve) wx*x*x/2 -MA+M +V*x = 0 w*x32+V*x = 0

Q: Determine the reactions at the supports 1000lb 600 lb B 20' 20' 20' 20' E 400 lb 1000 lb

A:

Q: The asymmetric simple truss is loaded as shown. Determine the reactions at A and D. Neglect the…

A: No, knowledge of size of structure is not necessary.

Q: Determine the stresses in each bar and the bond reactions.

A: Given in the Question to determine the stress in each bar and bond digram:

Q: Q5) Classify each of the structures as statically determinate or indeterminate. If indeterminate,…

A:

Q: the truss shown in the below figure is supported by a hinge at A and a link BC. Determine the…

A: FBD of the given truss: Note: Vertical reaction will not developed at support B because support Bis…

Q: For the truss given below, what is the restraint that can not be remove to arrive with a primary…

A: To find restraint force which need to be removed

Q: Solve for the reactions at the support of the given beam and loadings. 8k/ft 4 k/ft A B 30 ft - A…

A:

Loads and Reactive Forces

Loads are the external influences that a beam experiences under its working conditions. For instance, a beam may be subjected to shear loads, twisting loads, bending moment, and axial loads during its working conditions. Engineers primarily deal with beams and trusses in the civil engineering domain. Due to the influence of loads, it is very crucial to determine the induced stresses and deformation values. These values give an insight into the critical area of the beam that needs to be worked upon to make it fail-safe.