*34. D An 86.0-kg climber is scaling the vertical wall of a mountain.His safety rope is made of nylon that, when stretched, behaves like aspring with a spring constant of 1.20 × 10º N/m. He accidentally slipsand falls freely for 0.750 m before the rope runs out of slack. How muchis the rope stretched when it breaks his fall and momentarily brings himto rest?

Mass of the climber, m = 86 kg Spring constant, k = 1.20×103 N/m Displacement of the rope, d = 0.75…

Answered: *34. D An 86.0-kg climber is scaling…

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A 10.0 g bullet is fired into and embeds itself in a 1.75 kg block attached to a spring with a spring constant of 22.0 N/m and whose mass is negligible. How far is the spring compressed if the bullet has a speed of 300 m/s just before it strikes the block, and the block slides on a frictionless surface? (Note: You must use conservation of momentum in this problem.) m
7. A small block of mass M = 450 g is placed on top of a larger block of mass 3M which is placed on a level frictionless surface and is attached to a horizontal spring of spring constant k = 2.8 N/m. The coefficient of static friction between the blocks is μ = 0.2. The lower block is pulled until the attached spring is stretched a distance D = 4.5 cm and released. part a: Assuming the blocks are stuck together, what is the maximum magnitude of acceleration amax of the blocks in terms of the variables in the problem statement? part b: calculate a value for the magnitude of the maximum acceleration amax of the blocks in meters per second. part c: Write an equation for the largest spring constant kmax for which the upper block does not slip. part d: Calculate a value for the largest spring constant kmax for which the upper block does not slip, in N/m.
A block with a mass m = 2.5 kg is pushed into an ideal spring whose spring constant is k = 4520 N/m. The spring is compressed x = 0.066 m and released. After losing contact with the spring, the block slides a distance of d = 2.25 m across the floor before coming to rest. a. Write an expression for the coefficient of kinetic friction between the block and the floor using the symbols given in the problem statement and g (the acceleration due to gravity). (Do not neglect the work done by friction while the block is still in contact with the spring.)
3. A 1.5 kg block (moving in the right direction on a horizontal surface) collides with a spring whose force constant is k= 60 N/m (A) assuming the surface is frictionless, calculate the maximum compression of the spring if the block has a speed constant of 1.5 m/s before its collision with the spring. (B) what is the maximum compression of the spring if a constant force of kinetic friction acts between the block and the surface, with uk = 0.55. (The speed of the block at the moment before it collides the spring is 1.5 m/s).||
1. A heavy crate (m = 23 kg) is resting on a frictionless inclined plane while suspended from a wall by a spring. The plane is inclined at an angle of 30° from the horizontal, and the spring is stretched from its equilibrium position by 25 cm. What is the spring constant of the spring? If the frictionless inclined plane is now replaced with an otherwise identical plane except with a rough surface, the crate now stretches the spring by 12 cm from its equilibrium position. What is the coefficient of static friction? You can assume that the static friction is at its maximum value. 30°
K Question 13 of 32 A spring hangs from the ceiling with an unstretched length of xo = 0.99 m. A m¡ = 9.1 kg block is hung from the %3D spring, causing the spring to stretch to a length X = 1.18 m. Find the length x2 of the spring when a m2 = 3.3 kg block is hung from the spring. For both cases, all vibrations of the spring are allowed to settle down before any measurements are made. m2 X2 = %3D 0.04 m m,
P-7. The steel shaft shown in the figure rotates at 6.40 Hz with 42 kW taken off at A, 27 kW removed at B, and 69 kW applied at C. Using G = 110 GPa. The shear stress developed @ BC is_ MPa A B 55 mm ¢ 65 mm o 4 m 2 m 12.173 16.747 20.505 25.942 31.821
A 5-kg collar A is at rest on top of, but not attached to, a spring with a stiffness k1 = 400 N/m when a constant force of 150 N is applied to the cable. Since A has a speed of 1 m/s when the upper spring is compressed 75 mm, determine the k2 spring stiffness. Neglect friction and the mass of the pulley. 450 mm. k₂ 75 mm k₁ 400 mm. B 150 N
Use g = 10m/s/s
X Incorrect The 14.9-in.spring is compressed to a 7.6-in. length, where it is released from rest and accelerates the sliding block A. The acceleration has an initial value of 440 ft/sec² and then decreases linearly with the x-movement of the block, reaching zero when the spring regains its original 14.9-in. length. Calculate the time t for the block to go (a) 3.65 in. and (b) 7.3 in. -7.6 14.9 Answers: To go 3.65 in., t= i To go 7.3 in., t= 0.017 0.012 sec sec
A student conducts the "Hooke's Law" Lab with the same apparatus and collects the following data. You can assume that with 0 g hung on the spring the spring displacement is O cm. hanging mass displacement spring (g) (cm) 50.0 3.5 100.0 7.2 150.0 11 200.0 14.2 250.0 18 300.0 20.5 Based on this data, what is the spring constant, k, in N/m to the correct number of significant figures.
Khufra works at a spring factory and he was assigned to test a certain spring, whose constant is 50 N/m, attached to a 50-kg block in an incline (8=30*). With the spring initially at equilibrium position, the block was pushed 0.5 meters up the incline by a 30-N external force applied parallel to the path. The coefficient of kinetic friction is 0.30. a) draw clearly the FBD of the block. b) How much is the normal force (in Newtons) on the block? c) How much work is done by the spring (in Joules) on the block?

SEE MORE QUESTIONS

Recommended textbooks for you

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

College Physics

Physics

ISBN:

9781305952300

Author:

Raymond A. Serway, Chris Vuille

Publisher:

Cengage Learning

University Physics (14th Edition)

Physics

ISBN:

9780133969290

Author:

Hugh D. Young, Roger A. Freedman

Publisher:

PEARSON

Introduction To Quantum Mechanics

Physics

ISBN:

9781107189638

Author:

Griffiths, David J., Schroeter, Darrell F.

Publisher:

Cambridge University Press

Physics for Scientists and Engineers

Physics

ISBN:

9781337553278

Author:

Raymond A. Serway, John W. Jewett

Publisher:

Cengage Learning

Lecture- Tutorials for Introductory Astronomy

Physics

ISBN:

9780321820464

Author:

Edward E. Prather, Tim P. Slater, Jeff P. Adams, Gina Brissenden

Publisher:

Addison-Wesley

College Physics: A Strategic Approach (4th Editio…

Physics

ISBN:

9780134609034

Author:

Randall D. Knight (Professor Emeritus), Brian Jones, Stuart Field

Publisher:

PEARSON

SEE MORE TEXTBOOKS