Subject: Mechanics of materialsNote : 2.33 is question number this is not a graded question 2.33 The stress components at a critical point that is in plane stressdue to a force P areOrr = 10P MPa (T)Ovy = 20P MPa (C)=D5P MPa%3D%3DTy%3!where P is in kilonewtons. The critical stress intensity factor ofthe material is 33 MPa/m. For inspection purposes, the small-est crack length that is acceptable is 1 mm. What is the maxi-mum force P that can be applied?

It is required to determine the principal stresses.…

33 The stress components at a critical point that is in plane stress due to a force P are 3D 10P МPа (T) Oy = 20P MPa (C) %3D Try 5P MPa where P is in kilonewtons. The critical stress intensity factor of the material is 33 MPa./m. For inspection purposes, the small- est crack length that is acceptable is I mm. What is the maxi- mum force P that can be applied?

33 The stress components at a critical point that is in plane stress due to a force P are 3D 10P МPа (T) Oy = 20P MPa (C) %3D Try 5P MPa where P is in kilonewtons. The critical stress intensity factor of the material is 33 MPa./m. For inspection purposes, the small- est crack length that is acceptable is I mm. What is the maxi- mum force P that can be applied?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need the answer as soon as possible
If an aluminum weighs 165 lb/ft^3, How much will a 12-in dia. sphere weigh when immersed in water? Answer: 53.721 TRY AGAIN
Please answer and label each part
MECHANICS OF DEFORMABLE BODIES WRITE THE COMPLETE SOLUTIONS. UPVOTE WILL BE GIVEN. ANSWER IN 2 DECIMAL PLACES.
I need the answer as soon as possible
Please answer the following questions as a reply on this Discussion Provide a Stress-Strain Diagram showing the relationship of shear strain to shear stress. Specify the proportional limit, modulus of rigidity, elastic limit, yield point, ultimate strength and nominal rupture strength. Hint: you can use excel to assign random values of shear stress and strain, and to graph them easily.
SUBJECT: FUNDAMENTAL OF ENGINEERING MECHANICS Q2 A2 PLEASE ANSWER AS SOON AS POSSIBLE
Answer # 4-8 ( 1 or 2 sentences only)
13. Why are steel bridges not electroplated, whereas jewelry and cutlery are electroplated?