32. Find the rate of change of depth of water in a rectangular channel of 10 m wide and 1.5 m deep, when the water is flowing with the velocity of 1 m/s. The flow of water through the channel of bed slope 1 in 4000, is regulated in such a way that the energy line is having a slope of 1 in 4000

Q: 7. Two reservoirs L & H have elevations of 265 m and 110 m respectively. It is connected by a 25 mm…

A: Apply Bernoullis theorem PLγw+vL22g+zL=PHγw+vH22g+zH+HP+HLHead loss using hazen williams…

Q: Water (P =1000 kg/m , p=1.59x108 kg /m.s) is flowing with the velocity of 0.25 m/s through a smooth…

A: i. Given data-

Q: a. The velocity before the jump b. The depth after the jump c. The velocity after the jump d. The…

A:

Q: A small turbine is run by water from a reservoir, as shown. Both the pipe leading to and away from…

A: Given data:  Diameter of the pipe, D= 0.6 ft Velocity, V=10 ftsec The volume flow rate from the…

Q: A commercial solvent at 20°C flows from tank A to tank B through 152 m of new 150-mm asphalt-dipped…

A: We have to solve for value of flow in system.

Q: A centrifugal water pump is tested under its design flow rate Q=250 m/hr. The static pressure at the…

A: Given Discharge   Q=250 m3/hr=0.0694  m3/secpressure  P1=1.2 bar=120 KPaand at outlet end   P2=8.5…

Q: Water at 4°C enters a tank of diameter Dr = 50 cm at a constant mass flow rate of min= 1 kg/s. An…

A:

Q: Q:- Find the forces exerted by water on a Im width of The surface of the dam shown in figure and the…

A:

Q: reynolds number b.) total head lossv(m) c.) gage pressure at 1

A: Gauge pressure: - It is defined as the extra pressure to a system with respect to local atmospheric…

Q: An orifice (Ao = 0.005 m², cv = 0.92) is installed at the horizontal face of a tank as shown in the…

A: Cv = 0.92 Ao = 0.005 m² H = 8.5 m

Q: m Water is flowing through a horizontal pipe of diameter 150mm at a velocity of 2-. A circular solid…

A: Given:Pipe diameter, D = 150 mm = 0.15 mVelocity of flow, V = 2 m/sDiameter of solid plate, d = 120…

Q: A water stream flows into a tank with a diameter of 0.2 m at a flow rate to maintain the water level…

A:

Q: 10.70 A water turbine is connected to a reservoir as shown. The flow rate in this system is 4 cfs.…

A: The flow through the pipe, Q = 4 cfsThe diameter of the tube, d = 12 in = 1 ftThe efficiency of the…

Q: Consider the velocity field given by u = and v =- 2xy. Find the circulation around an area bounded…

A:

Q: A channel of rectangular section, 9ft wide, is discharging water at a rate of 71034gal/min with an…

A: "Hi! Thank you for the question, As per the honor code, we are allowed to answer three sub-parts at…

Q: Consider flow from a water reservoir through a circular hole of diameter D = 0.16m at the sidewall…

A: Given data Diameter of hole D = 0.16m Vertical distance of sidewall from free surface = H = z1…

Q: A town with a population of 150000 people is supplied with water through a pipeline from a reservoir…

A:

Q: Water flows over the overflow structure shown in the figure below. Upstream the depth is 6.00 m and…

A: Upstream depth is Speed of liquid is The top surface of liquid is at atmospheric…

Q: The flow through a rectangular channel (width in x and height in z) is nonuniform with a velocit…

A: We have to determine the expression for flow rate and average velocity using contants and we have to…

Q: A water reservoir of 300 (Height) x 300 (width) x 500 (depth) m has its free surface at 250 m above…

A: Height of reservoir = 300m Width = 300m Depth = 500m Dia of orifice = 500mm Coefficient of…

Q: The head of water over an orifice of diameter 100 mm is 10 m. The water coming out from orifice is…

A:

Q: The flow through a rectangular channel (width in x and height in z) is nonuniform with a velocity…

A:

Q: A channel of rectangular section, 9ft wide, is discharging water at a rate of 71034gal/min with an…

A: NOTE - Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the…

Q: Q3 hydraulic jump, as in below figure. If yı=1 m and ys-40 cm, estimate a) V1, V3 b) the bump height…

A:

Q: 7. For the Pitot Tube below, determine the height that the fluid rises, L, in the column if water is…

A: Velocity of flow through pitot tube is given and it has been asked to determine height of fluid…

Q: Example 6.9 Consider the velocity field given by u = and v = - 2xy. Find the circulation around an…

A: solutIon                                          Now, we have to find circulation along the area…

Q: pipe, and D is the diameter of the pipe. If the pipe diameter is 20 cm and the rate of flow is 0.06…

A: First we will find the headloss at L=2000m The formula for headloss is 0.02LDV22g where L=2000m…

Q: 3.53 The water flows fully through the rectangular channel of lateral dimensions 4 m x 3 m. What is…

A: given- Rectangular channel-dimension=4 m×3 mslope S=0.0006Chezy's constant C=90

Q: through a pipe at 150 gradually in diameter from 165 mm at point M to 473 mm Water flows L/s that…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.