31. A 200- ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in a parallel across a 120- V, 60-Hz AC line. Calculate the following: a. Resistor current b. inductor current C. capacitor current

31. A 200- ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in a parallel across a 120- V, 60-Hz AC line. Calculate the following: a. Resistor current b. inductor current C. capacitor current

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: A circuit contains a diode in series with a 500 Ohm resistor. The diode is oriented to all current…

A: Given data: The resistance, R=500 Ω

Q: Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and…

A: A limiter circuit should be designed that limits a 20 V rms sinusoidal voltage to a maximum positive…

Q: A.An iron core 0.4m long and 5 cm2. In cross section, is wound with 300 turns. When a current of 0.5…

A: In this question , we will find inductance of iron core coil with given length , area ,…

Q: An inductor of value 5.6 H is connected across 240 V, 109 Hz supply. Then the value of inductive…

Q: For the capacitor circuit in Figure 1 a. Determine the time constant of the circuit. b. Write the…

Q: This is an electrical engineering question. It belongs to microelectronics and material processes.

A: In MOS devices, usage of the polysilicon as a gate electrode is a significant development in MOS…

Q: 400 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is…

A: DC-DC Converter: It will transfer the DC power from one circuit to another circuit at the required…

Q: Each of the conductor in a parallel-plate capacitor is called a. dielectric b. insulator c. plates…

A: Parallel Plate capacitors:- It is an arrangement of two conducting plates of equal dimensions are…

Q: ohm resistor in series with a 7.96 milliHenry inductor is connected across a 110-V 60-Hz and (c)…

Q: The diode (blue line) should be at -10V not -8V

A: The Diode-based circuit can be designed in LTspice by selecting the general diode and changing the…

Q: the non-inductive resistance of kelvin double bridge are set at 1000 each, the standard resistance…

A: Kelvin double bridge it's used to measure low resistance. Resistance R= 1000 ohm Standard…

Q: Please answer it clear and complete solutions. Thank you.

Q: what is the use of DC/DC tension converter DC/DC booster MT3608

A: Types of mostly used DC DC Converter Step up Converter ( Boost converter) Step Down Converter (…

Q: 5. An iron core 0.4m long and 5 cm?. In cross section, is wound with 300 turns. Wh current of 0.5 A…

Q: We want to investigate how the field strength will be with air as dielectric and with steatite. A…

A: Parallel plate capacitor, Line voltage, VL=24 kV. Area of parallel plate A=1 m2. Distance between…

Q: Which of the following answers best describes discontinuous conduction mode? A. The inductor voltage…

A: Given: Discontinuous conduction mode To find: Suitable option that best describes discontinuous…

Q: In the experiment set-up, what is the Inductance in the given AC supply R-1500 O a. 0.9 Henry O b.…

Q: Q9 / What are the function of brushes , pole and commutator in DC machine

Q: An air core toroidal coil has 120 turns, the length is 12 cm and 12 sq. cm in area What is the…

Q: In half wave rectifier with filter, if the capacitance is increased, the ripple factor increases.…

A: Choose the correct option In the half wave Rectifier with fliter, If the capacitance value increase…

Q: 2. A burst controlled triac is feeding a 200 ohm resistive load. The AC supply providing 240 V rms…

Q: Design a DC power supply using FWR to perform the following requirements. Find V_dc, V_rms,…

Q: The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 10…

A: From the CRO basics...

Q: Each terminal of a small polarity-independent incandescent bulb is connected to the positive…

A: According to the statement, the circuit will be such as The brightness of the bulb is directly…

Q: An iron core 0.4 m long and 5 cm2 is wound with 300 turns. When a current of 0.5A flows in the coil,…

Q: Where is electrical energy stored in an inductor? O In the electric field surrounding its coils. O…

A: Inductor stores energy in the form magnetic field. Inductor does not stores electrical energy. The…

Q: The ohmic resistance of a large magnetic contactor is measured to be 20 ohms. A 230 V 60 Hz is…

A: Given that, VS=230 volt , 60 HzL=?R=20Ωi(t)=3.2 A As per the given terms, the circuit is like:

Q: The three-phase circuit shown in figure 1 is 220 Vrms per phase and 50Hz. Diodes are real. The…

A: Given Three phase bridge rectifier circuit with R load Input voltage =220 V rms frequency = 50 Hz…

Q: inductance of 2 henrys and a resistance of 10 ohms are connected in series with an emf of E volts.…

Q: These question from electronics two course

Q: The waveform displayed on an oscilloscope is as shown in Figure The 'time/cm' switch is set to 2…

A: CRO waveform

Question

31. A 200- ohm resistor, 130 millihenry inductor, and a 66 microfarad are placed in a parallel across a 120-
V, 60-Hz AC line. Calculate the following:
a. Resistor current
b. inductor current
C. capacitor current

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Alternating Current (AC) Series Motor and Universal Motor

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

quick please
Discuss the difference between Alternating Current (AC) and Direct Current (DC)
Number 9 Please show your detailed solution. Number 9 Please show you detailed solution. A 50-ohm resistor is in series with a 40-?F capacitor across a constant potential source of 180 volts. Determine frequency that will give current of 3.13 amp. A. 250 Hz C. 160 Hz B. 200 Hz D. 140 Hz
We want to investigate how the field strength will be with air as dielectric and with steatite. A plate capacitor is placed in a 24 kV network between phase and ground. The relative permittivity of air is &=1 and for steatite &-6. The plate capacitor has area = 1m². The distance between the electrodes is 2 mm. Ep = 8.854-10-12 F/m A=1m² d=2mm a) Calculate the maximum field strength in the plate capacitor. (Answer: 9.8kV/mm) b) What is the capacitance of the capacitor if we use steatite? (Answer: C = 26.6nF)
Question- A solar cell of 350 V is feeding power to an ac supply of 440 V, 50 Hz through a 3-phase fully controlled bridge converter. A large inductance is connected in the dc circuit to maintain the dc current at 20 A. If the solar cell resistance is 0.5 Q, then find the period for which each thyristor be reverse based.
Please answer it clear and complete solutions. Thank you.
A resistor and a capacitor are connected in series across a supply of 250 Volts. When the supply frequency is 50 hz and the current in the circuit is 5 A. When the supply frequency is 60 hz, the current is 5.8 A. find C.
400 V is the input voltage given to a chopper, the required output is 650 V. The thyristor is conducting 300 usec. what is the addition of conducting and non conducting period? (Write your answer in usec) Answer:
A 2-diode power supply has transformer turns ratio of 5:1. What capacitance would be required to maintain 19-V minimum voltage across 100 ohm load? A 110V, 60Hz source is used.
How temperature effect conductivity? Explain with the help of following equation. m e'n7'
A coil has a resistance of 18 when it mean temp is from 20o C to 50o C. Find its mean temp rise when its resistance is 21 and the surrounding temp is 15o C. A potential difference of 250 V is applied to a copper field coil at a temp of 15o C and the current is 5A. What will be the mean temp of the coil when the current has fallen to 3.91 A, the applied voltage being the same as before.
Calculate the voltage across the capacitor in the circuit in the figure and plot the charging curve on the graph.