Answered: 300 0ml of a00s at 100atm and 27°C…

Science

Chemistry

300 0ml of a00s at 100atm and 27°C would require what temperature to change to 1.00L and

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter1: Chemical Foundations

Section: Chapter Questions

Problem 1RQ: Define and explain the differences between the following terms. a. law and theory b. theory and...

See similar textbooks

Related questions

Q: The volume of an automobile tire is 2.5 * 10 ^ - 2 * m ^ 3 pressure of the air in the tire is 2.5…

Q: 12.A sample of Nitrogen occupies 95.0 mL at 32.0 oC. Calculate the final volume when the temperature…

A: The volume and the temperature of a gas is directly proportional to each other when pressure of the…

Q: Calculate the original volume of a gas at STP if the new volume is equal to 6301 at 301 K and 125…

A: Given that the new volume of gas = 630 L temperature of gas =301 K pressure of gas =125 kPa…

Q: A Gas gas collected 0.97atm and 340 K. What will the temperature be at standard pressure?

A: Gay-Lussac’s Law: According to Gay-Lussac’s law, if we increase the temperature of the ideal gas the…

Q: Convert the volume to the new conditions. 2345.0 cm3 at 15.0 C and 104 kPa to 20.0 C and 41.0 kPa.

Q: (6) Using the following diagram to determine the atmospheric pressure (cm Hg): S0 cm

A: The given diagram is simple barometer. It is used to measure the atmospheric pressure.

Q: A shop-vac is capable of pulling in the air at a rate of 210 ft³/min. What is the rate of the…

A: The correct answer is given below

Q: A sample of krypton gas occupies a volume of 9.46 L at 58.0°C and 1.07 atm. If it is desired to…

Q: d. If 464mL of an ideal gas is at 27°C and 1.05atm, what will be new volume at STP? Gas Law: Solve…

A: d. Given: The initial volume, V1= 464 mL The initial temperature, T1=27 + 273=300 K The initial…

Q: Consider one mole of a real gas at 330 K packed into a container of 9.7 liters that obeys the van…

Q: A quantity of COCO gas occupies a volume of 0.32 LL at 1.9 atmatm and 303 KK . The pressure of the…

A: Ideal gas equation is given as: Where, P = Pressure of the gas; V = Volume of the gas; n = Number of…

Q: A container of a gas is at 25°C and 270kPa. If it can withstand a pressure of 1000 kPa, at what…

A: At constant volume pressure of gas is directly proportional to temperature

Q: 1. The pressure on 2.50L of an enclosed gas changes from 105kPa to 40.5kPa. If the temperature…

A: Given: The initial volume of the gas, (V1)=2.5 L. The initial pressure of the gas, (P1)=150 kPa. The…

Q: How many moles of carbon dioxide are in a 4,704 mL container at 489.2 kPa and 25°C?

A: Given data contains, Volume of container is 4704 mL=4.704 L Pressure is 489.2 kPa=4.8280 atm…

Q: use principles of the Kinette molecular Theory to respond to the quation below. slove all sub parts.…

A: a.

Q: A cooled tire has a volume of 34.9 Lat -10.94°C and 183.09 kPag. If the pressure and temperature are…

A: Initial volume of tire = V1 = 34.9 Litre Initial temperature of tire= T1 = -10.94°C = 273.15 -…

Q: 2. A 20. m long gas pipeline made out of Schedule 40. PVC pipe that is 2.66 cm in diameter is used…

A: We will use the ideal gas equation to determine the maximum number of moles of butane that the pipe…

Q: Estimate the percentage difference between the van der Waals and perfect gas calculations for carbon…

A: The Gibbs free energy change is equal to the maximum amount of a work a system can do.

Q: Gas Laws (3) O a. State Boyles Law - for a fexced mass of gas at constant Temperature Volume vanes…

A: Boyle's Law states that for a fixed mass of gas at constant temperature, the volume of the gas is…

Q: 1. By What factor does the pressure of an ideal gas Change when the number of moles is constant the…

A: For an ideal gas when number of mols are constant: P1V1T2 = P2V2T1 Where, P1 = initial pressure; P2…

Q: 1) A lungful of air (337 cm3 ) is exhaled into a machine that measures lung capacity. If the air is…

A: 1) As per the given data we haveP1=1.88atm P2=0.958atmT1=42.10C(315.25K)…

Q: The volume of 470 mL of gas at 23°C is decreased to 250 mL at constant pressure. What is the final…

A: Given:Initial volume, V1= 470mLinitial temperature, T1= 23∘C = (273+ 23)K…

Q: A N2 gas is pumped into a container with 39.6 L volume at 298.15 K and the final pressure reads 15.3…

Q: 9. A cylinder is fitted with a moveable piston. A gas in the cylinder is heated up. If the pressure…

A: Volume of the cylinder is also increases slightly along with the pressure when a gas in the cylinder…

Q: What is the new volume?

A: Given :- initial volume = 130 cm3 initial temperature = 27°C final temperature = 35°C To…

Q: A gas system has initial volume and temperature of 1590ml and 372.2K. If the temperature changes to…

Q: (ii) Calculate the fraction of oxygen molecules moving with a speed between 700 ms" and 710 ms' at…

A: Hello. Since your question has multiple parts, we will solve the first question for you. If you want…

Q: Q6 Two hundred Ibm of carbon dioxide is to be charged into a small metal cylinder at 25 °C at a…

A: Given data, Mass of CO2 (M)= 200 lbm = 90.7184 kg [1 lbm(pound) = 0.453592 kg]…

Q: A gas has a volume of 2.88 L at 4.4oC and 126.9 kPa. At what temperature would the gas occupy 1.4 L…

Q: Wine goes bad soon after opening because the ethanol (CH,CH,OH) in it reacts with oxygen gas (0,)…

A: Hey, since there are multiple questions posted, we will answer first question. If you want any…

Q: A 250 cm³ container filled with argon at 273 K and 101.3 kPa weighed 48.30 g. Filled at 303 K and…

A: Ideal gas Law: The equation that relates the pressure (P), temperature (T), Volume (V) and moles (n)…

Q: Ammonia is produced industrially by reacting N2 with H2 at elevated pressure and temperature in the…

Q: 6. a) What would be the expected temperature of a .75mg sample of H2 gas compressed to real gas…

Q: desired Mg mass =0.0340g "Atmospheric pressure (mmHg): 733.59 Trial 1 and Trial 2 values separated…

A: Given, Desired Mass of Mg = 0.0340 g

Q: The gas left in a used aerosol can is at a pressure of 199.5 kPa at 292.9K. If the can is thrown…

A: Here temperature and pressure are given , so we use Gay-Lussac's law which give relation between…

Q: A gas occupies a volume of 2.0 m^3 when at a pressure of 100 kPa and a temperature of 120°C.…

A: Given, Initially Pressure (P1) = 100 kPa Volume (V1) = 2.0 m3 Temperature (T1) = 120°C = (120 +…

Q: The ammonia contained in a container measuring rectangular tank 1m x 700 cm x 3000 mm if the…

A: Formula use: pV = nRT V = volume n= moles of gas R= gas constant = 8.3144 × 10−2 L⋅bar⋅K−1⋅mol−1 T=…

Q: mpressed to 3 cu.m, what is the resulti ssure assuming isothermal condition= a abs? (UP TO THREE…

A: Given, V1 = 8 cu.m V2 = 3 cu.m P1 = 200 kPa

Q: 1 1 1 1 1 A Trial 1 Trial 2 Trial 3 Trial 4 Trial 5 B C Total Pressure (kPa) Air Pressure (kPa)…

A: The Clausius-Clapeyron equation is used to find out the enthalpy of vaporization from the graph…

Q: [3] Two ships leave port at the same time and one travels S27°W at the rate of 20mph and the other…

A: Direction is usually measured relative to the location of North or South Pole. Directions determined…

Q: Initial-1 Final-2 Volume Pressure Temperature Volume Pressure Temperature P1 P2 ?°C ST °C K=°C+273…

A: According to the combined gas law,

Q: scuba diver’s compressed air tank is filled with an air mixture that has an oxygen partial pressure…

Q: .Initial Pressure = 95 kPa, Initial Volume = 4.0 L, Final Pressure = 101 kPa, Final Volume = 6.0 L…

A: given, Initial Pressure = 95 kPa, Initial Volume = 4.0 L, Final Pressure = 101 kPa, Final Volume =…

Concept explainers

Kinetic-Theory of Gases

Kinetic theory of gases is the model or method which was developed in the 19th century by Maxwell and Boltzmann. This is possible as the interatomic force which is of short-range forces that are important for solids and liquids can be neglected for gases. This theory or gas law gives a molecular interpretation of the pressure and temperature of a gas and is consistent with gas laws and Avogadro’s hypothesis. This theory is very helpful to correctly explain the specific heat capacities of many gases, kinetic energy and it also explains the transport qualities such as viscosity, thermal conductivity, and diffusion with molecular parameters. As stated in the kinetic-molecular theory, the temperature of a substance or gas particle is related to the average kinetic energy of the particles of that substance. When a substance is heated, some of the absorbed energy is stored within the particles, while some of the energy increases the motion of the particles, called average kinetic energy.

Question

100%

A sample of nitrogen is collected by water displacement at 730.0 mm Hg and 20°C. What is the
partial pressure of the nitrogen?
300.0mL of a gas at 1.00atm and 27°C would require what temperature to change to 1.00L and
0.500atm?
What is the pressure exerted by 1.2mol of a gas at 20°C and 9.5L?
Label the axes, states of matter and triple point on the following phase diagram.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Q2\ Estimate weight of one moles of Argon gas in round flask by applied atmospheric pressure 80 cmlg and temperature is 40 C" If the density for that inert gas is 0.09 gm.lem
Calculate the fraction of N2 molecules that have speeds in the range 320 to 332 ms-1. The temperature is 380K. Please enter a number round to 3 decimal places.
Torricelli, who invented the barometer, used mercury inits construction because mercury has a very high density,which makes it possible to make a more compact barometerthan one based on a less dense fluid. Calculate the densityof mercury using the observation that the column of mercury is 760 mm high when the atmospheric pressure is1.01 x 105 Pa. Assume the tube containing the mercury isa cylinder with a constant cross-sectional area.
Please help with 2(d)
For 1 mol O2 ideal gas at 290K and 0.9atm, calculate its volume in L, and ml.
A gas occupies a volume of 240 ml at 65°C and 297 kPa. What is the volume of the gas at STP? Show your work. Include units on your answer. (STP is standard temperature and pressure. Standard temperature is 273 K and 101.3 kPa.)
A 1.18 Liter sample of gas initially at 25°C is heated to 100°C at fixed pressure. What is its final volume?
H4. A zinc pot (coefficient of linear expansion : ) is filled with mercury at 100 °C, then having a 10.0 L capacity. Cools down to 0°C. Calculate the mass of mercury, measured at °C, that must be added so that the vessel is completely full (coefficient of volumetric expansion of mercury: ). Density of mercury at 0 °C; 13.6g/cm3.
I put the answer for 1(a)(i), need the answer for 1(a)(ii).
On a calm day in Los Angeles the pressure and temperature at sea level are 101.325 kPa and 20 °C. Find the pressure at a point 2500 m above sea level where the temperature is –1.1°C. 1.
, Dipropyl ether and dimethyl ether exist as a mixed ideal gas at a common 1) ( temperature. Let Vị = the most probable velocity for dipropyl ether. Let V2 = the most probable velocity for dimethyl ether. Calculate Vi / V2.
Initial Pressure = 125 kPa, Initial Volume = 125 mL, Final Pressure = 100. kPa, Final Volume = 100. mL and Final Temperature = 75.0oC. Solve for Initial Temperature. Answer: Unit: Blank 1: Blank 2: