30 A barge is pulled by two tugboats. If the resultant of the forces exerted by the tugboats is 5000 lbf directed along the axis of the barge, determine a) the tension in each of the ropes for a = 45°, %3D b) the value of a for which the tension in rope 2 is a minimum. 2007 The

Q: Force P is supported by two cables and a bar. Point A lies in the yz plane, and points B and C lie…

A:

Q: Required information NOTE: This is a multi-part question. Once an answer is submitted, you will be…

A:

Q: 1. Figure Q1 shows an illustration of a bell crank mechanism that is in a state of static…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Two tension forces are applied to the top of the tower as show wire is also attached to the top of…

A: Given data is We have to find the Tension in the wire AB such that the resultant force is only in…

Q: It is desired to remove the spike from the timber by applying force along its horizontal axis. An…

A:

Q: Q1.) A cable system is subjected to three concentrated loads as shown. The sag at point D is…

A: To Find:The sags and .The section of cable supports the largest tension and the magnitude.Given:A…

Q: When a system is taken from state a to state b in the diagram below along the path acb, 90.0 J of…

A: Givenfor acbDQ=90JdW=60Jwe know thatdQ=dU+dWdUa→b=90-60=30J

Q: A barge is pulled by two tugboats. If the tension force in the rope TAB and TBC is 3500 Ibs and 2500…

A: Given:TAB=3500 lbTBC=2500 lb

Q: Cables AC and BC are attached to points A and B respectively as shown. These two cables are then…

A: Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the following…

Q: 3) Find the forces developed in beams FE, CE, and CD. State whether they're in tension or…

A:

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.