#3.Assuming that vs = 8 cos(2t - 40º) V in the circuit of Fig. 1, find the average power delivered to each of the passive elements. Could you show all work step by step #3.Assuming that vs = 8 cos(2t - 40°) V in the circuit of Fig. 1, find the average power delivered toeach of the passive elements.Vs192202wwwww3 H0.25 FFigure 1: Figure for #3

Step 1:Step 2:Step 3:Step 4:Final answers: (note if a polar form is given as: r∠θThen it's magnitude…

Answered: #3.Assuming that vs = 8 cos(2t - 40°) V…

#3.Assuming that vs = 8 cos(2t - 40°) V in the circuit of Fig. 1, find the average power delivered to each of the passive elements. Vs 192 202 ww www 3 H 0.25 F Figure 1: Figure for #3

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: i) ii) iii) The complex power of each load; Load 1, Load 2, Load 3 and Load 4. The total complex…

Q: j16 Ω 8 Ω 10 Ω 2Ω ww -j5 Ω Figure 1 -j4Ω Vs rms

Q: Vs(t)=12cos2500t V, Is(t)=0.5 cos(2500t-30) A. 50 4 mH 4 mH ll E80 F (140) 3102 ll

A: We will solve this problem using nodal analysis method. Both the Voltage and current source have…

Q: 4. A certain load takes 10 kw at 75% pf. In the power contract, the pf penalty is applied only to…

Q: Three identical coils, each of resistor 10ohm and inductor 20ohm are connected in star to a phase…

A: Given, Three identical coils, each of resistor 10 Ω and inductive reactance 20 Ω are connected in…

Q: Q.24: The non-sinusoidal voltage er(t)=100+50sin300t- 20cos1800t Volt is applied to the circuit…

Q: A load consists of R=78 Q, XL=71 Q and Xc=47 Q. All the elements are connected in parallel across…

Q: If the power factor is 1/10 and the value of impedance is 20 ohm, calculate the resistance in the…

Q: A three-phase motor is delta connected to a 415 V, 60 Hz line. If the line current is 25 A and the…

A: Line voltage is given, Line current is given, Power factor before correction is , Frequency,

Q: 10. Find I, and I2 in the following circuit. What is the average power absorbed by ALL elements in…

A: Given data The reactance for the inductive element is XL=j2 Ω. The reactance for the capacitive…

Q: PROCEDURE A: demonstrate that the effective or rms value of alternating current is equivalent in…

Q: I need help with this problem and an explanation for the solution described below. (Electric…

A: Given: Vs(t)=20cos(5t)R=5ΩL=1.2HC=0.2F Step 1: Identify Relevant Equations In AC circuits, the…

Q: In a circuit having pf = 0.85 which is connected to 240V, 60Hz supply. If the load consume a power…

A: Given, Power factor = 0.85 Supply voltage (Vs) =240 V Frequency (f) =60 Hz Load consumes real…

Q: 6. A parallel circuit of 25 - ohm resistor, 64 – mH inductor and 80 - pF capacitor connected across…

A: In this question, We need to determine the current in the each element and total current?

Q: similar coils, connect of 3 kW, at a power-f. 400 V, 50 Hertz (Hz) ance of each coil in oh h coil in…

Q: A 1302 resistor and a 30μF capacitor are connected in parallel across a 200V, 50 Hz supply.…

Q: i need help

A: PF = 0.972, Leading Explanation:To compute for power factor, you could compute for the equivalent…

Q: Power Quality: Ensuring that the voltage and frequency of the power supplied to customers is of good…

A: We need to explain affect in power quality over next 100 years

Q: 3 For the circuit shown in the Figure, if Vs= 30 Vrms and RD 540 Q, answer the following two…

Q: -j2 N 1:2 j30 N 60 Ω 100/0° v ( ± 4Ω Ideal ell ll

A: Given Find the power absorb by 4 ohm resistances

Q: The constant of a 0.8 pf 2300V 60 hz 16 pole 3-phase wye connected 800Hp SM are as follows: leakage…

Q: Analyze the following AC networks, define and calculate all voltages, resistances (if necessary) and…

A: Given Here a,b,c,d forms star then we use star to delta connection

Q: A plant has a load of 290 kilowatt with an average power factor of 70 % lagging. The owner request…

A: From given values find the reactive power without capacitor and with capacitor and difference is the…

Q: Three identical coils, each of resistor 6ohm and inductor 12ohm are connected in star to a phase…

A: Given, Resistance, R = 6 ohm Inductance, L = 12 ohm Phase voltage, Vph = 220 V

Q: A 50 mH inductance is connected in series with a 20 ohm resistor. If the voltage is 220 volts, what…

A: Given data, In series RL circuit, Inductance, L=50 mH. Resistance, R=20 Ω. Voltage, V=220 V.

Q: In the given circuit, find the following: a. b. voltage magnitude across the load in volts voltage…

Q: Find the complex power delivered by the voltage source if R₁ = 5 2, R₂ = 1802, L = 2H and…

A: Introduction Complex power: Complex power is a mathematical concept used in electrical engineering…

Q: A 30 2 non-reactive resistor is connected in series with a coil of inductance 100 mH and negligible…

Q: In the circuit shown below, find the average power dissipated by the resistors. Additionally, find…

A: In this question, We need to determine the choose the correct options Compex power S= VI* = P+jQ…

Q: A 50-ohm resistance and an 80-μF capacitor are connected in series across 115-V 60-Hz mains.…

Q: What is the apparent power given by a source that, in a circuit, feeds 525 V at 50 Hz to a resistor…

A: here we have to find the apparent power of the circuit.

Q: 4. An alternating voltage single-phase power supply generates a sinuse a) Calculate the Vpeak. b)…

Q: V (v) 15 10 20 t (ms) 80° -15 Figure Q2(a): Two voltage signals. Based on this figure: (i) State the…

Q: In a two wattmeter method of power measurement, If the wattmeter reads P1 and P2, then the active…

A: Given Wattmeter reading P1 and P2 value Find active power

Q: For the circuit shown below, The maximum power supplied to the load resistor (Pmax)= 400 Watts and…

A: Given Data: Pmax = 400 W Rth = 35 ohm

Q: (d) The impedance in ohm of each coil. (Polar form) (e) The value of the resistance in ohm of each…

Q: 2. A sinusoidal alternating current of 3 amps is flowing through a resistance of 302. Calculate the…

A: To find the average voltage and the peak voltage of the supply.

Q: a) A p.d. of 200Z 30° V is applied to two branches connected in parallel. The currents in the…

A: Since there are many problems attached, as per the guidelines, the solution to the first problem (a)…

Question

#3.Assuming that vs = 8 cos(2t - 40º) V in the circuit of Fig. 1, find the average power delivered to each of the passive elements. Could you show all work step by step

#3.Assuming that vs = 8 cos(2t - 40°) V in the circuit of Fig. 1, find the average power delivered to
each of the passive elements.
Vs
192
202
ww
www
3 H
0.25 F
Figure 1: Figure for #3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step by step

Solved in 2 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

1) An inductive circuit absorbs 200 W at a current of 5 A from the supply of 220 V, %0 Hz. Determine: a) The impedance of the resistance, reactance and impedance of the circuit. b) The power factor of the circuit.
#8. Determine the complex power for the following cases: (a) P = 269 W, Q = 150 VAR (capacitive) (b) Q = 2000 VAR, pf = 0.9 (leading) (c) S = 600 VA, Q = 450 VAR (inductive) (d) Vrms = 220 V, P = 1 kW, 1Z1 = 40 9 (inductive) Show all work problems
Listen An AC voltage represented by e= 170 sin377t volts is applied to a resistor resulting in a current represented by i= 5.88sin377t mA. The average power consumed by the resistor is: O a) 500 mW Ob) 1 mW cer
Q2) A three phase load (motor) draws 30 kW when connected to 440 V rms, 50 Hz line if the power factor is 0.85 lagging, Determine: a) The line current drawn by the motor. b) The KVAR rating of the three capacitors - connected in parallel with the motor that will raise the power factor to 0.95 lagging, and c) The capacitance of each capacitor.
For the circuit in Figure below, determine the power absorbed by the 4 Q resistor. Assume the 100 V is an rms value. -j2 N 1:2 j30 N all 60 Ω 100/0° V Ideal elee
What is rms value of current (I) and active power delivered by source.
The average power consumed by a typical kettle with a heating element that has a pure resistance of 10Ω is 1200W. Calculate: a) the RMS current drawn by the kettle b) the peak value of the current through the element
(ii) Three coils each having resistance 6 N and inductance are connected in star with 415V. If the line current is 30 A, find the value of inductive reactance as well as inductance value. If 0 45° then calculate the power dissipation in kW when it is connected in Delta.
An AC voltage source has an output of v = (220 V) sin 2TIt and connected to a 70resistor as shown in the figure. Therefore, the maximum current (Imax) in the circuit and the averagepower delivered to the circuit would be1. 3.14 A. 346 W2. 3.14 A. 249 W3. 2.22 A, 346 W4. 2.22 A. 690 W
Compute v1, v2 and the average power delivered to each resistor..
In the circuit in Fig. 3: a. Find the average power and the reactive power for each passive element and indicate whether the power is absorbed or delivered. b. Find the complex power, the average power and the reactive power for each source and indicate whether the average and reactive power is absorbed or delivered. -j5 n 240/0° V rms (+ 452 Fig. 3 +220/-30° V rms
7