Answered: 3.79 Differential pressure is being…

3.79 Differential pressure is being measured between points A and B in two pipes. In pascals, what is Ap = Pa - Pa? (a) – 490 (b) – 350 (c) –770 (d) -630 (e) – 530

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: Based on the provided differential-type manometer, calculate the difference in the pressure between…

A: To find :- the pressure difference between points A & B.

Q: difference in height between the two legs of 30 in. If the meter coefficient is equal to 0.975,…

A: ###Determination of Actual Discharge ###

Q: AIR WATER 4cm OIL MERCURY A manometer connects an oil pipeline and water pipeline as shown.…

Q: If the rate distribution of a viscous liquid (u= 0-eight Ns/m2) over a fixed boundary is given with…

Q: Q3/ Water flows through a pipe at 5 L/s, as shown in Fig. 12.5 kPa, 11.5 kPa, and 10.3 kPa are…

A: Given, P1 = 12.5 kPa P2 = 11.5 kPa P3 = 10.3 kPa Q = 5 L/s or 0.005 m3/s NOTE : As per guidelines,…

Q: System 1 System 2 30N 10N 30N 100N.m 30N 50 N System 1 and System 2 are two equivalent systems.…

Q: Q Calculates the Force acting on a (2m) square based in the Figure when Pressure gage reads (150…

A: Given:Gage pressure reading = 150kN/m2Required:Force acting on 2m square

Q: From the figure shown below. Find the gage pressure entrapped on the top of the oil and what is the…

Q: Driven by pressurized air in a tank, water flows through pipes (L1₁ = 40 m, L2 = 80 m, L3 = 20 m) of…

A: Given: A flow of water through pipe of length L1, L2 and L3 as shown in the figure Dynamic…

Q: 1 Gate AB is 2.0 m wide perpendicular to the paper and open to let fresh water out when the sea…

Q: . Determine the fluid speed at the origin (x=y=z=0) and on the y-axis (x=z=0)

Q: Water is flowing through a venturimeter shown. The difference in pressure between A (D = 5cm) and B…

A: Given data in question Diameter Head loss To find out Velocity head at A

Q: 2 A rectangular gate AB hinged at A has a width of 2.0 m perpendicular to the paper and has…

A: Given, b= 2m unit weight of water=9.80 kN/m3 To determine, Magnitude of hydrostatic force in kN.

Q: Q2) Several water pipes intersect at the junction box illustrated in Figure. Determine the force…

Q: Question-03: Water flows downward along a pipe (shown in fig) that is inclined at 30'. A…

A: Draw the setup of the manometer

Q: use three decimal places Derive hf with respect to Q of the following empirical equation below.…

A: For the Hazen William's formula - Given - V = 0.849 C R0.63 S0.54 As known - Q = VA here, Q =…

Q: O OO A B E The air-oil-water system is at 20°C. Knowing that gage A reads 15 lbf/in² (absolute) and…

Q: A rectangular gate AB hinged at A has a width 2.0 m perpendicular to the paper, has a negligible…

Q: FLUID FLOW IN PIPES I. Proving. SHOW THAT 7.05 = √5 + √5 8

A: Given and to prove,

Q: A Venturi meter, 12 in. by six in., is installed in a vertical pipeline carrying water. A…

A: The system given is :

Q: A differential manometer is attached to a pipe, as shown in the figure. Calculate the pressure…

Q: 3. From the figure as shown, how far will the block move down after three seconds. At t=0, v-0.

A: find distance after 3 sec

Q: determine the values of e,, p, and pM, 24 in. 27 in. 6 #11 bars $3 in.

A: The values and diagram given in the question are as follows Yield strength of steel(fy)=80000 psi or…

Q: Derive hf with respect to Q of the following empirical equation below. Consider that the circular…

A: Given data- Empirical equations are given- V=0.849 C R0.63 S0.54V=1/nR2/3S1/2 To Find- It is needed…

Q: Problem 6 The small washer is sliding down the cord OA. When it is at the midpoint, its speed is 28…

A: Given:- A washer is sliding down the cord OA At the midpoint, The speed of the washer = 28 m/s The…

Q: I can't figure out what I'm doing wrong. I placed the following formula for column B:…

A: The question is discussed above. We will try to discuss the basic solution with details what is…

Q: The surlace tension of water in contact with air at 20°C is given as 0.0716 N/m. The pressure inside…

A: Given data : Pressure intensity greater than outside temperature (p)=0.0147 N/cm2Surafce tension…

Q: For the flow indicated in the shown figure, which section is representing the Vena contracta? a…

A: Vena contracta is the location of the stream where cross section of stream is minimum and the…

Q: 1 60⁰ The water jet is ejected from the 4-in.-diameter pipe with a steady velocity of v = 19 ft/s.…

Q: 1. Cords are looped around a small spacer separating two cylinders each weighing 400 KN and pass…

A: Given values: Weight of pulley 1 = 200 KN Weight of pulley 2 = 400 KN Weight of 2 cylinders…

Q: Determine the change in the elevation of the currency in the left leg of the manometer as a result…

Q: Q4. As water flows through the pipes, it rises within the piezometers at A and B to heights ha = 1.5…

Q: 2) The above pipe is 2.4 feet long and twists over the whole length of the pipe, what is the angle…

Q: Find the total loss of head between A and F. in m

Q: The cylinder shown in the figure extends 8 ft into the paper. If the cylinder has the radius of 4…

A: Consider the free body diagram of given cylinder in oil as shown below. Radius of cylinder, R=4…

Concept explainers

Pressure and Stress

Question

3.79 Differential pressure is being measured between points A
and B in two pipes. In pascals, what is Ap = Pa - Pa?
(a) – 490 (b) – 350 (c) –770 (d) -630 (e) – 530
751
air
501
water
250
water
100
B
dimensions in mm
Problem 3.79

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A differential gauge was attached to a venturi meter. The deflection of mercury is 14.3 inches. Assume no headloss. Point B is located at the 6 inches diameter pipe. Point A is located at the 12 inches pipe. Determine the velocity at point A in ft/s. + 5inches 12 inches
For the differential manometer shown. (a.) Find the H (in inches) if pressures at A is 9psi and Bis 7psi.
Three wires are connected at point D, which is located 18 in. below the T-shaped pipe support ABC. Determine the tension in wire BD when a 257 Ib cylinder is suspended from point Das shown. Round off only on the final answer expressed in 3 decimals and indicate unit. 0024.png ... `24 in. В 16 in. ` 24 in. 22 in. A 18 in. D 180 lb
A vertical rectangular gate 2.2 m wide and 4.0 m high is submerged in oil (SG-0.87) with its bottom edge is 13.6 m below the water surface. Find the location of the center of pressure, measured from the liquid surface (in meters). Answer in two decimal places. Numerical values only. Don't indicate units here, just on the submitted solution. DOD F5 F6 F7 F8 F9 F10 F11 F12 5 6 7 8 P H
se in measuring a dis 00 ft when the temperature of the tape is 32°E? 11.7 An aluminum wire is stretched between two rigid supports. If the tensile stress in the wire is 5000 psi at 68°F, what is it at 32°F and 90°F? Assume that the proportional limit is 35,000 psi. 11:8 A 1-m-long-copper bar is placed between two rigid, unyield- ing 11. ich stelupe
Example 7: The figure below shows a complex manometer. Calculate: 1. The gauge pressure of the air in the tube (2943 N/m²). 2. The gauge pressure at A (20718.72 N/m²). 3. The absolute pressure at A if the atmospheric pressure is 105Nm2 (120718.72 N/m²). s.g.= 0.90 S.g.= 2.94 B Air 0.6m 0.3m D FU 0.8m Water Density of water = 1000 kg/m³.
An orifice (area = 0.035 ft^2) is placed at the bottom of a cylindrical (diam = 5.93 ft) container. Determine the time (minutes) required for the head to fall from 4.99 ft to 2.35 ft. Use Cc = 0.67, Cv = 0.93. Round of to two decimal places.
The cylindrical tank weights 500 lb. Determine (a) FH, (b) FV, (c) FR and (d) ϴx. Use 2 decimal places in every solved value.
An engineer used a 30 m tape in measuring an inclined ground 459.20 m long. The difference between the starting point and end point is 1.20 m. The tape is of standard length at a temperature of 100 C and a pull of 50 N. During measurement the temperature reading was 15 0 C and a pull of 75N applied at both ends. A= 6.5mm2 ; E = 200GPa; K = 0.0000116 m/C0 . The mass of the tape is 0.075kg/m. Determine the horizontal distance.
Given: 4 tank full of water and oil (Set 0.80), as shown. Find: The pressure at the oil water interface and the bottom of the tank. %3D 0.9 m Oil (S = 0.8) 0.9%o Water, T 10° C 2.1 m 2.14 0.9 2.
Water is flowing through a venturimeter shown. The difference in pressure between Point 1 (D = 4cm) and Point 2 (D = 2cm) is measured using open tubes. If h is 50cm, solve the volumetric flowrate. h 下 O 0.00110m^3/s O 0.00162m^3/s O 0.00254m^3/s O 0.00102m^3/s