Qno3 solve it Asap 1.The observed temperature when the lengthof tape is 50 m is 29.6 °C and a pull of15kilosDuring theISapplied.measurement,the temperature recorded is18.9 °C and the applied pull is 15 kilos.The base line is measured to be 1632.48m. Determine the correct length of the line.Use coefficient ofthermalexpansion,0.00001 16/°C.2.A 30 m steel tape standardized at 20°Cand supported throughout under a tensionof 5.45 kg was found to be 30.012 mlong. The tape had a cross sectional areaof 0.05 cm² and a weight of 0.03967kg/m. This tape was held horizontal,supported at the ends only, with aconstant tension of 9.09 kg, to measure aline from A to B in three segments. Thedata listed in the following table wererecorded.Segment Distance (m) Temp. (°C)A-130.0001430.0001521.15116Determine the correct length of line AB.1-22-B3.With the transit at point A and the line ofsight horizontal, the stadia intercept at Bwas found to be 1.94 m. If the stadiaconstant is 0.3 and AB 194.2 m, findthe stadia interval factor.=

NOTE- Question 3 has been asked to solve. stadia intercept at B, s=1.94 m stadia constant C=0.3…

Answered: 3. With the transit at point A and the…

3. With the transit at point A and the line of sight horizontal, the stadia intercept at B was found to be 1.94 m. If the stadia constant is 0.3 and AB 194.2 m, find the stadia interval factor.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: A car is traveling at speed v when the brakes are suddenly applied, causing a constant deceleration…

A: Hello dear this is the solution of your problem The answer is found to be Distance travelled by car…

Q: The 10-minute triangular unit hydrograph for a watershed has a peak discharge of 100 ft’/s at 40…

A: 10-minute triangular unit hydrograph peak discharge(Q)=100 ft3/s (occur at 40 minutes) Total…

Q: Typical units of strain are a. Inches and millimeters. b. Pound-inch, kip-inch, and…

A: Strain is produced when stress is applied . Stress is defined as the ratio of force per unit area .…

Q: A nozzle is so shaped that the average flow velocity changes linearly from 1.5 m/s at the beginning…

A: Given velocity- V1=1.5 m/s V2 =15 m/s Distance dx=0.375 m

Q: Determine the reactions at rigid supports A and B. A B →10 kN 1 m 2 m

A: Following is the given rod between two rigid supports:

Q: A nylon thread is subjected to a 10 N tension force. Knowing that E=3.3 GPa and that the length of…

A: Given data : Change in length Original length=2.1100Force (P)=10 KNE=3.3 GPa

Q: Illustration 6.2 Water containing dissolved air is to be deoxygenated by contact with nitrogen in an…

A: Z= 0.001 m MA =60.03, MB =18.02. At 17°C, The component subscript on XA indicates mole fraction A,…

Q: Two identical specimens, 4 cm in diameter and 8 cm high, of partly saturated compacted soil are test…

A: To find Angle of shearing resistance?

Q: A rectangular footing 1 m x 2 m is placed at a depth of 2 m in a saturated clay behaving an…

A: Given- Rectangular footing size 1 m×2 m, Depth=2 m, UCS=100 kN/m2, It is needed to find the net…

Q: A 0.9-m³ soil specimen weighs 17 kN and has a moisture content of 9%. The specific gravity of the…

A: Given Data Total volume of soil specimen (V) = 0.9 m3 Total weight of soil specimen (W) = 17 KN…

Q: Solve CE only

A: Support reaction : Due to symmetry AY=12×(2×(1.5+3+3)+3)=9 KN

Q: Calculate Poisson's Ratio for a steel that has a modulus of elasticity E of 30,000,000 psi and a…

A: The given data is: Modulus of elasticity, E=30000000 psi Modulus of rigidity, G=11500000 psi

Q: 1. Compute the magnitude of the designated quantities by using their corresponding influence lines.…

Q: 5. A child in a school crossing ran into the street and was struck by a car, despite the driver…

A: Skidding occurs when a vehicle's tires lose traction on the road. When your tires lose grip, you…

Q: Problem 1 Consider the one-dimensional flow on a sloped impermeable bed. By reference to the sketch…

Q: 15 kN/m 10 kN/m 8.00 2.00 4.00 10.00 3.00

A: UDL1=15 kN/mUDL2=10 kN/mPoint load 1 =50 kNPoint Load 2=40 kN

Q: Question 1 A sieve analysis of a soil sample gives the following results. particle size/mm mass of…

A: The given data is shown below: The total mass of the soil sample is 500g.

Q: What is the depth of available water in the root zone if the readily available water in the root…

A: Given data : Readily available water =10 cmRate of evaporation=1 cm/day1 week =7 daysStorm water=2…

Q: A field pumping test was conducted from an aquifer of sandy soil of 4 m thickness confined between…

Q: 1. Compute the magnitude of the designated quantities by using their corresponding influence lines.…

Q: QUESTION 1 Air at 80 °C flows slowly through a 500 mm circular galvanized steel duct. Determine the…

Q: a) A dead body was found within a closed room of a house where the temperature was a constant 70°F.…

Q: What is the Maximum Shear Stress, t, on the centric axially loaded member shown? The cross-sectional…

A: Given data : Axial load (P)=40 kipsCross sectional area (A)=2 in2

Q: SOLVE REMAINING THREE PARTS

A: Given:- The variation in the flow rate within the peak hour is given To determine:- iii) The peak…

Q: Interval 1630 to 1645 1645 to 1700 1700 to 1715 1715 to 1730 Total Northbound T 207 230 241 238 916…

A: g NB, TH = 33.2 sg NB, LT = 17.3 sCycle length, C = 125 sAs vehicle green for through movements is…

Q: A maso m is laumched with an chitial speod 4 00 ft 1sec. The launch oungle is e= so°. The landing…

A: Given V = 400 ft/sec angle made with horizontal = 500 landing area is 150 ft higher than the…

Q: What is the mean "flow of pollutant", QC, into the lake in grams/min? Show calculations. Since the…

A: Given data: flow rate Q = 4 m3/minmean μ' = 10gm/m2standard deviation σ' = 2gm/m3

Q: Assegnment Solve the problems below and insert your answers into the ackboard question set Do not…

A: Answer(4th) We are asked to use given load and Influence coefficients to determine the vertical…

Q: Resolve force F1 = 250 kN into components along the u and v axes and determine the magnitude of…

Q: Determine the magnitude of the resultant force and its direction, measured counterclockwise from the…

Q: (3) (4) 6 41 4#9 14" 3" L 14" 21" €3" 3" 4" 4#9 fó= 4ksi. Nwc Grade 60 steel, Tied Bars. & Mn = ?…

A: 3.

Q: A soil has a saturated density of 2120 kg/m3 and a porosity of 0.30. What is the dry density of the…

Q: A saturated soil mass has a total density 22 kN/m3 and a water content of 10%. The bulk density and…

A: Given data : Water content (w%)=10%Total density (γT)=22 KN/m3

Q: ■ Example: A rectangular loading as shown below. 300 cm 100 cm 100 cm 200 cm T q=20 kPa 200 cm R U…

Q: diagrams for beam and loading shown

A: Draw free body diagram Consider the summation of forces in the horizontal direction HH=0 Consider…

Q: 3.50. Annual floods for a stream have a normal frequency distribution. The 2-year flood is 40,000…

A: Floods are among Earth's generally normal and most disastrous regular dangers. A flood happens when…

Q: Probability of a 10 year flood to occur at least once in the next 4 years is (a) 25% (c) 50% (b) 35%…

Q: 3.24 A 30-m tape has a mass of 544 g and is sup- ported only at the ends with a force of 80 N. What…

A: Given data : Mass of tape between two support (m)=544 g Length of tape (L)=30 m Force (P)=80 N

Q: 0.12 A hydraulic structure is sized for a 50 year recurrence interval design discharge. What is the…

Q: An open tank hokls a liquid with a specific gravity of 1.2. (1) What is the density of the liquid in…

A: Given data : Specific gravity (G)=1.2Density of water (ρWater)=1000 kg/m3

Concept explainers

State Plane Coordinate Systems

The state plane coordinate system (SPCS or SPS) is a collection of 124 coordinate systems or geographic zones prepared for particular regions of the U.S. Every state consists of one or more than one state plane zone, the boundaries of which generally follow the county lines. Inside the U.S., there are 110 zones in total, 10 more zones in Alaska, 5 in Hawaii, and 1 for Puerto Rico and US Virgin islands. The system is extensively used for geospatial and geographic data assembling by the state and local governments.

Question

Qno3 solve it Asap

1.
The observed temperature when the length
of tape is 50 m is 29.6 °C and a pull of
15
kilos
During the
IS
applied.
measurement,
the temperature recorded is
18.9 °C and the applied pull is 15 kilos.
The base line is measured to be 1632.48
m. Determine the correct length of the line.
Use coefficient of
thermal
expansion,
0.00001 16/°C.
2.
A 30 m steel tape standardized at 20°C
and supported throughout under a tension
of 5.45 kg was found to be 30.012 m
long. The tape had a cross sectional area
of 0.05 cm² and a weight of 0.03967
kg/m. This tape was held horizontal,
supported at the ends only, with a
constant tension of 9.09 kg, to measure a
line from A to B in three segments. The
data listed in the following table were
recorded.
Segment Distance (m) Temp. (°C)
A-1
30.000
14
30.000
15
21.151
16
Determine the correct length of line AB.
1-2
2-B
3.
With the transit at point A and the line of
sight horizontal, the stadia intercept at B
was found to be 1.94 m. If the stadia
constant is 0.3 and AB 194.2 m, find
the stadia interval factor.
=

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given

VIEW

Step 2: Calculation-

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.