3.) The steam rate to a turbine for variable output is controlled by a throttle valve in the inlet line. Steam is supplied to the throttle valve at 1,700 kPa and 225°C. During a test run, the pressure at the turbine inlet is 1000 kPa, the exhaust steam at 10 kPa has a quality of 0.95, the steam flow rate is 0.5 kg/s, and the power output of the turbine is 180kW. (a) What are the heat losses from the turbine? (b) What would be the power output if the steam supplied to the throttle valve were expanded isentropically to the final pressure?

3.) The steam rate to a turbine for variable output is controlled by a throttle valve in the inlet line. Steam is supplied to the throttle valve at 1,700 kPa and 225°C. During a test run, the pressure at the turbine inlet is 1000 kPa, the exhaust steam at 10 kPa has a quality of 0.95, the steam flow rate is 0.5 kg/s, and the power output of the turbine is 180kW. (a) What are the heat losses from the turbine? (b) What would be the power output if the steam supplied to the throttle valve were expanded isentropically to the final pressure?

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Question 3 Consider the turbocharger of an internal combustion engine. The exhaust gases enter the turbine at 450°C at a rate of 0.02 kg/s and leave at 400°C. Air enters the compressor at70°C and 95 kPa at a rate of 0.018 kg/s and leaves at 135 kPa. The mechanical efficiency between the turbine and the compressor is 95 percent (5 percent of turbine work is lost duringits transmission to the compressor). Using air properties for the exhaust gases, determine:(a).The turbine power output, compressor power input, air temperature at the compressor exit,(b).The air temperature at the compressor for the case of isentropic process and isentropic efficiency of the compressor.
Not ai generated please show all steps
Steam is produced for an ideal turbine at a pressure of 3.0MPa. The condenser pressure is 2.0kPa. The heat added per kilogram is 2750kJ. Neglecting pump work, determine the thermal efficiency.
Q4/ Steam enters the turbine of a power plant operating on the Rankine cycle at 600 ℃ and exhausts at 30 kPa. Calculate the thermal efficiency of the cycle for boiler pressure of 10000 kPa?
A two stage compressor is used to compress 800 m3 /h of CO2 measured at 288K and 1 bar from its initial state of 0.5bar and 30k to a pressure of 1.5 bar with inter cooling to 300K. A compression efficiency of 85% may be assumed in each stage. Calculate the power required to run the compressor and the discharge temperature.
The initial pressure and temperature of air in an Otto cycle engine during compression are 90 kPa and 12°C. Determine the maximum pressure occurring in the cycle if the initial and final temperature during heat addition process are 350°C and 1250°C, and the compression ratio is 6. Please complete the answer for good feedback.?
2. A gas turbine that operates on Brayton cycle provides a furnace with hot pressurized gas through its exhaust at 220 kPa. The turbine produces only enough power as required by the compressor. The compressor has inlet conditions of 110 kPa and 300 K. The inlet condition of the turbine is 850°C. Determine the pressure ratio of the compressor. Draw the schematic diagram.
None