3. The load shown in Figure below consists of a resistance R in parallel with a capacitor of reactance The load is fed from a single-phase supply through a line of impedance 8:4 +jl1:2 2. The ms volta at the load terminal is 120 0 V ms, and the load is taking 20 kVA at 0.8 power factor leading. (a) Find the values of R and X. (b) Determine the supply voltage V www. 8.4 +j11.2 2 1200Z0 V R

Q: An inductive impedance Z₁ is connected in series with a 5 ohm resistance. When 50 V at 60 Hz is…

A:

Q: Given Zc-j309 , R₁ = 390 , RL = 6401 2 and a = 0.39, what is the magnitude of the source voltage Vs…

A:

Q: If a load is leading, which statement is NOT true? a. The load is capacitive. b. It’s reactive…

A: We are given a MCQ and we need to select the correct option out of four given option.

Q: 8. For this circuit, find the current I₁. A) 5.87 + j0.88 A B) 6.35 + j1.41 A C) -48 + j24 A D) 2.27…

A:

Q: Given Zc - j339 , R₁ = 414 , RL = 12420 2 and a=0.24, what is the magnitude of the source voltage Vs…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.