3. The hot resistance of an incandescent lamp is 10 ohms and the rated voltage is 50 V. Find the series resistance required to operate the lamp from an 80 V supply

Q: Current is being discussed. Technician A says that DC current is produced in a sine wave. Technician…

A: Ac current is alternating current which has both positive and negative values. Which means that AC…

Q: Correct me if i am wrong I have studied different formula formula for saturation current.

A: Both are correct.

Q: Give a detailed description of an expirment about 'D'Arsonval Meter Movement as DC ammeter'.Support…

A: D’Arsonval Meter Movement is used as DC ammeter, Ohmmeter, and voltmeter. It is a current sensing…

Q: what is the reason primary cells wear out?

A: In this question we discuss why primary cells wear out.

Q: IF THERE ARE UNKNOWN SEMICONDUCTORING MATERIAL HOW DO YOU IDENTIFY ITS TYPE (n, p OR intrinsic?

A: Intrinsic semiconductors have very low conductivity at the room temperature. Hence, extra charge…

Q: Trace the output of the network  if the input is a 30V triangle wave, repeat for a sine wave of 8V .…

A: In the circuit, 2 zener diode is connected to back to back. Draw the output waveform 1. f the input…

Q: Ferromagnetic materials have this characteristic.    A. A relative permeability slightly less than…

A: We are asked to identify characteristics of ferromagnetic materials from the given options.

Q: What will be the value of thermal voltage at 300 K temperature?

A: In this case, the value of the thermal voltage at 300 K temperature is to be determined.

Q: What are the basic parts of a battery? How do batteries generate electrical current?

A: Battery: It is a device that is used to store electrical energy. In this electrical energy is stored…

Q: Describe the traces you would see on an oscilloscope monitoring voltage changes across a resistance…

A:

Q: Notes on the verification of ohm's law by voltage method?

A: Current" typically refers to the flow of electric charge in a circuit. It is measured in Amperes (A)…

Q: Alternating current is __________. Select one: A. AN ALTERNATING FLOW OF ELECTRONS B. ELECTRONS…

A:

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.