3. Robert is pulling his red wagon forward with a force of 230N by holding the handle at a 60 degree angle. His twin is pushing the wagon with a force of 300N. Find the magnitude and the direction of the resultant force on the wagon.

3. Robert is pulling his red wagon forward with a force of 230N by holding the handle at a 60 degree angle. His twin is pushing the wagon with a force of 300N. Find the magnitude and the direction of the resultant force on the wagon.

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter4: Coplanar Equilibrium Analysis

Section: Chapter Questions

Problem 4.148P: Show that all diagonal members of the truss carry the same force, and find the magnitude of this...

See similar textbooks

Related questions

Q: Prob. 2.7-5. The hole in a hasp plate is punched out by a hy- draulic punch press similar to the one…

A: The required punch force is P = 8990.8 lbf.

Q: The man in Fig. 14-15a pushes on the 50-kg crate with a force of F = 150 N. Determine the power…

Q: Using the steam tables (for water), find the specified property data at the indicated states. In…

A: c) For p = 28 MPa and T = 520 °C: From the steam tables, we can look up the specific volume and…

Q: Give an example of concentrated force.

A: Whenever total magnitude of a force act on a single point then this type of loading on a beam is…

Q: Define the sideslip angle at the centre of gravity of a car. Then show that v+raj B11 = u-rt1/2…

A: Sideslip angle:The difference between the two directions of a vehicle moving and the direction the…

Q: 1. The hanging box is being pulled by two ropes T1 and T2 as shown below. T1 = 565 Newtons and T2 =…

Q: A 45° reducing bend in a horizontal plane, 0.59 m diameter upstream and 0.23 m diameter downstream…

A: The given values are - Q =0.46 m3/sd1=0.59 m , d2=0.23 mP1 =1.46 bar =146 kPa Assuming that the…

Q: Please answer all the parts from a -d complelty and clearly

Q: Determine the forces in members CG and GH of the symmetrically loaded truss. The forces are positive…

A: The freebody diagram of the body is shown below

Q: Determine the moment of inertia a uniform steel disk about an axis perpendicular to the disk and…

A: Given the density, thickness and radius of disk. Required: Moment of inertia about O.

Q: A particle moving along a straight line has an acceleration which varies according to position as…

Q: Define concentrated force.

A: A concentrated force acts along a single line in space. Concentrated forces are mathematical…

Q: Determine the average velocityof the particle during this time interval.

Q: 4) A vapor absorption refrigeration system receives heat from a geothermal well at 110°C at a rate…

Q: The 10-kg block shown in Fig. 14-6a rests on the smooth incline. If the spring is originally…

Q: A force F having a magnitude of 100 N acts along the diagonal of the parallelepiped. (Figure 1) Part…

A: Given Data: Magnitude of force F=100 N Moment MA=rB×F Moment MA=rC×F Coordinates of point A…

Q: What is the mass in grams and the weight in dynes ,gram force and in Newton of 12 oz salt? ma a. •…

A: Given that, Amount of salt, W=12 OZ salts Since, 1 OZ=28 gram=28 gHence,12 OZ=12×28 gram12 OZ=336…

Q: In the figure, a 3.50 g ice flake is released from the edge of a hemispherical bowl whose radius r…

A: Disclaimer: Since you have asked multiple questions, we will solve the first question for you. If…

Q: Determine the forces in members BC and CG. The forces are positive if in tension, negative if in…

Q: 18 Consider fully developed flow in a circular pipe with significant entrance effects. If the length…

Q: The platform P, shown in Fig. 14-12a, has negligible mass and is tied down so that the 0.4-m-long…

Q: R D.

Q: You have to do thermal analysis of a building near an arctic observatory, which has a footprint of…

A: Given: Dimension of footprint: 8-m x 12-m Height, h = 4-m Ambient temperature of air, T0=-15 C…

Q: Determine the unit vector normal to the plane when A and Bare equal to (10)i + (11)j (5)k and 9i-…

A: Given:To find:The unit vector normal to the plane.The unit vector normal to the plane.

Q: The 420-kg uniform beam is subjected to the three external loads shown. Compute the reactions at the…

Q: As shown in figure, a homogeneous 50-kg rigid block is suspended by the three springs whose lower…

Q: 3-Determine the magnitudes of the components of F = 800 N acting along and perpendicular to segment…

Q: Determine the gauge pressure at P in the figure below which shows a compound manometer. Take all…

A: GIVEN DATA- A MANOMETER GIVEN WE HAVE TO FIND GAUGE PRESSURE AT P

Q: 5) 400 m³/min of recirculated air at 20°C DBT and 10°C dew point temperature is to be mixed with 150…

Q: Air flowing horizontally at a speed of 100mph through a duct 4 sq.ft in cross-section. The duct…

Q: The left limb of a U-tube manometer is connected to a pipe conveying water, the level of mercury…

Q: Question 8 An element in plane stress from the frame of a racing car is oriented at a known angle as…

Q: Water flows through a horizontal pipe at a velocity of 50 fps. Owing to the pipe gradually banding…

Q: Differentiate enery and force

A: energy is defined as the amount of work that can be performed by force and units of the energy is…

Q: Determine the x-coordinate of the mass cen the tapered steel rod of length L where the dia at the…

A: GIven

Question

100%

With help of FBD.

3. Robert is pulling his red wagon forward with a force of 230N by holding the handle at a 60 degree
angle. His twin is pushing the wagon with a force of 300N. Find the magnitude and the direction of the
resultant force on the wagon.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 5 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the forces Q1,Q2, and Q3 so that the two forces systems are equivalent.
The magnitude of the force F is 160 lb. Find its rectangular representation.
To move the oil drum, the resultant of the three forces shown must have a magnitude of 500 N. Determine the magnitude and direction of the smallest force F that would cause the drum to move.
Show that all diagonal members of the truss carry the same force, and find the magnitude of this force.
A force F1 of magnitude 105.6 lb is directed toward the right. Find a second force F2 that will produce a resultant force of 201.9 lb to the left.
Two horses on opposite banks of a canal pull a barge moving parallel to the banks by means of two horizontal ropes. The tensions in these ropes are 200 lb and 240 lb while the angle between them is 60°. Find the resultant pull on the barge.
Two horses on the opposite banks of a canal pull a barge moving parallel to the banks by means of two horizontal ropes. The tension in these ropes are 200 lb and 240 lb while the angle between them is 60 deg. Find the resultant pull on the barge and the angle between each ropes and the sides of the canal.
5. Two cables A and B are attached to a hook. Cable A exerts a pull with a magnitude and direction defined by the vector A = 6i + 4k (kN). Cable B is also attached to the same hook where cable A is attached, cable B exerts a pull with a magnitude and direction defined by the equation B = -41 +7k (kN). What is the magnitude of the component of the resultant force of from both cables along z-direction? Express your answer in unit of kN.
What is the component of the force P along line AC?
QUESTION 3 In the plane forces system, F, = 6 kN, F2 = 4 kN and F3 = 5 kN. The direction of the force F3 is tan a = 4/3, the moment arm of the force couple is d, = 2 m and the action points of the forces are A2(-2,5), A3(-4, -4). Find the resultant force R as a vector (kN) and calculate the line of action. SOLUTION A: F Fi F As
The moment of the given forces about point "A" is 4.5 KN/m 5.0 m 3.0 m A
If the value of the resultant forces is F and the angle θ is vertically upward, find the value of the forces N