3. For an air standard ideal dual cycle, air at 14 psia and 530R is compressed isentropically with a ratio of 16. During the heat addition process, it was found that the cut off ratio is 2, and the pressure ratio is 1.3. Draw the PV and TS diagrams, find the heat added, net work, and efficiency. 583.84 ; 363.03 ; 62.18% Btu Btu lbm lbm

3. For an air standard ideal dual cycle, air at 14 psia and 530R is compressed isentropically with a ratio of 16. During the heat addition process, it was found that the cut off ratio is 2, and the pressure ratio is 1.3. Draw the PV and TS diagrams, find the heat added, net work, and efficiency. 583.84 ; 363.03 ; 62.18% Btu Btu lbm lbm

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

Solve the Problem. Submit your solution with the problem with the submission area. Consider an ideal air-standard diesel cycle in which the state before the compression process is 95 kPa, 290 K, and the compression ratio is 20. Find the maximum temperature (by iteration) in the cycle to have a thermal efficiency of 60%?
PLEASE DO THIS TYPEWRITTEN AND COMPLETE IT, I WILL UPVOTE. IF NOT COMPLETE AND TYPEWRITTEN, NO UPVOTE. THANK YOU
An idealcold air-standard Brayton cycle produces some quantity of power. Air with a mass flow rate of 6 kg/s enters the compressor at 100 kPa, 300 K.It is also known that the compressor has a pressure ratio of 10 and the turbine inlet temperature is 1400 K.If k = 1.4for the working fluid, determine the thermal efficiency, the ratio of back work, and the net power for the cycle in kW.
In a Diesel cycle, the volume at the end of the isentropic compression is 0.07 L. If the displaced volume of the cycle is 0.78 L, the cutoff ratio is 1.52, the specific heat ratio is y=1.37 and the heat rejected is 430 kJ/kg, the work done in kj per kg of air is: Select one: a. 705.2 Ob.521.4 Oc. 124.5 d. 566.0
In a regenerative gas turbine cycle, the pressure ratio, maximum temp and min temp is 4.5, 900 K and 290 K, the cycle efficiency will be equal to
A rankine cycle operates between a pressure limit of 6 MPa. and 50 kPa., the steam leaves the boiler at 450 C, the isentropic efficiency of the turbine is 94%, the steam mass flow rate is 20kg/sec. draw the T-S diagram assuming point 1 is at the pumpe entrance. and determine the required power to operate the pump, cycle thermal efficiency. Ans. (122 kW, 30.25%)
.) An Engine operating using the ideal Otto Cycle receives air at 15 psia and 75 F, then compresses it to 1.76. The total heat added during heat addition process is 352 Draw the PV and TS diagrams. Solve Btu lb for: the remaining temperatures, QR, Wnet, efficiency and how many lb of air is required if the engine is rated 500hp?
kg An ideal dual combustion cycle where air has initial conditions air at 110 kPa and 20C, is compressed to 0.051m. During the heat addition process, it was found that the pressure ratio is 1.5, and the cut off ratio is 2.5. Draw the PV and TS diagrams, solve for QA, QR, Wnet, efficiency, and Pmep
Rankine cycle – Consider the ideal cycle shown below and determine the thermal efficiency of the cycle using the steam tables. T 500 °C 3 Wturb,out 9in 6 MPа 10 kPa Jout pump,in