3. Consider a cylinder with an outer Diameter, D = 4 m that is under a pressure p = 200 kPa and twisted with a Torque T = 1350 kNm as shown below. у. A Diameter, D = 4 m Thickness, t = 0.14 m T 1350 kNm Internal pressure p = 200 kPa a. Find the stresses on element A oriented as shown and sketch the element. Clearly label the coordinate axes and show the magnitude and direction of the stresses. b. Find the principal stresses using Mohr's circle

Q: A closed ended, thick-walled cylinder, manufactured from silicon material is designed to contain…

A: Given data, Outer radius of the cylinder, ro = 0.3 m Inner radius of the cylinder, ri = 0.1 m…

Q: shaft attached to 1900 N flywheel at distance of 400 mm from A and the shaft is rotated by a pulley…

A:

Q: 3. As in the figure, a ship can move both with the wind and with a diesel engine. your ship The mast…

A:

Q: 2. Consider the Flamant solution - a line load on the edge of a half space. The valid stress…

A: according to a given question

Q: Consider the plane stress element shown in representing the state of stress at a material point. If…

A:

Q: An element in plane stress from the fuselage of an airplane is subjected to compressive stresses of…

A: Given:ζxy=11 MPaσx=-22 MPaσy=6 MPa

Q: 2. A hollow generator shaft of 180-mm outer diameter and 120-mm inner diameter carries a torque T 40…

A:

Q: The thin-walled pipe has an inner diameter of 2 in. and a thickness of 0.1 in. It is subjected to an…

A:

Q: B = 30° A 50 mm

A: The moment of inertia about the y-axis and z-axis are determined as follows.

Q: = A machine component is fabricated from a bent tube as shown below. One part of the tube lies along…

A: Outside diameter, d0=122 mmInside diameter, di=108 mmForce F=8.5 kNLengths,L1=258 mmL2=118 mmL3=281…

Q: Consider a point in a structural member that is subjected to plane stress. Normal and shear stress…

A:

Q: 1. A loaded bicycle pedal crank is shown below. 18. 750 N (-7 direction) d A @ Top -y₁ B@ Top d = 15…

A:

Q: Lical planes at the polnt are Sx (a) Determine the principal stresses (o,l > Op2) and the maximum…

A:

Q: Figure Q5 shows a thick cylinder of 50 mm internal radius and 130 mm outer radius is subjected to an…

A: 2   Given: The internal radius, ri = 50 mm The outer radius, ro = 130 mm The internal pressure, Pi =…