3. Calculate the Current Passing through the 4 Ω resistor using Norton OR Thevenin's Theorem. 5Ω 4Ω 2Ω 4A 8 Ω i AC RMS 10 V

Q: A 120-V rms 60- Hz source supplies two loads connected in parallel, as shown in the figure. a) Find…

A: We are given,a) calculate power factor of parallel combinationb) calculate capacitance connected in…

Q: 4. For the circuit shown in Figure (4.a): i) a) Find the voltage across the capacitor in polar form.…

A: In this solution we discuss about current division rule, equivalent impedance calculation &…

Q: A resistor and a capacitor are connected in series across a 150V AC supply. When the frequency is…

A: It is given that: V=150 VAt frequency of 40 Hz: I1=5 AAt frequency of 50 Hz: I2=6 A

Q: An inductor is "charged" to some value, then connected in series with a 1002 resistor and allowed to…

A: Step 1:

Q: I have a series circuit with a source of 50V, resistor 400 ohms, capacitor Xc=120 ohms, and a 60 Hz.…

A: If f is the frequency of the input AC signal, then the reactance of the capacitor of capacitance C…

Q: 2) a)For the following circuit find the total capacitance and inductance and hence find the total…

A: The given circuit diagram is shown below,

Q: Problem - 8 Refer to the circuit below and 25V C2 5 uF compute the following: C1 5 pF i) Total…

A: The overall value of capacitance can be found as:-  1. Find the combination of C2 and C3 capacitor…

Q: A 6-H inductor is connected to a 12-VDC source. What is the value of its inductive reactance? I was…

A: Given, A 6 H inductor (L) is connected to a 12 V DC source.

Q: 1. You are an electrician working in an industrial plant. You discover the problem with a certain…

A: Given that: In an industrial plant, a machine has a defective capacitor and its rating is 10 μF and…

Q: What are the steps in solving a circuit having a resistance, a source, and an inductance (or…

A: Concept: A capacity to do work is called energy and it may exist in potential, kinetic, thermal,…

Q: 3. A 2/30⁰-MV voltage source is in series with the parallel arrangement of an inductor and a…

A: In the questions, we need to change the circuit into its equivalent current source.

Q: None

A:

Q: 9. A noninductive load with a resistance of 30 Q2 is connected in series with a capacitor. The…

A:

Q: Four capacitors are arranged in the circuit shown in the igure. The capacitors have the values C₁ =…

A:

Q: Consider the circuit shown in the figure below. The four capacitors have capacitances C₁ = 5.8µF .C₂…

A:

Thevenin Theorem

Any linear circuit, no matter how complex, maybe simplified to an equivalent circuit utilizing only a single voltage source and series resistance coupled to a load, according to Thevenin's Theorem. The superposition principle says that all foundational equations must be linear, and the notion of "linear" is still the same (i.e., there should not be any exponentials or roots). This is particularly the case when operating with passive elements like resistors, inductors, and capacitors. However, some components (particularly some gaseous and semiconductor devices like tunnel diode, Schottky diode, transistors like BJT, MOSFET) are nonlinear, meaning their current resistance fluctuates with voltage and current. As a result, circuits made up of these parts are known as nonlinear circuits.