3. An industrial load consists of the following: A 200 hp motor loaded to 100-hp: efficiency 0.82, pf 0.6 lagging A 350 hp motor drawing 80 kW: pf 0.8 lagging = A 500 hp motor drawing 47 kW: pf 0.7 leading A 70 kW lighting load Determine for the overall load: a. Real Power (kW) b. Reactive Power (kvar) c. Apparent Power (kVA) d. Power Factor

Q: What is a receptacle?  What is meant by “service drop”? What are sets of service-entrance…

A: As per the guidelines given, we can only provide the solution of one question in multiple type of…

Q: What are the steps for plotting points on microstation uisng offset, station, side and elevation?

A: We need to tell about steps for plotting points on microstation uisng offset, station, side and…

Q: After reduction, the current - caring capacity of a condenser is referred to as the___. A. ambience…

A: Given: After reduction, the current carrying capacity of a conductor is referred to as the ___.

Q: Two shunt generators operate in parallel to supply a total load current of 3,000 A. Each machine has…

A: In this question we need to find the load voltage and the armature current of each machine.

Q: In the experiment a half wave 3-phase rectifier is required to fed a 402 (resistive) load from a…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Briefly explain the working of following power plants a) Thermal Power plant b) Hydel power plant

A: thermal power Plant coverts heat energy to electric power / Energy. The basic principle of these…

Q: 9.a. What should be done with the connector ferrule once a connector is attached to a fiber optic…

A:

Q: Q1) A) What is bus? How many ways to construct bus system. (explain with example for one type)

A:

Q: Choose which answers are correct ‎‏What is the unit of slope of a Fuel cost curve ? a . $ / MWh b .…

A:

Q: Fill in the blanks: Q. Expansion of LSB is

A: A combinational circuit is one in which the various gates in the circuit, such as the encoder,…

Q: Can we replace the Fossil Fuels? How?

A: Can we replace the Fossil Fuels? How?

Q: Based on the computed TEC (Thevenins Equivalent Circuit), What is the voltage across the load R3, in…

A: In this question,  We need to determine the voltage across the resistance R3  in Volt.  We are…

Q: Determine the size and type of wire to he installed to a building with temperature that reaches…

A: Here ratings of loads are given for a single phase 230 V source. We need to determine the size and…

Q: What can you say/perspective about National Electrical Code?

A: The National Electrical Code (NEC) was created to protect people and property from the risks posed…

Q: What is receptacle load ? Explain under 100 words...

A: The amount of load produced by a device inserted into a receptacle is referred to as a receptacle…

Q: In a 10-trunk circuit, there are 180 calls in one hour. The average holding time per call is 2…

A: This is a problem of mobile communication. The detailed solution is given in the next step.

Q: In a semiconductor it is observed that 80% of the current is carried by holes and 20% by electrons.…

A:

Q: The ________parameters may not reflect the actual operating conditions but simply provide an…

A: For the AC analysis of BJT or MOSFET based circuits, It is important to convert it into different…

Q: Find the difference. 11010011two − 1011101two _____two

A: We will first convert the given binary numbers into decimal. The subtraction of these decimal…

Q: us bars are either flat......... or...........

A: According to question:

Q: 4) Calculate the value of the resistance Rled in Circuit #1, to ensure that a GREEN LED will have a…

A:

Q: d) None of these. 5. Materials which easily allow the passage of electric current are known as: a)…

A: Answer 2- The power is defined as a rate of doing work.  So, option (c) is correct.   Answer 4- An…

Q: where did the 100 come from? Thank you.

A: In the given solution Xc<<1.5k Where Xc is  reactance of the coupling capacitor .

Q: What is meant by Electric Bid Package?

A: Bid package means the collection of the pertinent portion of the construction documents into a…

Q: 8. A larger time delay has been provided with over-voltage protection compared to the under-voltage…

A: Time delays are used to control the flow of power in different parts of the system and by…

Q: if you have (10) 10 OHM resistors and (5) OMR resistors in a series circuit what would the total…

A: Resistances are given as,

Q: Describe what a maintenance work order in electrical engineering should contain.

A: Electrical maintenance is one of the most important thing which keeps the system healthy,durable and…

Q: The choice of wiring system design is basically affected by temperature, safety and cost factors,…

A: Before assembling a structure, one needs to make the right choice when it comes to the type of…

Q: In standard architectural site plan symbols, a fire hydrant is indicated by a/an _. A. Dark -field…

A: In this question we need to choose a correct option.

Q: How Rth connected with the load resistance, explain

A: RL will be  connected in series with  RTH  as shown in the example.

Q: 10. What is role or function of circuit breaker? What is its graphic symbol in electrical…

A:

Q: What is the meaning of "system redundancy" in aircraft electrical systems? Explain why system…

A: We have given the following problem What is the meaning of "system redundancy" in aircraft…

Q: b) With sketch of diagram, show the number of resistor and switched would be required to implement…

A:

Q: Q3: What is a synchronous circuit?

A: I hope you asking synchronous circuit in terms of digital circuits, you have not stated it so I am…

Q: 6-streets traffic light controller

A: