Answered: 3. A small circular hole 6.00 mm in… | bartleby

Related questions

Question

A. Find the speed of the water coming out from the hole.

B. And the discharged per second

3. A small circular hole 6.00 mm in diameter is cut in the side of a large water
tank, 14.0 m below the water level in the tank. The top of the tank is open to
the air. Find (a) the speed of the water coming out from the hole, and the
volume discharged per second.

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

The input piston on a hydraulic lift has area A =1.5×10-4m2 and the lift plunger has area A. =4.5× 10-2m2. The car and plunger have a combined mass of 1900 kg. Pushing down the input piston lifts the car on the output plunger. A1 a. Find the hydraulic pressure needed to raise the car at constant speed. b. Find the force needed on the input piston. c. The input piston is pushed down 0.5 m. What is the work done on the car by the lift plunger? d. Explain how the lift can raise a car with such a small force.
m 1. A river is 12.2 m wide with an average depth of 5.1 m. The river is flowing at a speed of 1.7 At one point in the river, there is a section of rapids. Here, the speed of the water increases to a. -3.6 . What is the effective area of the river at this point? b. Later, the river dumps into a lake where the area rapidly increases to 202 m2. How fast is the water moving just after it enters the lake?
24.The area of contact between an injection needle and the skin is a very tiny circle with a diameter of 2.54x10cm. If the needle exerts a force of 6.9x10 2N, what is the pressure in Pa? Answer:
Water flows through a pip. At Point 1, the pipe has a radius of r and the water travels at speed v. At point 2, the water travels at speed 4v. What is the radius at Point 2? A. 2r B. 4r C. 8r D. r/2 E. r/4
Water flows through a 15.0 cm fire hose at a rate of 5.00 m/s.A. Find the rate of flow through the hose in L/min.B. How many liters pass through the hose in 30.0 min?
Suppose that it takes 15.3 hours to drain a container of 72.7 m3 of water. What is the "mass flow rate," of water from the container?
A 12 kg package rests on one of its sides on a horizontal surface. The area of the side is 0.09-m2. The total pressure exerted by the package on the table is about: Group of answer choices a. 1.31 kPa b. 13.07 Pa c. 10.6 Pa d. The answer is not listed among the given choices. e. 133.3 Pa
The density of two liquids (A and B) is given as 1000 kg/m3 and 600 kg/m3, respectively. The two liquids are mixed in a certain proportion and the density of the resulting mixture is 900 kg/m3. How much of liquid B (in grams) does 1 kg of the mixture contain? Assume the volume of the two liquids is additive when mixed. a. 666.7 g b. 168.8 g c. 400 g d. 278 g
I Review I Constants I Periodic Ta Water flowing through a 2.5-cm-diameter pipe can fill a 200 L bathtub in 3.3 min . ▼ Part A What is the speed of the water in the pipe? Express your answer in meters per second. ? V = m/s Submit Request Answer
If the linear mass density of a cord is0.042 kg/m, then what is the mass of245 mof the cord?8.A.9.855 kgD.9.433 kgB.9.914 kgE.10.07 kgC.10.29 kgF.10.80 k
1. If a closed cylinder has an applied force of 7600N, and the pressure is 40kPa, what is the area.? 2. Find the force, in Newtons, for a glass box with a gas that has a pressure of 125N/m2 and an area of 22.4 m2.
A large open tank contains water as shown in the figure. The level of the water in the tank is 8 m from the ground while the circular opening in the side of the tank is 1.5 m above the ground. If the discharge rate at the opening is 75 li/sec, determine the diameter of the opening. 1

SEE MORE QUESTIONS