3. A magnetic field is perpendicular to the plane of a single-turn circular coil. The magnitude of the field is changing, so that an emf of 0.47 V and a current of 3.5 A are induced in the coil. The wire is then re-formed into a single-turn square coil, which is used in the same magnetic field (again perpendicular to the plane of the coil and with a magnitude changing at the same rate). What (a) emf and (b) current are induced in the square coil?

3. A magnetic field is perpendicular to the plane of a single-turn circular coil. The magnitude of the field is changing, so that an emf of 0.47 V and a current of 3.5 A are induced in the coil. The wire is then re-formed into a single-turn square coil, which is used in the same magnetic field (again perpendicular to the plane of the coil and with a magnitude changing at the same rate). What (a) emf and (b) current are induced in the square coil?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

20. The figure shows a rod that is forced to move at constant speed v = 2.0 m/s along the horizontal rails, which are separated by distance L = 10 cm. The rod, rails, and connecting resistor at the left form a conducting loop. The entire apparatus is placed in a uniform 0.80 T magnetic field pointing into the page. If the induced current through the loop is 10 mA, what is the force applied to the rod? Assume no mechanical resistance and all energy supplied by the force turns into heat in the loop. (1) 220 μ. (2) 4 mN (3) 48 mN YA y (4) 12 mN X X X X X X X X XIX X XIX X X XÃ X X X X X X X X X X X X X X X X XV L X X X X X X X X X X (5) 0.8 m
5. A rectangular loop of wire (length L=13.0 cm and width W=7.80 cm) is moving as shown in the drawing with a speed of 1.00 m/s. The loop is leaving a region in which a 2.80 T magnetic field exists; the magnetic field outside this region is zero. During a time of 0.13 s, what is the magnitude of the change in the magnetic flux? Wb XXXX XXX XXXXXXXXX xxxxxxxxx xxxxxxxxx XXXXXXXXX XX
6. The conducting rod shown in the accompanying figure moves along parallel metal rails that are 25-cm apart. The system is in a uniform magnetic field of strength 0.75 T, which is directed into the page. The resistances of the rod and the rails are negligible. a. What is the emf (including its sense) induced in the rod when it is moving to the right with a speed of 5.0 m/s? b. What force is required to keep the rod moving at this speed? c. What is the rate at which work is done by this force? d. What is the power dissipated in the resistor? B x M x x t x 25 cm 5.0 m/s 0.25 N * N
3. A loop of wire sits in a uniform magnetic field, everywhere pointing toward you. Due to a changing magnetic flux through the loop, an induced current flows in the wire, clockwise as shown. The area of the loop is 0.590 m^2 , and the magnetic field initially has magnitude 0.950 T. Suppose that, over a time period of 1.55 s, the magnetic field changes from its initial value, producing an average induced voltage of 0.217 V. What is the final value of the magnetic field after this time period? 0.608 T 0.912 T 1.824 T 1.520 T
A 100-turn square coil of side 20.0 cm rotates about a vertical axis at 1.6 x10 rev/min as indicated in the figure. The horizontal component of the Earth's magnetic field at the coil's location is equal to 2.00 x 10T. Calculate the maximum emf induced ( in units of mV) in the coil by this field. 20.0 cm 20.0 cm
1.A 33-turn circular coil of wire has diameter 0.97 m. It is placed with its axis along the direction of the Earth's magnetic field of 53.0 µT and then in 0.200 s is flipped 180°. An average emf of what magnitude is generated in the coil?
A 130 turn , 2.10 cm diameter coil is at rest in a horizontal plane. A uniform magnetic field 60° away from vertical increases linearly from 0.620 T to 1.66 Tin 0.650 s. Figure 1 of 2 > Vertical 60° Coils
2. A flat, circular coil has radius 10.0 cm and 200 turns. It is immersed in a uniform magnetic field that makes an angle of 60.0 degrees with the plane of the coil as shown below. The magnetic field is increasing with time at a rate of 12.0 T/s. What is the magnitude of the emf induced in the coil (in V)? (A) 65.3 (B) 100 (C) 133 (D) 76.8 (E) 49.8 (F) 30.0 unour em to the
Answer Q9. Hence Justify your answer, explaining detailly each step
4. Consider a square-shaped conducting coil with 75 turns of wire. Each turn of the wire has a length of the side equal to 12 cm. A uniform magnetic field is directed perpendicular to the plane of the coil. If the magnetic field changes linearly from 0 to 0.35-T in 0.40 s, what is the magnitude of the induced EMF inside the coil while the magnetic field is changing?
2. A flat, circular coil has radius 10.0 cm and 200 turns. It is immersed in a uniform magnetic field that makes an angle of 60.0 degrees with the plane of the coil as shown below. The magnetic field is increasing with time at a rate of 12.0 T/s. What is the magnitude of the emf induced in the coil (in V)? (A) 65.3 (B) 100 (C) 133 (D) 76.8 (E) 49.8 (F) 30.0 Fee
1. A flat circular coil with 95 turns, a radius of 4.20 × 10−² m, and a resistance of 0.430 is exposed to an external magnetic field that is directed perpendicular to the plane of the coil. The magnitude of the external magnetic field is changing at a rate of AB/At = 0.787 T/s. Find the induced current in the coil. A